1. For the given truss: (a) Draw the FBD of the truss. (b) Determine the supporting forces at A and G. (e) Find the zero forces members. (d) Determine the forces in members CE, CF, BF, and BG using the joint method. 4kN 7kN 3kN 60° 2m 2m 2m D B E 3m 135° 6kN

Q: P3 F 2.5m B 3m 3m - 3m P1 P2

A: a) Reaction forces on the diagram

Q: ION The truss is acted on by two forces and is supported by a roller at D and a pin support at F. a)…

A: Calculate the support reactions at support D and F…

Q: Determine the force in members CE, CF and BF for the truss loaded as shown. Ans. BF = 0.289P (T) BO…

A:

Q: 3.) Consider the 2D simple-truss shown below where point A is connected via a pin, and point D is…

A:

Q: The question is: Determine the force developed in the member HC of the below truss  (hint use the…

A: Method of Sections. FHC can be determined directly by writing the moment equations of equilibrium…

Q: 2 Determine the force in members BF, BE and CE of the truss shown and state whether these members…

A:

Q: 3m A 12 kN -3 m 8 kN B F -3 m C -3 m- E D 5m

A:

Q: Problem 3 Classify each of the trusses below as statically determinate, statically indeterminate, or…

A: Finding static indeterminacy

Q: Determine the force in members CE, CF and BF for the truss loaded as shown. Ans. BF = 0.289P (T) B…

A:

Q: For the truss shown below, the area of all bars is 1.8 in?; E is 30,000 kips/in? 1) determined the…

A: Given : Determinate truss A = 1.8 in2  E = 30000 kips/in2

Q: Determine the forces in members CG and GH of the symmetrically loaded truss. The forces are positive…

A:

Loads and Reactive Forces

Loads are the external influences that a beam experiences under its working conditions. For instance, a beam may be subjected to shear loads, twisting loads, bending moment, and axial loads during its working conditions. Engineers primarily deal with beams and trusses in the civil engineering domain. Due to the influence of loads, it is very crucial to determine the induced stresses and deformation values. These values give an insight into the critical area of the beam that needs to be worked upon to make it fail-safe.