1. A parallel-plate capacitor has a plate area of 0.2m² and a plate separation of 0.1 mm. If the charge on each plate has a magnitude of 4 × 106 C, what is the potential (CLO1) difference across the plates approximately? Note: & permittivity of free space -8,85.10-12 C²/Nm²

Q: What is the voltage drop across RC, VC, in volts?  (Enter the number, not the units.)

A: Given circuit is -

Q: I can't really make out the workings because it's kinda scribbled ? Could it be made more clear ?…

A: The thevenin's equivalent circuit can be obtained by calculating the open circuit voltage and…

Q: Fill in the blanks for Ampacity, Voltage, Power and Resistance

A:

Q: question: Suppose that you want to sort blocks of different heights automatically. How can this task…

A:

Q: HERE IS IT

A: Physical address can be expressed by the following formula:Physical Address = (Segment Address) x 10…

Q: Question: What are the applications of Energy Storage System?

A: Different energy sources are required in day to day life. These energy sources can be renewable or…

Q: I have an O Gauge track and would like to convert it into a “sensored” track. Additionally, I would…

A: According to the question, an O-gauge track and would like to convert it into a “sensored” track.…

Q: if you have (10) 10 OHM resistors and (5) OMR resistors in a series circuit what would the total…

A: Resistances are given as,

Q: How Rth connected with the load resistance, explain

A: RL will be  connected in series with  RTH  as shown in the example.

Q: Does ‘a three digit color coding of resistor values’ limit producible resistor value ranges? Why? If…

A: Solution Yes color coding of resistor values limit the resistor value range. In colour coding of…

Thermistors

A thermistor is a special type of resistor whose resistance is more temperature-dependent than standard resistors.  The resistance of the thermistor decreases with increasing temperature. This is the basic principle of thermistors. This allows the thermistor circuit to detect very small temperature changes that cannot be observed with the Resistance temperature detectors (RTDs) or the thermocouples. Since the resistance of a thermistor is temperature dependent, it can be connected to an electrical circuit to measure body temperature. This high sensitivity to temperature changes makes thermistors very useful for accurately controlling and calibrating temperature measurements. In general, resistance increases with increasing temperature in most metals, but thermistors react negatively.