1. A liquid which is around vaporization state is called:o Saturated liquido Compressed liquido Saturated Liquid-Vapor mixture2. Heat added and work done by a system are negative.o Trueo False3. The amount of heat required to raise the temperature of a substance by one degreeduring an isobaric process is known as:o Cvo Cpo Lh- is a devise that decreases the speed of the passing fluid while increasing4. А -its pressure.o Turbineo Compressoro Nozzleo Diffuser--, all the properties of the system except the temperature vary as moving5. In -from one state to another.o Isobaric Processo Isometric Processo Isothermal Processo Polytropic Process6. The specific heat at a constant pressure Cp is always smaller than the specific heat ata constant volume Cv.o Trueo False7. Energy required to push the mass into or out of the control volume iso Enthalpyo Flow energyo Internal energy8. The 2nd law of thermodynamic state that energy has aand

Note-As per the honor code we can answer upto three parts. Please, repost question to get detailed…

1. A liquid which is around vaporization state is called: o Saturated liquid o Compressed liquid o Saturated Liquid-Vapor mixture 2. Heat added and work done by a system are negative. o True o False 3. The amount of heat required to raise the temperature of a substance by one degree during an isobaric process is known as: o Cv o Cp o Lh

1. A liquid which is around vaporization state is called: o Saturated liquid o Compressed liquid o Saturated Liquid-Vapor mixture 2. Heat added and work done by a system are negative. o True o False 3. The amount of heat required to raise the temperature of a substance by one degree during an isobaric process is known as: o Cv o Cp o Lh

Refrigeration and Air Conditioning Technology (MindTap Course List)

8th Edition

ISBN:9781305578296

Author:John Tomczyk, Eugene Silberstein, Bill Whitman, Bill Johnson

Publisher:John Tomczyk, Eugene Silberstein, Bill Whitman, Bill Johnson

Chapter2: Matter And Energy

Section: Chapter Questions

Problem 29RQ: If 3000 ft3 of air is crossing an evaporator coil and iscooled from 75F to 55F, what would be the...

See similar textbooks

Similar questions

One British thermal unit will raise the temperature of _____ 1b of water _____F.
If 3000 ft3 of air is crossing an evaporator coil and iscooled from 75F to 55F, what would be the volume of air, in ft3, exiting the evaporator coil?
1. Consider the following schematic of a power plant (operating in what is called a 'Rankine Cycle') Turbine Steam generator Condenser Coling water Economiaer The power plant control room reports that the plant is operating continuously at the following peak load conditions: a. Power to pump = 300KW b. Rate of steam flow = 25 kg/s c. Cooling water temperature at condenser inlet = 13 C d. Cooling water temperature at condenser outlet = 34 C Additionally, the following measurements were made at various points in the piping connecting the power plant components Data Pressure Temp. Quality enthalpy Specific Velocity (kJ/kg) point (kPa) volume (m/s) (m3/kg) (C) (x) 1 6200 2 6100 43 5900 177 ---- 4. 5700 493 ----- 5 5500 482 ----- 6 103 0.94 183 7 96 43 -----
Which of the following statement is correct for Isobaric process? Select one: O a. The value of Change in enthalpy is zero O b. When a gas is heated at constant pressure, its temperature and volume both will increase O C. The value and direction of change in internal energy and the value and direction of work is same O d. Isochoric process and Isobaric process are same
these are the properties dependent on the size or extent of the system
Q-1(c): Consider a case in which the air inside the pressurized cabin of a jet transport flying at some altitude of pressure, 0.9 atm and of temperature, 15°C. The total volume of air at any instant inside the cabin is 1800m3. If the air in the cabin is completely recirculated through the air conditioning system every 20 min, calculate the mass flow of air in kg/s through the system. I Answer:
Q1) The heat capacity at constant volume of hydrogen sulfide at low pressures is given by Eq. Q1-1: Co[kJ/(mol•°C)] = 0.0252 + 1.547 × 10-T – 3.012 × 10-9T² Eq. Q1-1 ........ Where, Tis temperature in °C. A quantity of H2S is kept in a piston-fitted cylinder with initial temperature, pressure, and volume equal to 25°C, 2.0 atm, and 3.0 liters, respectively. i- Calculate the heat (kJ) required to raise the gas temperature from 25°C to 1000°C, if the heating takes place at constant volume (i.e., if the piston does not move). ii- For a closed system at constant pressure with negligible kinetic and potential energy changes, the specific heat is determined by Eq. Q1-2: Cp = Cy + 0 008314 Eq. Q1-2 calculate the heat (J) required to raise the gas from 25°C to 1000°C at constant pressure. What would the piston do during this process? Given the gas constant = 0 08206 atm. Lit/ (mol. K)
Consider the following : 1. When a gas is heated at constant pressure, its temperature and volume both will increase 2. Volume V,-Vz 3. Change in heat transfer is equals to change in internal energy 4. The value of the work done is not zero Which of the above condition relates with isobaric process? Select one: O a. 1,2 and 4 only O b. 1, 2, 3 and 4 O C. 1,3 and 4 only O d. 1 and 4 only d anssad a
If an initial volume of an ideal gas is compressed to one-half its original volume, and to twice its original temperature, what happens to the pressure? O It becomes four times as much as the original pressure. O It becomes twice as much as the original pressure. O It becomes thrice as much as the original pressure. ON O It becomes one-fourth of the original pressure. O It becomes half the original pressure.
P2 Explain the application of the first law of thermodynamics to appropriate systems
i- The throttling is an isothermal process of an ideal gas ii. The enthalpy of a perfect gas is equal the specific heat at constant pressure times the absolute temperature.
Skg of Steam at pressure of 4.9 bar is produ- ced from water at 20c. Determine the amount of heat supplied if the Steam is o.9 dy.