1. Explain the benefit of letting the solutions of HCl(aq) and NaOH(aq) sit overnight. 2. When using the same graduated cylinder to measure the volumes of HCl(aq) and NAOH(aq), it is important to rinse the cylinder with water and a small amount of the second reactant before measuring the volume of the second reactant. Explain why this is important for this investigation. 3. Describe how to perform each of the following safely: • diluting a strong acid solution with water • dissolving a solid base in water • adding a solution of base to a solution of acid

1. Explain the benefit of letting the solutions of HCl(aq) and NaOH(aq) sit overnight. 2. When using the same graduated cylinder to measure the volumes of HCl(aq) and NAOH(aq), it is important to rinse the cylinder with water and a small amount of the second reactant before measuring the volume of the second reactant. Explain why this is important for this investigation. 3. Describe how to perform each of the following safely: • diluting a strong acid solution with water • dissolving a solid base in water • adding a solution of base to a solution of acid

Chemistry

10th Edition

ISBN:9781305957404

Author:Steven S. Zumdahl, Susan A. Zumdahl, Donald J. DeCoste

Publisher:Steven S. Zumdahl, Susan A. Zumdahl, Donald J. DeCoste

Chapter1: Chemical Foundations

Section: Chapter Questions

Problem 1RQ: Define and explain the differences between the following terms. a. law and theory b. theory and...

See similar textbooks

Similar questions

13. A chemistry student offers a possible improvement to this lab. Since one goal of this lab is to determine the mass of the precipitate produced, wouldn't it be possible to measure the mass of an empty beaker, mix the solutions, and boil off the water until it is entirely evaporated, leaving only solid behind? Then the beaker with the precipitate could be weighed, and the difference between this mass and that of the empty beaker would be the mass of the precipitate. This would eliminate the need for the filtration step. Explain why this is a poor suggestion. Remember to check your reasoning on this question and all other questions with your instructor.
How can you figure out if a set of products will produce a precipitate?? I understand how to get to the reactants but I don't understand how to know if it forms a precipitate. Here is an example of figuring out which forms a precipitate: The mixing of which pair of reactants will result in a precipitation reaction? a. NaNO3(aq) + NH4F(aq) b. Li2SO4(aq) + Pb(NO3)2(aq) c. KI(aq) + NaOH(aq) d. HCl(aq) + Ca(OH)2( ^ answer choices
Molarity of the standard solution of sodium hydroxide = 0,lo00 mol/1 Volumes of NAOH(aq): Rough First Second Third titration titration titration titration Final burette reading: (mL) Initial burette reading: 18.48 33.58 48.40 23.72 3.48 18:48 33.61 8,92 Volume added: 15.00 15.10 14.79. 一4,80 Fourth Fifth Sixth Seventh titration titration titration titration Final burette reading: 38.68 20.62 Initial burette reading: 23.70 5.81 1 나.98 14,81 Volume added: oY ら,00 thefefore, cond uc
A constant amount of metal (Mg) about 0.080 g is reacted with two acids (HCl and H2SO4) to produce hydrogen gas a. write out a correctly formatted hypothesis that describes how the amount of hydrogen gas produced will be affected by the concentration of acid. b. write out a correctly formatted hypothesis that describes how the amount of hydrogen gas produced will be affected by the type of acid (HCl or H2SO4) reacted with the Mg metal
What two substances, when mixed, would create a precipitate? Choose two. a) NaC,H,0, (aq) b) NH,OH (aq) c) Ca(OH), (aq) d) KNO, (aq) e) Li,Co, (aq) E and Type the letters a, b, c, d, or e in alphabetical order
[Nonacid] Molecules Dissolve... Intact hmg H2O C12H22011(s) → C,2H22O11(aq) A2??4 Covalent chemical bonds! H2O CH5OH(s)→ Co Hs OH (aq) H2O (sand) SiO,(s)→ → Molecular nonacid solutes disperse to single molecules (_) ...but no further! Dissolved nonacid molecules stay whole
1. If 10. g of AgNO3 is available, what volume of 0.40 M AgNO3 solution can be prepared? Volume = mL? 2. A 7.52-g sample of a diprotic acid requires 179.0 mL of a 0.750 M NaOH solution for complete neutralization. Determine the molar mass of the acid. g/mol?
13
4. When a solutions of aluminum sulfate and potassium hydroxide are mixed, a precipitate forms. a. Write a balanced net ionic equation for the reaction. b. Calculate the mass of the precipitate when 3.89 g of aluminum sulfate in 100mL of solution is combined with 50 mL of the o.300 M KOH. c. What is the molarity of the ion in excess? (Ignore the spectator ions and assume that volumes are additive)
How can we complete and balance