1. A cylindrical steel tank is manufactured based on the following data: internal pressure: 36 MPa factor of safety with respect to YP: 2.0 yield stress in tension (circumferential): 900 MPa yield stress in shear (longitudinal): 440 MPa (a) Determine the minimum wall thickness if the diameter of the cylindrical steel tank is 360 mm. (b) Determine the maximum acceptable internal pressure if the wall thickness is 1.28 cm. Use 2 decimal places in every solved values.

1. A cylindrical steel tank is manufactured based on the following data: internal pressure: 36 MPa factor of safety with respect to YP: 2.0 yield stress in tension (circumferential): 900 MPa yield stress in shear (longitudinal): 440 MPa (a) Determine the minimum wall thickness if the diameter of the cylindrical steel tank is 360 mm. (b) Determine the maximum acceptable internal pressure if the wall thickness is 1.28 cm. Use 2 decimal places in every solved values.

Structural Analysis

6th Edition

ISBN:9781337630931

Author:KASSIMALI, Aslam.

Publisher:KASSIMALI, Aslam.

Chapter2: Loads On Structures

Section: Chapter Questions

Problem 1P

See similar textbooks

Similar questions

Locate the centroid of the plate area shown below: (All units are in mm).
take note: please use virtual work method or unit load method (mechanics of deformable bodies)
aircraft structural mechanics
Cross-Section A (Channel Cross-Section) The first cross-section is what is often referred to as an open 'channel' cross-section. The dimensions are given as: b = 160 mm ● ● ● d = 220 mm t = 40 mm ● • x b With reference to the origin shown above, what are the coordinates of the centroid for this cross-section: y - X -t- Imax • Imin mm mm d What is the maximum and minimum second moment of area about axes passing through the centroid: mm4 mm 4
What does symmetry and anti-symmetry mean in terms of loads.
Solid Mechanics
Subject: Mechanics of solids
Describe at least 5 parts of theodolite and provide introduction and conclusion.
MECHANICS OF DEFORMABLE BODIES Torsion
Subject :Mechanics of materials Give me right solution