1. The original datagram diagrammed below enters a network with an MTU of 1805 bytes. IP ID DF Flag MF Flag Offset Data Size in bytes 6202 4231 bytes a) What is the largest data size possible on the 1805-byte MTU network in bytes? b) How many fragments are required to transmit the original datagram on the 1805-byte MTU network?

Q: Q. Take two hosts, A and B, linked by a single R bps connection. Assume that both hosts are…

A: dprop=m/s seconds.

Q: a digital communication system with the following specifications: Pbe=0.05, (n,k) block coding with…

A: It is defined as a element of a standardized code or protocol. Each code word is assembled in…

Q: 1) Consider a Transport layer segment with size of 8000 bytes includes an IP header of 20 bytes no…

A: Given Data : ID = 555 MTU = 1500 Total Data = 8000

Q: We have the 3 links mentioned in the table with their corresponding MTU. Link Maximum Transmission…

A: Introduction: Given three links A, B and C and there MTU are 200, 400 and 1500 respectively, using…

Q: A certain link layer interfaces uses CRC to detect errors. Answer the following questions. a. For…

A: G(x0) = x^4 + x^2+ 1 8-bit data frame is = "10011101"

Q: 8. An Ethernet MAC sublayer receives 1515 bytes of data from the upper layer. The data needs to be…

A: Answer : --   option A) 1500 bytes; 15 bytes

Q: We are sending a 50 Mbit file from a source host to a destination host. All links in the path…

A: Given that, length of the file= 50 M bits Bandwidth= 10 Mbps Propagation speed= 2 * 10^8 meters/sec…

Q: Given, you are to transfer a total datagram of size 28939 Bytes over a network that has an MTU of…

A: you are to transfer a total datagram of size 28939 Bytes over a network that has an MTU of 3038…

Q: Which of the following are data-link layer issues? a) routing b) flow control c) synchronization d)…

A: Given question are multiple choice selected question so we provide detailed explanation below.

Q: provides grouping of the information for transmissi In a bus topology, all LAN data traffic is…

A: Note As per bartleby guidelines we have to solve only one question please post the remaining…

Q: w how it finds the network and the subnetwork address to route the packet. A otwork required in four

A: The answer is

Q: 1. In a data link layer-level communication, sender wants to send following data in bits…

A: 1) answers:-In a data link layer-level communication, if the sender wants to send the data…

Q: 16. Calculate the total transfer time of a 1000byte packet sent between a client and a server…

A: 1 Byte = 8 bits 1 Mbps = 106 bps   Packet Size = PS = 1000 bytes BandWIdth = BW = 1 Mbps…

Q: 1. A router receives a packet with destination address (please refer to the table attached to find…

A: The following is the solution

Q: datagram

A: Given :- A Datagram with size 2400 bytes and the maximum transfer unit is 700 Bytes with an…

Q: Assume we have

A:

Q: mbers all data bytes that are transmitted to the receiving systems. Uses no flow control mechanism…

A: Dear Student, UDP does not number all data bytes, instead only port numbers are stored along with…

Q: What is the purpose of NAT(Network Address Translation)/PAT(Port Address Translation) mechanism? a.…

A: NAT is used for LANs.  It is used to translate their individual IP address to a single IP address so…

Q: a) Two connecting nodes are transmitting frames using 18-bit sequence numbers. Calculate the maximum…

A: In given question, we are going to find out the Maximum sender window size and receiver window size…

Q: What is the maximum transfer unit MTU? Which field is it related to in the header of the IP…

A: In a computer network, the maximum transfer unit (MTU) is the size of the largest protocol data unit…

Q: In asynchronous transmission, why does the gap time between bytes differ?

A: Introduction:   Because Transmission is asynchronous, the time interval between bytes is "variable."

Q: Assume we need to design a Go-Back-N sliding-window protocol for a network in which the bandwidth is…

A: Here is the Average RDT = 20ms Bandwidth delay product = 5 Mbps x 20ms =100000 bits Number of…

Q: 5. Given the host address 203.83.74.242 and the broadcast address 203.83.95.255, find the Network…

A: Below I have provided a solution for the given question.

Q: ​Assume a static dual-issue MIPS architecture. Assign instructions to packets in the most effective…

A: SOLUTION- If we want to determine the IPC (instructions per cycle) of the loop body, we need to…

Q: A. Consider the following packet-switched network with two hosts (A and B) connected by three…

A:

Q: ppose the information content of a packet is the bit pattern as shown below, and an even parity…

A: Step 1: The value of the field containing the parity bits be for the case of a two-dimensional…

Q: take

A: The correct answer is 3.643

Q: The physical layer is in charge of coordinating the functions required to send a bit stream via a…

A: Introduction: The physical layer is in charge of moving individual bits from one hop (node) to the…

Q: 1. A router receives a packet with destination address (please refer to the table attached to find…

A: IPv4 address are consist of 32 bits. A unique identifier for computers connecting to a network is an…

Q: otal length of IP datagram = 3620, (including 20 bytes of header). Apply IP fragmentation for…

A: MTU stands for Maximum Transmission Unit. The total length of IP datagram = 3620, (3600+20 bytes of…

Q: 6- Which of the following is the multiple access protocol for channel access control? a) CSMA/CD b)…

A: NOTE  :-  As per our company guidelines we are supposed to answer only first 3 sub-parts. Kindly…

Q: Assume we need to design a Go-Back-N sliding-window protocol for a network in which the bandwidth is…

A: The sliding window protocol is an Error control protocol.Go back N is one of the…

Q: In asynchronous transmission, why does the gap time between bytes differ?

A: Given: What causes the gap time between bytes in asynchronous transmission to vary?