1. Phasevoltages= 23120°,ofastar-connectedalternatorareE,E,2312 - 120°, and E.2312120°.What is the phasesequence? Compute the line voltages.

Answered: Image /qna-images/answer/c792099e-adc1-40f7-9a32-8948e68d765b.jpg

Answered: 1. Phase voltages = 23120°, of a…

1. Phase voltages = 23120°, of a star-connected alternator are E, 2312 - 120°, and E. 2312120°. What is the phase sequence? Compute the line voltages.

Power System Analysis and Design (MindTap Course List)

6th Edition

ISBN:9781305632134

Author:J. Duncan Glover, Thomas Overbye, Mulukutla S. Sarma

Publisher:J. Duncan Glover, Thomas Overbye, Mulukutla S. Sarma

Chapter2: Fundamentals

Section: Chapter Questions

Problem 2.7MCQ

See similar textbooks

Related questions

Q: 6-pole, 3-phase, wye-connected, 60 Hz alternator has 12 slots per pole and 4 conductors per slot.…

Q: Q5: A 3-phase, 50 Hz, 8-pole alternator has a star-connected winding with 120 slots and 8 conductors…

A: Given alternator is star connected. In star connected line voltage is 3 Times of phase voltage. As…

Q: The winding data for three different alternators are as follows I. 60 slots, four poles, span 1 to 9…

A: pitch factor=cos(short pitch angle2). slot angle=180slot /pole.

Q: A 3-phase,16 pole alternator has a wye connected full-pitch with 144slots and 10 conductors per slot…

Q: Q3 A 3-phase, Y-connected, 2-pole alternator runs at 3,600 r.p.m. If there are 500 conductors per…

A: The solution is given below

Q: . A 2300 V, With 2500 kVA three phase delta-connected alternator has a resistance of 0.1 ohm/phase…

Q: A transformer, circuit breaker is equipped with 500/5 A CTS connected to a induction type over…

A: Given- A transformer, circuit breaker is equipped with 500/5 A CTs connected to a induction type…

Q: When a generator fails, its power output is lost, and the result is an imbalance between total load…

Q: The p.u. impedance value of an alternator corresponding to base values of 13.2 kV and 30 MVA is 0.2…

Q: If you have 3-phase power and you need to step down (or up) in 3-phase voltage, how many…

A: The objective of the question is to determine the number of single-phase transformers required to…

Q: A single phase 120V AC sourc controls power to a resistve load 202 using integral cycle control. a)…

A: Note: As per our policy, I have attempted the first three subquestions. Given data: The source…

Q: A 3-phase, 16 pole alternator has a star connected winding with 144 slot and 10 conductor per slot.…

A: This question belongs to electrical machine . It is based on the concept synchronous generator .…

Q: The dc armature resistance of delta-connected alternator measured across its two terminal is 0.8…

Q: Alternator A (100 kVA, 3-f, 240 V, 60 Hz, 1800 rpm) is operating in parallel with alternator B (125…

A: In this question We need to determine the pf of load. If Alternator A (100 kVA, 3-f, 240 V, 60 Hz,…

Q: Three single-phase transformers are connected into a three-phase bank. The primary is connected as a…

A: In this question we need to find a phase voltage of primary.

Q: v. With reference to an 50 Hz3 phase alternator explain how P,Q,V and F are controlled.

A: It is asked to explain the control of P (active power),Q (reactive power), V (voltage) and F…

Q: Explain the conditions of parallel connection of alternators and how these conditions are fulfilled.

A: If the value of the power demand is large then, it is not possible to provide the power by using a…

Q: Define the parts and functions of AC Generator - Define the working principle of AC Generator. -…

A: AC Generator A machine that converts mechanical energy to electrical energy is called AC generator.…

Q: onsider a three winding transformer with the following particulars: = 50-40° A. Assume that V₂ is 1=…

A: Solution- THREE WINDING TRANSFORMER Given, Z1=Z2=Z3 = 0.02+j0.08 ohmV2 = 400 VI2 = 60∠-30° AI3…

Q: The winding data for three different alternators are as follows 1. 60 slots, four poles, span 1 to 9…

A: We will find the pitch factor in each case as shown below.

Q: - A3-phase, star-connected alternator is rated at 15000 kVA, 11 k V. The armature resistanc and…

A: The alternator is an electrical device used for the conversion of mechanical to electrical energy. A…

Q: a given field current produces an armature current of 250 A on short-circuit and a generated e.m.f.…

A: Given data, Armature current Ia=250 A Open circuit voltage Voc=1500 V Voltage V=6600 V power factor=…

Q: 3.The voltage generated across one inductor of an alternator is 8.11V. There are 120 slots and 4…

A: The e.m.f induced in one conductor = 8.11 V No. of slots (S) = 120 Synchronous speed (Ns) = 720…

Q: What is the relationship between primary induced emf( E1) and applied voltage (V1) of a Transformer?…

A: The relationship between primary induced emf( E1) and applied voltage (V1)

Q: The winding data for three different alternators are as follows 1. 60 slots, four poles, span 1 to 9…

A: pitch factor can be calculated using the following relation Pitch factor = cos(alpha) / 2

Q: If a 3-phase short circuit occurs at the terminals of an alternator, the current in the armature…

Q: A three phase star connected alternator has a resistance of 0.5 ohms per phase and a synchronous…

Q: Chapman Problem 3-4. A single-phase power system is shown in the figure below. The power source…

Q: The reactance of a generator is given as 0.1 pu based on the generator of 17 KV, 300 MVA. Determine…

A: In this question per unit impedance given on some Mva and kv..We have to find new ou impedance on…

Q: Two three-phase alternators operate in parallel. The rating of one machine is 50 MW and that of the…

A: Must Condition for parallel operation of the generator The voltage phase sequence should be same…

Q: O A. The reactive power is flowing from the generator to the load and from load to the generator at…

Q: 1. A 3-phase, 16-pole alternator has a wye connected armature winding with 144 slots, 10 conductors…

Q: phase,240 V,60 Hz,1800 rpm). The load of alternator A is 60kW at 90% pf lagging and the alternator B…

Q: Generate a conclusion on this following statements: Determine and analyze the voltage regulation…

A: GIVEN: resistive load inductive load capacitive load DETERMINE: the…

Q: A three-phase star-connected alternator delivers at rated load a current 1= 200 A under a voltage of…

A: The given question deals with a three-phase star-connected alternator with a certain load connected…

Concept explainers

Fault Analysis

In an electrical engineering system, a fault is an abnormal electric current flowing through the system, and fault analysis is the study of these faults. For instance, a short-circuit is a fault where the live wire touches the ground or neutral wire. If a circuit is interrupted by a failure of a current-carrying wire then an open circuit fault occurs. The open-circuit faults are also called series faults. One or more phases or ground may be involved in a three-phase fault or may occur only between two phases. Current flows into the earth in case of a ground fault or earth fault. For most situations, the prospective short circuit current of a fault that is predictable can be calculated. To limit the loss of service because of a failure, the protective devices can detect fault conditions and operate circuit breakers and also other devices. All phases equally can be affected in a poly-phase system which is known as symmetric electrical fault. The asymmetric fault becomes more complicated to analyze if only some phases are affected. By using methods such as symmetrical components, the power system analysis of these types of faults is often simplified. The main objective of power system protection is to design, detect, and interrupt power system faults.

Question

1. Phase
voltages
= 23120°,
of
a
star-connected
alternator
are
E,
E,
2312 - 120°, and E.
2312120°.What is the phase
sequence? Compute the line voltages.

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Step 3

VIEW

Step by step

Solved in 3 steps with 3 images

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, electrical-engineering and related others by exploring similar questions and additional content below.

Similar questions

3. A circuit consists of two impedances. Z1 =20230° and Z2 =25260° 2, in parallel, supplied by a source voltage V=1002600 volts. Determine the power triangle for each of the impedances and for the source.
Problem 1 - Series en Parallel AC networks [19] Look at the circuit in Figure 1 and determine the following: (a) Total Admittance. (b) Total Impedance. (c) Total Current (l:). (d) Current (I1) through impedance Z2. (e) Current (12) through impedance Z3. (f) Current (I3) through impedance Z4. (g) Is this an inductive or capacitive circuit? A. B Zs 220V;50HZ Figure 1 (h) Voltage across Z1. (i) Voltage across A and B. G) Voltage across Zs. Z1 = 3 + j5 ohm Z2 = 10 + jo ohm Z3 = 5 + j15 ohm Z4 = 10 – j30 ohm Zs = 20 – j30 ohm Admittance and Impedance in rectangular notation. All currents and voltage in polar notation. Take voltage as reference.
A three-phase balanced load of 15A per phase is supplied by a steel wire armoured cable with a c.s.a. of 2.5mm². The voltage drop for this cable is 15mv/A/m and the circuit is 40m long. Calculate the voltage drop in the cable.
e = 0 Q1: What does happen if we change two currents? a. Q2: What does happen if we have a three-phase four poles machine? Q3: What does happen if we have a two-phase two poles machine? e = 0 Q4: What does happen if we apply a capacitance in phase b and then use same voltage for both phase. Dr. Ali Ki. pw --
X₂=0.1 1 XL +03 Soto X₁ = 0.2 X = 0.1 X = 0.1 Above is the one-line diagram of a simple power system. Each generator is represented by an emf behind the subtransient reactance. All impedances are expressed in per unit on a common base. All resistances and shunt capacitance are neglected. The generators are operating on no load at their rated voltage with their emfs in phase. A symmetrical fault occurs at bus 1 through a fault impedance Z, =j0.08 per unit. a) Using Thevenin's Theorem, determine the impedance to the point of fault and the fault current in per unit. b) Find the bus voltages and line currents during the fault. 2 O oto
GMR calculate
Discuss how delta connection is achieved in three-phase systems?
The instantaneous power absorbed by the load in a single-phase ac circuit, for a general R LC load under sinusoidal-steady-state excitation. is (a) Nonzero constant (b) Zero (c) Containing double-frequency components
In the system shown in Figure 1, the transformers are connected star-star with both star points grounded and the generators are connected in star with thier star points grounded. The system base is 15 MVA. The transformers all have reactances of 0.04 p.u. on this 15 MVA base. The reactances of all other elements are given in Table 1 (in 2) and the voltage levels are given in Table 2. p.u. G1 p.u. T1 jö Per-Unit Convert all values to p.u. on a 15 MVA base. Xa= p.u. Xc₂= XL = V BABE G1 2 X 9 T3 Figure 1: A section of the distribution system T1 L Table 1: Sequence reactances (2) 3 G1 L G2 0.3 0.59 0.01 4 L 9/10 10 Fault Voltage What is the voltage at bus 3 (in Volts) after the fault has occurred? Vp= V T2 5 T2 34 10/4 Table 2: Voltage bases (kV) G2 4 T3 10/9 | G2 Fault Current A three-phase fault with a fault reactance of 0.01 p.u. occurs at bus 3. Calculate the fault current flowing at the fault point in KA. Ip=-j KA So
5.5 kW, 1450 rpm. L-type equivalent circuit and parameters for a continuous sinusoidal phase of a star connected 3-phase ASM with line voltage 220 V and frequency 50 Hz are given as follows, ignoring core (iron) losses: R1=0.21 Ohm, R2=-0.18 Ohm, X1=X2-0.66 Ohm and Xm = 9.9 Ohm How many times the inrush current will be the rated current when the ASM is started directly? Answer options group 8.0815 2.6455 4.3763 7.1534 1.2558 6.3414 5.2280 3.7473
5.5 kW, 1450 rpm. L-type equivalent circuit and parameters for a continuous sinusoidal phase of a star connected 3-phase ASM with line voltage 220 V and frequency 50 Hz are given as follows, ignoring core (iron) losses: R1=0.21 Ohm, R2=-0.18 Ohm, X1=X2-0.66 Ohm and Xm = 9.9 Ohm How many times the inrush current will be the rated current when the ASM is started directly? Answer options group 8.0815 2.6455 4.3763 7.1534 1.2558 6.3414 5.2280 3.7473
The p.u. impedance value of an alternator corresponding to base values of 13.2 kV and 30 MVA is 0.2 p.u. Then the p.u. impedance value of an alternator for the new base values of 13.8 kV and 50 MVA is......