1. Calculate the mass of magnesium that is required to produce 27.8 mL of hydrogen gas at 26 °C and a total pressure of 735 mmHg when collected over water according to the following reaction. Use the table of vapor pressures of water given in the lab procedure to correct for the water vapor. Mg (s) + 2 HCI (aq) MgCl2 (aq) + H2 (g) Balance the following equation and calculate the volume of hydrogen gas produced from the reaction of 0.425 g of aluminum when completely reacted with excess hydrochloric acid. The gas was collected over water at 28 °C and a total ressure of 745 torr. Al (s) + HCl (aq) AlCls (aq) + H2 (g)

1. Calculate the mass of magnesium that is required to produce 27.8 mL of hydrogen gas at 26 °C and a total pressure of 735 mmHg when collected over water according to the following reaction. Use the table of vapor pressures of water given in the lab procedure to correct for the water vapor. Mg (s) + 2 HCI (aq) MgCl2 (aq) + H2 (g) Balance the following equation and calculate the volume of hydrogen gas produced from the reaction of 0.425 g of aluminum when completely reacted with excess hydrochloric acid. The gas was collected over water at 28 °C and a total ressure of 745 torr. Al (s) + HCl (aq) AlCls (aq) + H2 (g)

Chemistry

10th Edition

ISBN:9781305957404

Author:Steven S. Zumdahl, Susan A. Zumdahl, Donald J. DeCoste

Publisher:Steven S. Zumdahl, Susan A. Zumdahl, Donald J. DeCoste

Chapter1: Chemical Foundations

Section: Chapter Questions

Problem 1RQ: Define and explain the differences between the following terms. a. law and theory b. theory and...

See similar textbooks

Similar questions

Solid potassium chlorate, KCIO3, decomposes upon heating to form potassium chloride and oxygen gas. Write a balanced chemical equation for the reaction. The volume of oxygen that would form at standard temperature and pressure if 0.456 g KCIO3 decomposes is mL. Answer must be verified.
A chemical engineer must calculate the maximum safe operating temperature of a high-pressure gas reaction vessel. The vessel is a stainless-steel cylinder tha measures 52.0 cm wide and 62.4 cm high. The maximum safe pressure inside the vessel has been measured to be 7.00 MPa. For a certain reaction the vessel may contain up to 25.8 kg of sulfur hexafluoride gas. Calculate the maximum safe operating temperature the engineer should recommend for this reaction. Write your answer in degrees Celsius. Round your answer to 3 significant digits. temperature: C x10 X
The nitrogen content of organic compounds can be determined by the Dumas method.The compound in question is first passed over hot CuO(s): Compound N2(g) + CO2(g) + H2O(g) The gaseous products are then passed through a concentrated aqueous KOH solution to remove the CO2.The remaining gas contains N2 and water vapor.A 0.127-g sample of a compound was treated as above, producing 89.0 mL of N2 saturated with water vapor at 25 °C and 739.3 torr.What is the mass percent of nitrogen in the compound? . The vapor pressure of water at 25 °C is 23.8 torr.
A chemical engineer must calculate the maximum safe operating temperature of a high-pressure gas reaction vessel. The vessel is a stainless-steel cylinder that measures 26.0 cm wide and 31.2 cm high. The maximum safe pressure inside the vessel has been measured to be 2.40 MPa. For a certain reaction the vessel may contain up to 0.237 kg of dinitrogen monoxide gas. Calculate the maximum safe operating temperature the engineer should recommend for this reaction. Write your answer in degrees Celsius. Round your answer to 3 significant digits. temperature: || °C Contacts G.. APR 24 80 888 F2 DII F3 F4 F7 F8 F9 F10
2 H3PO4(s) --> 3 H2(g) + 2 P(s) + 4 O2(g) Using the reaction above, show step by step how many liters of oxygen can be created if I start with 0.7156 grams of H3PO4 solid at STP?
Given the following data from the experiment, calculate the molar volume of hydrogen gas at STP. Be sure to show all of your calculations. Note: You can assume the solution level was the same inside and outside of the tube at the end of the experiment. Mass of metal used : 0.0862 g Temperature of the gas collected : 24.0 °C Vapor pressure of water at 24 °C : 22.4 torr Volume of gas collected : 89.4 mL Room atmospheric pressure : 757 torr Gas constant : 0.0821 L • atm / K • mol
Please don't provide handwriting solution
Please answer
A student experimentally determines the gas law constant, R, by reacting a small piece of magnesium with excess hydrochloric acid and then collecting the hydrogen gas over water in a eudiometer. Based L-atm on experimentally collected data, the student calculates R to equal 0.0832 mol·K L-atm Ideal gas law constant from literature: 0.08206 mol·K (a) Determine the percent error for the student's R-value. Percent error = % (b) For the statements below, identify the possible source(s) of error for this student's trial. The student notices a large air bubble in the eudiometer after collecting the hydrogen gas, but does not dislodge it. The student does not clean the zinc metal with sand paper. The student does not equilibrate the water levels within the eudiometer and the beaker at the end of the reaction. The water level in the eudiometer is 1-inch above the water level in the beaker. The student uses the barometric pressure for the lab to calculate R.
Calculate the total pressure (in atm) of a mixture of 3.00 x 10-2 mol of helium, He, and 7.00 x 10- mol of oxygen, O2, in a 6.00 L flask at 20.°C. Assume ideal gas behavior. Total pressure atm ||
8. In one lab this semester, you ran the reaction: KC1O3 (s) → KCl (s) + O2 (g). The directions asked you to add about 1.5 g KC1O3 to a crucible. How many liters of O2 should form at STP?