1. The beam is loaded as shown below: a. Draw the influence lines for the reaction at A, moment reaction at A, shear and moment at B. Place all important ordinates and dimensions in the sketch. b. Assuming that the span can be loaded with a moving unform load of 8.5 kN/m and moving concentrated load of 56 kN, find the maximum shear at D and maximum bending moment at D due to these loads. 3m D 2m •) B 2m E 2m

1. The beam is loaded as shown below: a. Draw the influence lines for the reaction at A, moment reaction at A, shear and moment at B. Place all important ordinates and dimensions in the sketch. b. Assuming that the span can be loaded with a moving unform load of 8.5 kN/m and moving concentrated load of 56 kN, find the maximum shear at D and maximum bending moment at D due to these loads. 3m D 2m •) B 2m E 2m

Structural Analysis

6th Edition

ISBN:9781337630931

Author:KASSIMALI, Aslam.

Publisher:KASSIMALI, Aslam.

Chapter2: Loads On Structures

Section: Chapter Questions

Problem 1P

See similar textbooks

Similar questions

A rectangular lot was measured using a 50m steel tape which was later found to be 15mm too short. The recorded dimensions were 122.5m long by 94.5m wide. What is the error in the area? Rules: 1. For significant figures and rounding off numbers, provide only the numerical value for the answer. 2. For all the computed values with decimals, use four (4) digits after the decimal.
Fluid mechanics
With FBD and Solution pls refer to the second picture if the answer is in the choices one of those 4 answers is correct
Structural engineering
Can you answer this in 30 mins, ASAP Show your complete solution.Input correct unit. Enclose all final answers. Determine the centroid and the moment of inertia with respect to the x and y axis from the given T-beam. Width of the upper flange is 300mm and its height is 75mm, while the web's length is 250mm with a base of 50mm.
What is the deflection at 2.5 m to the right if B in mm? Indicate the negative sign if the answer is negative. Any GEOMETRIC METHOD Use E=200 GPa, I=300x10^6 mm^4
I need the answer as soon as possible
i need the answer quickly
6. List the given, required and box the final answer. Please include the formula that has been used.
Q1: Answer the following questions. Support your answers with an example 1. what are methods used for representing points in AutoCAD? 2. What are the differences between line and pline ? Discuss ?