1. Describe how would you use a multimeter to test each of the following. Describe where you would place the 2 probes, and which dial setting in the multimeter you would use. a.) check if a battery has low voltage i. b.) how much current is flowing at a certain point in a circuit 2. Describe 2 ways that multimeters are commonly 'burnt' (destroyed): ii. c.) check if the cable between your electric-guitar and an amplifier is broken under the insulation

Q: Three resistors are connected in series across a 12-volt battery course. It has found to be that the…

A: Given, three resistors are connected in series across a 12-volt battery, Let, R1​, R2​ and R3​ be…

Q: List 5 examples of devices using DC Voltage and 5 examples of devices using AC Voltage. Don't give…

A: The device using the DC voltage has a constant supply voltage. The example of these devices are…

Q: Explain the charging system from Supply system to the battery in detail

A: In an Electric Vehicle (EV), the charging system is responsible for transferring electrical energy…

Q: Calculate the upper and lower expected resistance values for a red-green-orange-silver resistor.

A:

Q: What is the coupling field used between the electrical and mechanical systems in energy conversion…

A: In this case, the proper coupling field that is used between electrical and mechanical systems in…

Q: shows the circuit of a battery polarity tester using a light emitting diode (LED) and a resistor R.…

A: For the given circuit we have to find out 2) power dissipated in the resistor.3) Largest voltage…

Q: If we were to connect a voltmeter directory to an ohmmeter, what would you expect to see

A: If we were to connect a voltmeter directory to an ohmmeter, what would you expect to see changes in…

Power Measurement

According to Blondel's theorem, the total power is measured with one less number of wattmeters than the number of wires present in the system. So, a single-phase and two-wire system will require one wattmeter and a single-phase and the three-wire system will require two wattmeters, and a three-phase and the three-wire system will also require two wattmeters and a three-phase and the four-wire system will require three wattmeter devices. The wattmeter is a device that measures power using one voltage and one current input as shown in the above figure. Multiple current or voltage input pair cables are used by many power analyzers and digital storage oscilloscopes (DSOs) for measuring watts, in effect within a single instrument acting as multiple wattmeters. It is possible to measure three-phase and four-wire power with one correctly specified power analyzer.