1. A 75mm x 37.5mm Venturi meter installed in a 75mm pipe to measure the flow of oil (s.g = 0.850. A differential gage connected with inlet and throat contains water in the lower part of the tube. The remainder of the tube is filled with oil. The difference in height of the water column in the two legs of the tube is 560mm. If the coefficient of meter is 0.97. Compute the discharge. Fig. 75mmo 37.5mmo oil 560mm water

Q: 450 mm 150m -0. 375 mm Mercury S = 13.6

A: Given data Diameter of inlet= 450 mm  Diameter of throat = 150 mm  Specific gravity of mercury =…

Q: Two vats are connected by a submerged pipe with a square cross-section, as shown in Figure Q2. A…

A: h2 > h1 Let density of fluid be ρ

Q: In Fig. all pipes are 8-cm-diameter cast iron. Determine the flow rate from reservoir (1) if valve C…

A: D = 8 cm or 0.08 m  Kv = 0.5

Q: The mercury manometer indicates a differential reading of 0.30 m when the pressure in pipe A is…

A: Pressure diffrence has to calcluated

Q: Water flows through a 90° bend in a horizontal plane as depicted in the figure.

A:

Q: Q. A fountain consists of a horizontal inlet pipe with a cross-sectional area, A1, which enters a…

A: Figure is as shown

Q: 1. A pump station design fills a pressurized water tank by pumping water from a reservoir. The flow…

A: Frictional loss is due to shear stress in the walls of the pipe.

Q: For the pipe enlargement shown, the pressure at sections (1) and (2) are 56.3 and 58.2 psi,…

A:

Q: taining air and water is shown. At the closed end of the manometer the air pressure is 16…

A:

Q: Calculate the coefficient of discharge for the venturi meter if the flow rate is 102 m^3/hr. O 0.197…

A: