1. a) Write a short note on the generation of electrical energy. b) Define a steam power station and explain the factors taken into account while selecting the site for a steam power station. c) A diesel engine power plant has one 700 kW and two 500 kW generating units. The fuel consumption is 0-25 kg per kWh and the calorific value of fuel oil is 10000 kcal/kg. Estimate (i) the fuel oil required for a month of 30 days and (ii) overall efficiency. Plant capacity factor is 40%.

1. a) Write a short note on the generation of electrical energy. b) Define a steam power station and explain the factors taken into account while selecting the site for a steam power station. c) A diesel engine power plant has one 700 kW and two 500 kW generating units. The fuel consumption is 0-25 kg per kWh and the calorific value of fuel oil is 10000 kcal/kg. Estimate (i) the fuel oil required for a month of 30 days and (ii) overall efficiency. Plant capacity factor is 40%.

Introductory Circuit Analysis (13th Edition)

13th Edition

ISBN:9780133923605

Author:Robert L. Boylestad

Publisher:Robert L. Boylestad

Chapter1: Introduction

Section: Chapter Questions

Problem 1P: Visit your local library (at school or home) and describe the extent to which it provides literature...

See similar textbooks

Similar questions

A noninductive heater element with a resistance of 5 2 is connected across a 60 Hz source. The supply has a sine wave voltage with an instantaneous maximum value of 141.4 V. a. Determine the power in watts taken by the heater unit. b. What is the energy, in kilowatt-hours, taken by the heater unit in one month if it is operated 5 hours per day for a period of 20 days?
I need to solve the question in 10 minutes, please
15. An AC ammeter set at 10 A is connected in series with the lamp which is busted/open. What is the current reading? Assume the lamp has a resistance of 10 ohms.
17. An AC ammeter set at 10 A is connected in series with the lamp which is shorted. What is the current reading? Assume the lamp has a resistance of 10 ohms.
(a) Illustrate the process of power generation from a typical thermal power plant. Describe the overall power generation process of a typical thermal power plant based on your illustration in 5(a). Distinguish between geothermal power plant and thermal power plant.
Discuss the significance of power factor in electrical power systems and its impact on efficiency.
low voltage systems An AG 1 heater has 230 V and 10 kW on its label. So which of the following shows the 230 V value? a) Effective Voltage b) Maximum Voltage c)Peak Voltage d) Average Voltage
2. Draw and Explain Schematic diagram of Geo Thermal power plant. Discuss its disadvantages.
Which of the following sources need expensive machines for large scale production of electricity? a. Biofuel O b. Coal c. Biomass O d. Wind