1. Refer to Figure 1. Assume all diodes are ideal, v,= V,VZ sin ot where V, = 240 volt, w = 2nf. f=50Hz and t = time in second (s). Given the magnitude of ripple voltage, Vr(p-p) = 6V. a. Describe clearly the function of Block A, Block B and Block C b. Find the peak value of vị, v, and v3 c. Draw and completely label the waveforms of v, v, and v3 d. Calculate the average value of v; e. What is the DC value of v,? 2000 V2 1002 Vz=9V |1000내 10 :1 Block A Block B Block C Figure 1

Q: Explain the given circuit diagram and also explain its functions with suitable examples. Ground 1…

A:

Q: To what extent can we characterize an IC

A: An IC (integrated circuit) is the fundamental building block of all modern electronic devices.

Q: Question: What is the primary function of a diode in an electrical circuit? A) To regulate voltage…

A: Option A is wrong because the Zener diode is used to regulate the voltage, but the normal PN…

Q: Full load copper losses

A:

Q: A certain voltage Tripler has 20 V rms on its input. What is the output voltage? Draw the circuit,…

A:

Power Measurement

According to Blondel's theorem, the total power is measured with one less number of wattmeters than the number of wires present in the system. So, a single-phase and two-wire system will require one wattmeter and a single-phase and the three-wire system will require two wattmeters, and a three-phase and the three-wire system will also require two wattmeters and a three-phase and the four-wire system will require three wattmeter devices. The wattmeter is a device that measures power using one voltage and one current input as shown in the above figure. Multiple current or voltage input pair cables are used by many power analyzers and digital storage oscilloscopes (DSOs) for measuring watts, in effect within a single instrument acting as multiple wattmeters. It is possible to measure three-phase and four-wire power with one correctly specified power analyzer.