1. Compute the compression ratio of an engine that has a bore of 5 in. and a stroke of 5 in. when the volume at the combustion chamber is 16.36 cubic.in. with the piston at TDC

Q: Which of the following components give support to the wind turbine?

A: Explanation All the support provide by foundation to the wind turbine. There are two types of load…

Q: Multicylinder pump

A: Where more than one cylinder is being driven by one driver, the arrangement is named according to…

Q: A Toyota engine has a displacement volume of 0.004418 m and a clearance volume of 0.0004 m. What…

A: Compression ratio is equal to sum of displacement volume and clearance volume divided by clearance…

Q: Explain the Four - Stroke Cycle Engine p

A: Four strokes cycle engine can be a diesel engine or petrol engine if it is a diesel engine it has…

Q: 02:- Answer by False or True 1. If the swept area of the wind rotor increase the wind power decrease…

A: 1. A wind turbine is a device that converts the kinetic energy associated with moving air into…

Q: Single Engine Failure while Hovering

A: Single engine failure while hovering is a critical situation for any helicopter pilot. It requires…

Q: The car engine has a torque of 0.4 kNm at 2000 rpm (rev/min). What is the power (kW) at this time?

A: Given data: torque (T) = 0.4 kNm Speed (N) = 2000 rpm Need to determine the power.

Q: True or false Connecting rod in a reciprocating engine is an example for curvilinear translation

A: When the path of motion of two points on a body are along a curved line which are equidistant, this…

Q: What does the schematic symbol below representing?

A:

Q: What determines the cut off point in performance of wind turbine

A: Turbines cut in and cut off speeds are determined by the manufacturer to protect the turbine from…

Q: Backgrour grid Exit jet

A:

Q: C- Mention three of the advantage of the positive displacement pump?

A: The question given is

Q: This is called the... baggage hold propeller cabin cockpit

A: Baggage hold is the system of aircraft which is used to hold baggage or to store the baggage during…

Q: Draw the graphic symbol for a two-position spring centered valve, a spring offset valve, an…

A: Valve symbols are used to develop hydraulic circuits with ease. They convey the necessary…

Q: What flow rate at 4000 lbf/in.2 would it take for a hydraulic motor to deliver 20 FHP?

A: Pressure= 4000 lbf/in^2 Fluid power= 20 FHP   To find; Flow rate

Q: List any four limitations of using conventional energy sources

A: There are two main sources of energy which can be written as below, 1. Source of conventional type…

Q: Discuss the FRACTIONATING COLUMN in Oil Refinery Plant

A: To Explain : The fractionating column in oil refinery plant.

Q: The turbine depends mainly on the fluid kinetic energy to produce power

A: This question is based on the concept of turbine .

Q: WHAT ARE THE WASTE OF CAR TYRE

A: The waste tire is a type of tire that is not mounted on a car or vehicle. It means that the waste…

Q: A 4-cylinder, 4-stroke, diesel engine, has the following parameters: brake power = 100 hp, engine…

A: Given : n= 25 rps = 1500 rpm Bp = 100 hp = 74.57 kW bsfc = 213 g/kWh ρ = 0.85 g/cm3 To find : Volume…

Q: What are some of the main materials challenges in running jet engines at high temperatures? Select…

A: Given data:-Jet engines:-Jet engines propel aircraft by expelling high-speed exhaust gases. Air is…

Q: • A 6 MW generator had a thrust of 103,000 lb. The outside diameter of the step bearing is 12 in,…

A:

Q: What do you mean by intake stroke?

A: Intake stroke: It occurs when suction occurs due to downward movement of piston in an internal…

Q: 1) Draw a simple sketch of your regulator design 2) Draw a simple sketch of the spring

A:

Q: Question 3 A four-cylinder of 1.6 liters S.I engine (S4PH with BSFC = 0.5 lb/HP- hour) has the…

A: Given dataN=4BSFC=0.5Injector size =240 cc/minQ'=240 cc/minP'=43.5 psiP=50 psi ***As per company…

Q: Match each of the steady-flow engineering devices with its best description:   Question 1 options:…

A: A device that increases the pressure of a fluid by slowing it down - Diffuser  A device where two…

Q: The accelearation of the hip is not 0.59 m/s^2

A:

Q: ressure = 4 MPa on = 0.25 kg per BP per h value of fuel = 44 000 kJ kg s of the total heat developed…

A:

Q: C- Mention three of the advantage of the positive displacement 4 pump?

A: Given Data- Positive diaplacement pump given we have to list out its three advantage

Q: Radial hydraulic thrust is the summation of unbalanced impeller forces acting in the axial direction…

A:

Q: In order to maintain sufficient oil to critical components inside a combustion engine, it is…

A: Givens pumps are positive displacement types pumps and used for the lubrication of the  Gerotor pump

Q: ! Required information NOTE: This is a multi-part question. Once an answer is submitted, you will be…

A:

Q: Hello good Afternoon Sir, Permission, i have a question in my homework. The following bellow is…

A:

Q: write an article for one stroke engine

A: Introduction:The world of internal combustion engines has seen remarkable advancements over the…

Q: turbulent mixing complicated? A. The Reynolds number cannot be calculated when the flow is…

A: Option c is correct. Low frequency velocity fluctuations contribute to the complexity of such…

Q: Production tubing diameter has no effect on the inflow performance of a reservoir. Select one: True…

A:

Q: How many piston does a two stroke engine have

A: A two stroke engine with single cylinder will have one piston and it takes two strokes of the single…

Q: What is the unit of flow rate?

A: Flow Rate The flow rate or discharge is defined as the volume of fluid passing through a cross…

Q: For the Internal Combustion Engine test that you conducted, sketch the P-V diagram showing the…

A: The diesel cycle has a constant pressure because heat is added during the power stroke, so the…

Q: Steam powerplant

A:

Applied Fluid Mechanics

A fluid is a substance that is continuously deformed by the application of shear stress. The rate of deformation of a fluid depends on its viscosity. The fluid tries to flow when it interacts with some other system.