1. A cylindrical tank 80 cm in diameter and 90 cm high is filled with a liquid. The tank and the liquid weighed 420 kg. The weight of the empty tank is 40 kg. Determine the following properties of the liquid: a. Unit weight, in kN/m³ b. Mass Density, in kg/m³ C. Specific Gravity, SG Ans. y = 8.24 kN/m³; p = 839.96 kg/m³; SG = 0.839

1. A cylindrical tank 80 cm in diameter and 90 cm high is filled with a liquid. The tank and the liquid weighed 420 kg. The weight of the empty tank is 40 kg. Determine the following properties of the liquid: a. Unit weight, in kN/m³ b. Mass Density, in kg/m³ C. Specific Gravity, SG Ans. y = 8.24 kN/m³; p = 839.96 kg/m³; SG = 0.839

Structural Analysis

6th Edition

ISBN:9781337630931

Author:KASSIMALI, Aslam.

Publisher:KASSIMALI, Aslam.

Chapter2: Loads On Structures

Section: Chapter Questions

Problem 1P

See similar textbooks

Similar questions

A liquid storage tank consists of a vertical axis circular cylindrical shell closed at its lowered end by a hemispherical shell as shown in the figure. The weight of the system is carried by a ring like support at the topand the lower extremity is unsupported. A liquid of specific weight of 9KN/m^3 entirely fills the container. Consider H = 8m, R =2.4m, and plate thickness of 1.8mm. a.Find the peak stress in the hemispherical region. b.Calculate the peak circumferential stress in the cylindrical region. **Note = Pressure = specific weight x height Show free body diagram
Question B2 As shown in Figure B2, a cylindrical steel structure (density pb = 8000 kg/m³) loosely sits vertically on a flat concrete slab that is fixed at the bottom of the riverbed and in parallel to the river stream. The diameter and length of the cylindrical steel structure, which is fully immersed in the river stream, are 1 m and 6 m, respectively. The properties of water are given as density p = 1000 kg/m³ and viscosity µ = 1.0x103 N.s/m?, respectively. The drag coefficient of the cylindrical steel structure can be taken as 0.5. It is assumed that i) the flow of river stream is steady; i) the ground effect around due to the slab on the river stream is negligible; ii) the acceleration due to gravity, g. can be taken as 10 m/s?. Determine the minimal speed of river stream, V, at which the cylindrical steel structure can be tipped over. V H=6m D=Im Concrete slab River bed Figure B2
(c) Consider the following conditions: Condition 1 Condition 2 A wooden cube of size 2 m and the 20% of the volume of a body is visible relative density of 0.5 floats in the over the free surface of the water. water. Calculate: (i) Volume of the cube submerged in the water, based on Condition 1. (ii) Density of the wooden cube, based on Condition 2.
8. A block of ice float in the sea as shown in the -3 figure below. The density of sea is 1.2 gr cm¯ and density of ice is 0.9 gr c-3. The volume of x ice in sea water = ....... X the volume of ice in the air. Density of sea (Psea) = 1.2 gr -3 cm Gunung es
Illustrate the diagram
A cylindrical barrier holds oil as shown. The contact between the cylinder and the wall is smooth. Consider a 2- Im length of the cylinder. The water inside the cylinder is exposed to atmospheric pressure. What is the minimum mass (ton) to achieve the equilibrium as shown in the figure? B Oil S.G. =0.8 r=m 57 Water
Given: diameter of orifice=100mm diameter of tank=1.2m C=0.65 solve for the time it takes to: a) remove the first liquid b) remove the second liquid c) completely drain the tank use 3 decimal places
3Q. At normal atmospheric conditions, approximately what pressure in MPa must be applied to water to reduce its volume by 3%? (Take Ey= 320,000 psi at normal atmospheric conditions)
Please solve Correctly,It's Simple one . Don't Provide Wrong solution again and again. Check all the values. (And make sure to add +ve or -ve in the final ans)
...
The water tank has a diameter of 750mm , a height of 1750mm to which the Initial height of water was 5 cm. If water was to be filled 90% of height and the water meter initial reading is 2000L, a. what is the final reading of the water in L b. Find the mass of water tank if its initial weight is 45 kg
Example ( 7) A cubical body is subjected to -48000 N/mm, ,-35000 N/mm and o,=30000 N/mm if the length of cube =0.02m , E=1*10 N/mm', u =0,25, determine the change in length in three direction. 35000 N/mm? 48000 N/mm 30000 N/mm