1. ASSUMING THAT MR ALIWALAS WANTS TO CONSTRUCT A RAILWAY SYSTEM NEAR THE RIVER AND THE AREA IS PRONE TO EARTHQUAKE FIRE AND EROSION AND EXPOSED TO HEAVY TRAFFIC A WHAT ARE THE LISTS OF MATERIALS OF THAT YOU WILL RECOMMEND FOR ITS COMPLETE PERMANENT WAY

1. ASSUMING THAT MR ALIWALAS WANTS TO CONSTRUCT A RAILWAY SYSTEM NEAR THE RIVER AND THE AREA IS PRONE TO EARTHQUAKE FIRE AND EROSION AND EXPOSED TO HEAVY TRAFFIC A WHAT ARE THE LISTS OF MATERIALS OF THAT YOU WILL RECOMMEND FOR ITS COMPLETE PERMANENT WAY

Structural Analysis

6th Edition

ISBN:9781337630931

Author:KASSIMALI, Aslam.

Publisher:KASSIMALI, Aslam.

Chapter2: Loads On Structures

Section: Chapter Questions

Problem 1P

See similar textbooks

Related questions

Q: explain the importance of the following in characterizing a strain: (a) sources, (b) numbers, and…

A: Strain is the deformation of a material from stress. It is simply a ratio of the change in length to…

Q: What type of material can we use for bridge? If we using concrete then how will we improve the…

A: In construction of Bridge We can Use various Type of Material1. Steel2. Concrecte3. Stone…

Q: Suppose a pre-stressed concrete bridge project has completed its engineering design stage and ready…

A: For the use of unchanged sections of steel girder in place of prestressed concrete sections i) The…

Q: Why would the AASHTO separate structural dead loads from wearing surface dead loads anduse different…

A: The AASHTO separate structural dead loads from wearing surface dead loads anduse different load…

Q: Illustrate and discuss the different parts or components of the swine farm and greenshouse…

Q: What commercial size of new cast iron pipe shall be used to carry 4,490 gpm with a loss of head of…

A: Given data in question Discharge constant value Head loss To find out Diameter

Q: The architect has laid out the anticipated functions for a new library: offices, reading areas,…

A: Solution:- a) According to the codal provision, the minimum live load that must be considered when…

Q: Given the bridge abutment shown here, determine the numberof worker hours required to form the…

A: Given: L1=30ftL2=50ftL3=30ftThickness of wall(t)=1ftHeight of abutment(H)=8ft Form work area for…

Q: For you (As an engineer) why is dam constuction is interesting to buiild and challenging?

A: Dam:- It is a kind of barrier that stops or restricts the flow of surface water or underground…

Q: write short notes on why a timber brought onto the site is not good for construction of civil works.

A: Timber is one of the oldest and most convenient construction material. It is widely available and…

Q: How does the value of bearing capacity factor the soil above the pile tip is comparable to the soil…

A: The bearing capacity of pile is greatly influenced by the type of soil surrounding the pile, but…

Q: If the free haul area is between 4+30 and 14+30, what is the average haul distance (ft) for the net…

Q: Q- What is the correct Sentence scientifically? Using pile foundation when the O structure is…

A: Option 4 is correct Using pile foundation when the structure is adjacent the surface of the water.

Q: What do you mean by the mountain-valley wind? How it occurs?

A: the mountain valley wind occurs on the daily basis on a cycle. these wind flow from the mountain…

Q: which type of sand and timber brought onto the site is not good for construction of civil works

A: Concrete is the most used building material all over the world due to its high strength and…

Q: What is the item of importance in pile installation?

A: The piles are used to lay the foundation at hard strata thus getting better bearing capacity of soil…

Q: Bohol leyte link bridge expected date to finish and cost

A: Bohol leyte link bridge

Q: Briefly discuss the advantages of preloading methods?

A: The technique of pre loading was developed and is mainly was used in the projects connected to…

Q: Describe the categories of the structural loads applied to piles.

A: pile is the long cylindrical member made up with material which having high compressive strength .…

Q: . Explain a suitable structural form for a 12 km bridge to be built crossing a valley. Justify your…

A: A 12 km bridge is considered to be a very long bridge. We have six basic structural forms of…

Q: Using Internet resources, watch a few video clips on the Minnesota I35 bridgecollapse on August 1,…

A: An eight-lane, steel truss arch bridge that carried Interstate 35W over the Saint Anthony Falls of…

Q: What materials are most suitable for the construction of an embankment shell of a dam? Put into…

A: Solution: The embankment Dam cross section basically shows the shape of a bank or hill. They have a…

Q: Explain in your words the following : Under reamed piles

A: Under reamed pile : An under reamed pile is one with an enlarge base or bulb , the bulb is called…

Q: Hi. Can u help me with this task? when the building is built from logs, the settlement of the…

A: Given: sinking rate = 10 mm/m door way height = 2230 mm

Q: 1. ASSUMING THAT MR ALIWALAS WANTS TO CONSTRUCT A RAILWAY SYSTEM NEAR THE RIVER AND THE AREA IS…

Q: Why foldable wagon is important for apartment/high rise building?

A: In this question we are asked to find importance of all types of foldable wagon specially in case of…

Q: Explain what the mass haul diagram is all about

A: Readers can see a graphical orientation of the items transported with a mass haul diagram. The graph…

Q: A vertical lifeline rope with a rope grab must Reach the lower level or have a stop below the brake…

A: A vertical lifeline rope with a rope grab must : all of the above

Q: Explain different method of including non destructive method required method required for building…

A: The company uses non-destructive testing (NDT) to analyze the qualities of a substance, element,…

Q: Describe the Basic concepts of pile capacity related to soil support.

A: In situations where soil at shallow depth is poor, then in order to transmit the load safely, the…

Q: 1. To withstand the loads on it, a house structure must meet three criteria. What are these?…

A: The three main criteria for a house structure to withstand the loads on it are: 1. Structural…

Q: If the free haul area is between 4+30 and 14+30, what is the average haul distance (ft) for the net…

A: Free Haul Area between Volume section toTo find:Average Haul Distance (ft)NOTE:Since you have posted…

Q: example of invitation to tender pack for Road

A: An invitation to tender (ITT) is a proper greeting to make a proposal for the stockpile of products…

Q: An earthfill dam is being designed in an area prone to medium to severe earthquakes. What kind of…

A: An earthen embankment is a manmade embankment to store water, to raise the ground level for…

Q: Sleepers are.......... attacked by vermin and able to accommodate any .gauge Steel Concrete O Wooden…

Q: Timber is to be used in the construction of a single story house. Sketch the proposed house and…

A: Timber for construction is one of the many forest products used around the world. It is used in…

Q: Fall protection is generally required in Construction over? O 4 ft O 6 ft O 8 ft 10 ft

A: Fall hazards occur in construction works mainly due to falling of materials and tools over workers…

Q: What is pile and pier? Write the differences between pile and pier

A: In pile foundation, the loads are transferred by means of vertical timber, concrete or steel. Pier…

Q: b) Why buckling in a rail section take place and how this distress could be avoided? Is welded rail…

A: To find out the buckling of rail section and how this distress could be avoided. To find out the…

Q: A multistorey building is constructed in Al Seeb near old Muscat international airport. All the…

A: We answer three sub-parts at a time so we will answer first three. please resubmit another question.…

Q: There are 3 ways to protect against trenching hazards. Which one of the following is not a method? O…

A: Trenching is technique of excavtion in ground . The depth of excavation is deeper than its width .…

Q: provides various engineering solutions, including electrical, mechanical and construction. As part…

A: Hi there!! Since you have posted a question with multiple sub-parts, we will solve the first three…

Q: -------- was built in the 1920s. It vwas the first concrete bridge in this city The bridge which O…

A: If it is human, we refer it as 'who' If it belongs to someone, we say 'whose' If it is an object ,…

Q: Class Prep Problem • Will the following crane tip over if it is picking up 7 kips? • The weight of…

Q: Explain a suitable structural form for a 12 km bridge to be built crossing a valley. Justify your…

A: Generally, six forms of structural bridges are there- Beam bridges. Arch bridges. Truss bridges.…

Concept explainers

Pavement Management

Pavement management is the process of planning the maintenance and repair of a roadway network or other paved infrastructure to improve road conditions throughout the network. It is also used on runways and airports. Every highway superintendent undertakes walkway management. Traffic management includes the cost of living cycles in a systematic way of repairing minor and major roads and reconstruction projects. The needs of the entire network and budget estimates are considered before the projects are undertaken, as the cost of data collection can change significantly. Pavement management incorporates many of the features and functions required to maintain the quality of the paved material as well as to ensure that the entire road network can sustain itself at the required levels. Although pedestrian management involves the life cycle of commuting from planning to maintenance of any transport infrastructure, road asset management, and road maintenance planning is primarily aimed at road infrastructure.

Question

1. ASSUMAING THAT MR ALIWALAS WANTS TO CONSTRUCTA RAILWAY
SYSTEM NEAR THE RIVER AND THE AREA IS PRONE TO EARTHQUAKE
FIRE AND EROSION AND EXPOSED TO HEAVY TRAFFIC
A WHAT ARE THE LISTS OF MATERIALS OF THAT YOU WILL
RECOMMEND FOR ITS COMPLETE PERMANENT WAY

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Step by step

Solved in 2 steps with 1 images

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, civil-engineering and related others by exploring similar questions and additional content below.

Similar questions

(b) Timber is to be used in the construction of a single story house. i) Sketch the proposed house. ii) Indicate with justification three (3) possible structural and three (3) non- structural application of timber. iii) What is glu-laminated timber? Explain the suitability of glu-laminated timber to be used in the construction of the house.
Tall building construction
Explain about the Pile Tip Bearing.
A ball bearing operates at 3000RPM, and has a life of 50,000 hours, 6500hours and 1000hourswhen subjected to constant amplitude loads of 1kN, 2kN and 4kN. During each hour of operation,the load is 4kN for 5min, 2kN for 15min and 1kN for 40min. Given this information, determinethe total damage caused by this loading sequence on the ball bearing. Also, determine the life ofthe bearings in terms of hours. What percentage of the damage is caused by each of the loadingindividually?
write a case study about construction mangement of the methodology and modern techniques about Casa Mila bulding.
I need the answer as soon as possible
How many 16-kip axle loads are needed to reduce the serviceability index to the same p, = 2.5 limit?
Scaffolding is one of the most important temporary structures in construction system to erect the building level. Thus, discuss briefly FIVE (5) significances of scaffolding specification towards in construction work
A 40 ft * 60 ft one-story agricultural storage building will have corrugated steel siding and nointerior finish or interior columns. However, it will have two 20 ft wide roll-up doors. Determinethe allowable total and differential settlement for this building.
Explain the differences in the types of railway sleepers according to disadvantages of their use.
(B) Confirm the validity of statements by writing (T) otherwise write (F) and gave your opinion for it. 1-Steel H 4- In Iraq, timber pile is available, low cost, and widespread.
You are a structural Engineer who works in Dar Al Handasah company. Your ene-up-direct manager has called for a meeting and providedyou with the below schematic design of a concrete beam that might þe implemented at one of the sites. You were requested to calculate the following: (make 15 KN bold) 40 KN 15 KN 20 KN 45 30 KN 40 KN 16 20 Figure 1: Concrete Beam 1. Find the equivalet forces of the disturbedloads. 2. Sketch the beamshowingwith all the applied forces (reaction and equivalent forces) and allocat theminto thetheir suitable locationsproperpoints. 3. Apply the momentequations in the equilibrium state to find the value ofthe reaction forces at points A and B. 4. Ifthe given beamin Figure 1 compressedehrank to be 19.98 meter where the originaltempreture was atthe giventemperature T1=200 K, find the temperature (T2) afterthe compressionelminking.