1.) A loaded scow has draft of 1.8m in fresh water when erect. The scow is 6m wide, 12 long, and 2.4m high. It's center of gravity is 0.6m below the top of the scow along the vertical axis of symmetry. What maximum single weight W can be .moved transversely over the edge of the side without sinking the scow? Assume the center of gravity is at the same point. Determine also the value of the moment of the couple in kN-m.

1.) A loaded scow has draft of 1.8m in fresh water when erect. The scow is 6m wide, 12 long, and 2.4m high. It's center of gravity is 0.6m below the top of the scow along the vertical axis of symmetry. What maximum single weight W can be .moved transversely over the edge of the side without sinking the scow? Assume the center of gravity is at the same point. Determine also the value of the moment of the couple in kN-m.

Structural Analysis

6th Edition

ISBN:9781337630931

Author:KASSIMALI, Aslam.

Publisher:KASSIMALI, Aslam.

Chapter2: Loads On Structures

Section: Chapter Questions

Problem 1P

See similar textbooks

Similar questions

Please help, I promise to give good feedback. Please do not just guess. Thank you!
b10
The loaded scow has a draft of 1.8 m in fresh water when in upright position. The scow is 6m wide and 12m long & 2.4 m deep. The center of gravity of the scow is 1.8 m above the bottom of the scow along the vertical axis of symmetry. What is the maximum safe weight that can be moved transversely from the center of the scow & unloaded over the side without sinking it?
Q.9 A single concentrated load of 1000 kN acts at the ground surface. Construct an isobar for σz= 40 kN/m2 by making use of the Boussinesq equation.
please answer it all thank youu...
Determine the value of El y at the right end of the overhanging beam. a = 4.4 m, b = 2.8 m, Wo = 19.0 kN/m a Wo b
this
A loaded scow has draft of 6ft in fresh water, when erect. The scow is 20ft wide and 40ft long and 8ft high. The center of gravity of the scow is 6ft above the bottom along the vertical axis of symmetry. What is the max. single weight that can be moved transversely from the center of the scow and unloaded over the side without sinking the scow?
1. A cantilever R.C. beam is 280 mm x 500 mm deep and is reinforced with 4- 20 mm diam bars for tension. Using an effective depth of d = 450 mm, determine if the 2.50 m long beam is adequate to carry a uniform load of 15 KN/m and a concentrated load of 10 KN at the cantilever end. Use f'c = 21 MPa, fy = 275 MPa. Neglect the weight of beam. Use n = 9 (Alternate Method of Design) %3D %3D %3D 2. Referring to #1, using the same data, determine if the cantilever beam is adequate based on strength design 2001 NSCP specifications. The 15 KN/m load is DL while the 10KN load is LL.