1. (1) Why fractions of higher boiling from crude oil (such as heavy gas oil) does not make a good fuel for engine combustion? (ii) Write the name of TWO (2) physical properties which are related to chemical composition of crude oils? (iii) How does salt get into crude oil?

1. (1) Why fractions of higher boiling from crude oil (such as heavy gas oil) does not make a good fuel for engine combustion? (ii) Write the name of TWO (2) physical properties which are related to chemical composition of crude oils? (iii) How does salt get into crude oil?

Chemistry: The Molecular Science

5th Edition

ISBN:9781285199047

Author:John W. Moore, Conrad L. Stanitski

Publisher:John W. Moore, Conrad L. Stanitski

Chapter10: Fuels, Organic Chemicals, And Polymers

Section: Chapter Questions

Problem 119QRT

See similar textbooks

Similar questions

What constitutes a 'reference material', and why does its utilization play a criticalrole in the chemical analysis of food products? Provide examples.
The fat in a 1.821 g sample of potato chips is extracted with supercritical CO2. After extraction, the residue weighs 1.139 g. What is the fat content (% w/w) of the potato chips?
When fractions from crude oil are burned in air, new compounds are made.These compounds can sometimes cause pollution. Describe how burningfractions from crude oil can cause pollution. Name the compounds produced.
5.20 g of tea leaves were used for the extraction of caffeine in a laboratory experiment, If the mass of crude caffeine obtained and the mass of pure caffeine recovered after recrystallization are 0.166 g and 0.082 g respectively, what is the percentage yield of pure caffeine from the tea leaves? O 2.10% O 2.30% O 1.58% O 3.62%
(a) A commercial 737 jet transporting 143 passengers and 5 crew members from Kansas City (MCI) to Baltimore (BWI) burned 11,800 lb (about 1700 gallons) of Jet A fuel en route. Jet A fuel is kerosine based, consisting primarily of CnH2n+2 hydrocarbons, with n =6 to 16, so the carbon:hydrogen ratio is close to 1:2. During this flight, how much CO2 was released into the atmosphere? Assume the combustion of the fuel was complete, so all the fuel was burned to form CO2 and H2O. Give both the mass of CO2 produced (in kg and in lbs) and the volume it would occupy at 298 K, 1 atm.(b) How much CO2 would be released into the atmosphere if those passengers and crew made the trip instead, in pairs, in hybrid cars at 40 miles per gallon. Assume the density of the gasoline is 0.75 kg L-1 and that carbon and hydrogen dominate the composition in a ratio of 1:2. The road trip is 1082 miles.
Triglycerides are composed of three fatty acids bonded to a glycerol backbone. Explore the structures and properties of triglycerides. The carbon-carbon double bonds of triglycerides will react with hydrogen gas in the presence of a metal catalyst such as Pt. This process will convert the unsaturated triglycerides to saturated triglycerides. What quantity in moles of H, gas would be required to convert this triglyceride to a fully saturated triglyceride? O O Question 19.c of 21 Fo Fo Fo 1 4 7 +/- 2 5 8 moles 3 6 9 0 Submit X с x 100 +
Oral rehydration salts are stated to contain the following components: Sodium Chloride 3.5g Potassium Chloride 1.5g Sodium Citrate 2.9g Anhydrous Glucose 20.0g 8.342 g of oral rehydration salts are dissolved in 500 ml of water. 5 ml of the solution is diluted to 100 ml and then 5 ml is taken from the diluted sample and is diluted to 100 ml. The sodium content of the sample is then determined by flame photometry. The sodium salts used to prepare the mixture were: Trisodium citrate hydrate (C6H5Na3O7, 2H2O) MW 294.1 and sodium chloride (NaCl) NW 58.5. Atomic weight of Na = 23. The content of Na in the diluted sample was determined to be 0.3210 mg/100 ml. Determine the % of stated content of Na in the sample.
Oral rehydration salts are stated to contain the following components: Sodium Chloride 3.5g Potassium Chloride 1.5g Sodium Citrate 2.9g Anhydrous Glucose 20.0g 8.342 g of oral rehydration salts are dissolved in 500 ml of water. 5 ml of the solution is diluted to 100 ml and then 5 ml is taken from the diluted sample and is diluted to 100 ml. The sodium content of the sample is then determined by flame photometry. The sodium salts used to prepare the mixture were: Trisodium citrate hydrate (C6H5Na3O7, 2H2O) MW 294.1 and sodium chloride (NaCl) NW 58.5. Atomic weight of Na = 23. The content of Na in the diluted sample was determined to be 0.3210 mg/100 ml. Determine the % of stated content of Na in the sample. The stated should be 104.5, how??
Dissolve 0.25g NaClI, 0.20g NaHCO3. 0.35g KCI, and 1.5g of glucose in 100 ml distilled water using a 250 mL capacity beaker. Use the formula to create a 60 mL ORS. Based on the given procedure, calculate the total amount of glucose in the prepared solution. (MW: Na: 23, K: 39, CI: 35, H: 1, C: 12, 0: 16) O 83.33 mmol/L 66.91 mmol/L 90.40 mmol/L 71.11 mmol/L O 23.81 mmol/L O 47.30 mmol/L
COMPLETE THE STATEMENT: 1. Before manufacturing process begins the sources of suitable fragrances are ______ in the manufacturing centre. 2. Oils are ______ from plants and other substances by several methods 3. During ________, flowers are spread on glass sheets coated with grease. 4. _________is the oldest and least complex method of extraction. 5. During Aging, the_____ tests whether the perfume has the specific smell or not.
ENUMERATE 5 EXAMPLES FOR FEMALE CONTRACEPTIVES. DESCRIBE THE CONTRACEPTIVE/S ON HOW IT IS BEING USED/FUNCTIONS.
A sample containing chlorophenol, C6H4ClOH, was analysed by gravimetric analysis. A 0.783-g of this sample goes through a chemical process allowing the chlorine in the chlorophenol to precipitate as silver chloride, weighing 0.271 g. Calculate the % (wt/wt) of the chlorophenol in the sample, assuming that chlorophenol is the only source of chlorine in the sample. Provide your answer to two decimal places and without units. Avoid using scientific notation.