YEUFAaA Tnd Natural ResourcesMECH 271 - Introduction to Fluid MechanicsAssignment 1- Pressure1. The basic barometer ean be used to measure the height of a building If the barometrikreadings at the top and at the bottom of a building are 730 mmHg and 755 mmllsrespectively, determine the height of the building Assume an average ar density of1.18 kg/m,2. Agas is contained in a vertical, trictionless piston cylinder devie The piston hasamass of 4 kg and a cross octonal area l35 cm A cumpressed spring above theoressure is SAP..

Name: YEUFAaA Tnd Natural ResourcesMECH 271 - Introduction to Fluid Mechani
Uploaded: 2024-03-20T06:56:55.000Z
Channel: Bartleby
Description: YEUFAaA Tnd Natural ResourcesMECH 271 - Introduction to Fluid MechanicsAssignment 1- Pressure1. The basic barometer ean be used to measure the height of a building If the barometrikreadings at the top and at the bottom of a building are 730 mmHg and

Given data: Barometer reading at bottom (H) = 755 mm of Hg Barometer reading at top (h) = 730 mm of…

Engineering

Mechanical Engineering

1. The basic barometer can be used to measure the height of a building If the barometric readings at the top and at the bottom of a building are 730 mmHg and 755 mmllg. respectively, determine the height of the huilding Assume an average air density of 1.18 kg/m.

1. The basic barometer can be used to measure the height of a building If the barometric readings at the top and at the bottom of a building are 730 mmHg and 755 mmllg. respectively, determine the height of the huilding Assume an average air density of 1.18 kg/m.

Elements Of Electromagnetics

7th Edition

ISBN:9780190698614

Author:Sadiku, Matthew N. O.

Publisher:Sadiku, Matthew N. O.

ChapterMA: Math Assessment

Section: Chapter Questions

Problem 1.1MA

See similar textbooks

Similar questions

A manometer containing two oils is used to assess the pressure of air in a storage tank. Given the configuration of the oils in the picture, calculate the pressure in the tank. The density of air is negligible to the density of the oils (?oil1 = 1000 ??/m3; ?oil2 = 400 ??/m3 ). The height of oil 1 is 1 ?, and the height of oil 2 is 0.8 ?. The atmospheric pressure is 98 ???. The manometer is ipen to the atmosphere.
A car tyre has a gauge pressure of 1.9 bar. Determine it's absolute pressure in mmHg, assuming the atmospheric pressure is 1.013 bar.
Urgent.
The pressure at 9.85m depth in a fluid is 102,482Pa. Calculate the density of the fluid and present the answer in Pascal with accuracy up to one decimal place. Consider 1 atm = 101325 Pa. Assume the value of gravity to be 9.8 m/s2.
Note: Substitute your corresponding assigned number to the blank The assigned number is 22
A manometer (device that measures gauge pressure) is attached to a pressurized container. One end of the manometer is open to the atmosphere and the local atmospheric pressure is 101 325 Pa. The height of the manometer fluid is 42 cm and the fluid has a specific gravity of 1.6. Calculate the absolute pressure on the inside surface of the container
Determine the absolute pressure at A in kPa. Oil, SG = 0.84. a = 21 cm., b = 39 cm., c = 49 cm.. Use Patm = 101.338 kPa. Round off to two decimal places.
if atp pressure is 101 kpa, and total pressure of a gas is 428 kPa, its gauge pressure is
An airship of 100m3 in size is launched from sea level and it gradually attains height until it reaches the desired altitude. A manometer measuring the gage pressure of the inside filled Helium gas show a reading of 1.2 bar at the altitude of A meters from the ground. Manometer shows reading of 2 bar when it reaches to a height of B meters. Assume; Density of air at point A = 1.00 kg/m3 and at Point B= A = 0.80 kg/m3. You can also assume average density = 0.9 kg/m3 where required. Consider temperature inside the balloon = 10°C and negligible change in temperature during the process. (a) How much payload mass can it carry if the mass of airship itself is 5Kg? Do you expect any change in lifting capacity while moving from point A to point B? (b) Calculate the mass of helium to be expelled out to maintain the constant pressure of 2 bar at point B.
An airship of 100m3 in size is launched from sea level and it gradually attains height until it reaches the desired altitude. A manometer measuring the gage pressure of the inside filled Helium gas show a reading of 1.2 bar at the altitude of A meters from the ground. Manometer shows reading of 2 bar when it reaches to a height of B meters. Assume; Density of air at point A = 1.00 kg/m3 and at Point B= A = 0.80 kg/m3. You can also assume average density = 0.9 kg/m3 where required. Consider temperature inside the balloon = 10°C and negligible change in temperature during the process. (a) Calculate external atmospheric pressure difference between Point A and B (b) Neglecting the effect of altitude on local gravitational acceleration, determine the height attained from A to B.
Determine the pressure in a vessel of oil (specific gravity is 0.85) at a point 15.75 feet below the surface, in (a) pounds per square gage; (b) pounds per square inch gage; (c) pounds per square foot absolute; (d) pounds per square inch absolute. NOTE: Clear handwritten solution
Please solve it fast , Urgent.