1. Use the method of sections to determine the magnitude of the internal forces (lbs) in members JK, CI, and HI for this truss-framed fuselage held in place on the ground by pin and roller supports. State whether these members are in tension or compression. Round off your answers to the nearest hundredths. 500 lb A 20 in. B K 20 in. C 20 in. D 20 in. E H 20 in. 400 lb F 45° 10 in. G10 in.

Q: 1. Determine the force in bars BD, CD, and DE of the nacelle truss shown below. Indicate whether…

A:

Q: For this Problem, kindly refer to our Textbook, Structural Analysis Fourth Edition By Aslam…

A: The Truss with the given loading is shown below, To find the force in the bottom chord nearest to…

Q: Problem 7.1 - Determine the force in each member of the truss by t method of joints and state…

A: To find force in all members of the truss

Q: the Howe bridge truss shown, d = 11 ft, 2950 lb, F2 = 1950 lb, F3 = 2550 lb, and F43650 lb. (Figure…

A: A simple truss is given with roller support at E and hinged support at A   To determine force in…

Q: The truss problem for this semester is the problem below. Find the maximum compression and the…

A:

Q: 1. Calculate the forces in all members of the truss shown using the method of joints.

A:

Q: Using the method of joints, determine the force in each member of the truss shown. State whether…

A: There are 3 methods: Method of joints Method of section  Graphical method

Q: using method of joints, please help me calculate all the force of all the members. thanks!

A:

Q: P = L1 = L2= L1 Your Answer: P 195 2.50 4.5 Answer KN m m L2 ▷ View hint for Question 1 P The…

A:

Q: There are two questions to answer. The first question is a truss problem and the second is a frame…

A: SOLUTION: Method of SectionsAt section a-a (left side) *To determine the force BD through method…

Q: Using the approximate method for beam capacity, determine how many # 10 bars are required for the…

A:

Q: B Steel E = 29 x 10 psi 7 = 490 lb* in. 4ft D Aluminura E = 10.1 x 10 psi 7 = 170 ³ Determine (a)…

A: For steel strut: E=29×106  psiγ=490 lb/ft3L=4 ft 12 in1 ft=4×12 ind=12 in=0.5 in For aluminium…

Q: For the steel truss and loading shown, determine the magnitude of the deformation (in inches) of…

A:

Q: PLEASE SOLVE THIS PROBLEM WITH A COMPLETE SOLUTION. THANK YOUU

A:

Q: 5. Method of Sections: Using the method of sections (no other method is acceptable), determine the…

A:

Q: Using

A:

Q: Problem 3. Using the method of joints, determine the force in all truss bars. Indicate tension or…

A:

Braced cuts

The braced cut is a method of providing lateral support to the soil in foundation trenches, to prevent the trenches from deformation by the caving in of soil and resisting it from moving laterally. During shallow excavation in firm soil, generally, slopes are provided to resist the caving in of soil. During shallow excavation in soft soil and deep excavation, the chances of caving in of soil increase. Hence, it becomes necessary to make a provision to resist the deformation of trenches due to caving in of soil. The braced cut is the method used for such conditions. The excavation using braced cuts is a bit uneconomical as compared to the traditional open-cut excavation method but provides better safety than the cut excavation method.