1. Fill-in the blanks with the correct answer or chose the correct answer. the blue wire 1-3. Given a 3-wire NPN inductive sensor, the black wire is to be connected to the and the brown wire to the to the 4. After connecting the load to an NPN sensor, the other terminal of the load will be connected to the 5. If a PLC, serving as load, uses a sinking input card, it needs a (PNP/NPN) proximity sensor. 6. Capacitive, Inductive, Photo electric sensors are called proximity sensors because

1. Fill-in the blanks with the correct answer or chose the correct answer. the blue wire 1-3. Given a 3-wire NPN inductive sensor, the black wire is to be connected to the and the brown wire to the to the 4. After connecting the load to an NPN sensor, the other terminal of the load will be connected to the 5. If a PLC, serving as load, uses a sinking input card, it needs a (PNP/NPN) proximity sensor. 6. Capacitive, Inductive, Photo electric sensors are called proximity sensors because

Introductory Circuit Analysis (13th Edition)

13th Edition

ISBN:9780133923605

Author:Robert L. Boylestad

Publisher:Robert L. Boylestad

Chapter1: Introduction

Section: Chapter Questions

Problem 1P: Visit your local library (at school or home) and describe the extent to which it provides literature...

See similar textbooks

Similar questions

Explain about P Control of the Heat Exchanger.
2) Explain the operation of the PLC by drawing the block diagram.
Write a PLC program that will operate a light (Q0.0) according to the following sequence: A momentary contact normally open PB (I0.0) is pressed to start the sequence. The light is switched on and remains on for 5 seconds. The light is then switched off and remains off for 5 seconds. A counter is incremented by 1 after this sequence. The sequence then repeats for a total of five counts. After the fifth count, the sequence will stop and the counter will be reset to zero. Any help would do. No explanations required
A ring of inner radius and outer radius R, carries a unifom surfa ce charge density of its electric potential at point P on the central asis of the ring at di stance x from the center of the ring is given by 2, •N What is the electric potential when R nd R, ? Hint: On , 2k, D) On
What is the firing angle of SCR in AC voltage controller that makes the voltage across the load is a maximum? explain.
A motor can be turned on when a momentarily pushbutton A or B is pressed.Another pushbutton C is used to turn off the motor. The motor is equipped withoverload relay. With the implementation of holding mechanism (SETRESET/KEEP), design a PLC program ladder diagram for this system
Which one of the following statement is correct ? a. Controlled rectifier circuit requires small filters b. Efficiency is better in controlled rectifier circuit c. Switching frequency is not responsible for output ripples in chopper d. Controlled rectifier regenerative braking process is very slow Clear my choice
5
Can you do this fast
3. Describe working of different proximity sensors used in a PLC.
From our experiment we used LM555 timer to demonstrate a multivibrator circuit. The following choices are a PIN number and its function of LM555 timer, which one is not correct? PIN 2 - Trigger PIN 7 - Discharge PIN 6 - Threshold PIN 4 - Control Voltage
Define in short about PLC.