1. A hollow steel box beam has the rectangular cross section shown in the figure. Determine the maximum allowable shear force V that may act on the beam if the allowable shear stress is 40 MPa. 10 mm 20 mm 20 Imm 200 mm 450 10 mm mm

Q: Determine the shear strain Yxy at corners D and the plastic distorts as shown by the dashed lines. 3…

A:

Q: A beam supports has been shown in the bellow figure. The material is gray cast iron. The value of…

A: Since we only answer up to 3 sub-parts, we’ll answer the first 3. Please resubmit the question and…

Q: Let strain rosette shown in figure computed the values of strains at the built in end and in NA of…

A:

Q: Draw the Shear and Moment Diagrams ラド |5- W=3K/FT. D B う 201 in

A: for equilibrium sum of forces in y axis is equal to zero, RA+RC-5-15-3×20=0RA+RC=80 k For…

Q: The piece of plastic is originally rectangular. Calculate the shear strain Yxy at corners A and B if…

A: For small angles.

Q: The beam shown in the figure below is subject to a moment of M = 10 kN.m as illustrated. Calculate…

A:

Q: Determine the internal forces at point J for the structure shown, where member BD can only carry…

A: Given:- a=160 mmP=450 N To find:- Internal force at point J

Q: g) Calculate the magnitude of the maximum bending stress in the beam. Enter your answer in MPa to…

A: Given:Required:Maximum bending stress

Q: If the distance of the outside edge to the axis of curvature is 100 mm, locate the centroidal axis…

A: The figure is shown below,

Q: Let strain rosette shown in figure computed the values of strains at the built in end and in NA of…

A:

Q: A steel beam (E = 208GPa) has square cross-section (edge = 40mm) and is constrained and loaded as in…

A:

Q: The steel bar has the original dimensions shown in the figure. If it is subjected to an axial load…

A:

Q: For the simply supported beam with the given cross-section, the shear force diagram has been…

A:

Q: (a) Try to find the slope of point A and point C after deformation. (b) Try to find the (vertical)…

A:

Q: termine the shear strain yxy at corners A, B, C, D i = dashed lines. Consider small strain…

A:

Members with compression and bending

Compression members are structural elements that carry compressive axial force. They are the vertical members of a building that support beams and their design, which is governed by buckling and strength. Columns are known as struct or compression members, which are subjected to compressive forces. These members provide stiffness to the building and avoid any imperfection regarding the transfer of axial load. For instance, webs in a truss, braces in a framed structure, tiers, and so on.