1. A steel rod is subjected to tension force (diameter: 30 mm) is made of annealed AISI 1015 steel. Yield strength of the annealed AISI 1015 steel is 386 MPa. (a) If the test specimen yielded when it was subjected to tensile force P, calculate P. yielding if the applied tensile force P is 1,200 kN. (b) Calculate safety factor against 30mm

Q: A torsion test shows that the shear modulus of an aluminum specimen is 27.6 GPa. When the same…

A: Shear modulus, G= 27.6 GPa Modulus of elasticity, E= 73.2 GPa   To find: Poisson's ratio, μ

Q: For some metal alloy, a true stress of 345 MPa (50040 psi) produces a plastic true strain of 0.02.…

A: The step by step solution for this problem is shown below.

Q: A stress-strain diagram for a tension test of an alloy steel sample is shown in the diagram below.…

A: Stress-Strain curve describes the relationship between stress and strain under a certain load in…

Q: The following results were obtained in a tensile test on a mild steel specimen of original diameter…

A: According to Hooke's law, Young's Modulus of Elasticity is defined as the ratio of longitudinal…

Q: In a tensile test, the force at the yield point was 1000 KN, at the ultimate point was 1500 KN and…

A: Given data: The yield point load on the specimen is Fy=1000 kN The ultimate point load on the…

Q: Consider the tensile stress-strain diagram below. If samples 1 and 2 are identical except that they…

A: From given stress strain diagram,it is required to determine which sample tested at lower…

Q: modulus of elasticity

A: in the question original length is not given. With original length of the specimen not possible to…

Q: A titanium alloy (Ti-5Al-2.5Sn) specimen with the dimensions shown below is subjected to a uniaxial…

A: The stress of a bar is given by,  , where P is the normal load and A is the cross-section area of…

Q: Load (lb) Elongation (in.) Load (Ib) Elongation (in.) 14 000 0.020 2310 0.0022 14400 0.025 4 640…

A: Hello. Since your question has multiple sub-parts, we will solve first three sub-parts for you. If…

Axial Load

When a bar of the uniform cross-section is acted by a load, such that the load acts along the longitudinal axis of the bar, such kinds of loadings are known as axial loadings. In general terms, a load is an external force acting on a component. An axial load acts perpendicular to the geometric cross-section of the component. Based on the direction of the application of the load, an axial load can be tensile or compressive. The analysis of bodies under the action of axial loads is generally studied under the branch of mechanics, known as statics.