1) Write the mesh equations and solve for the currents I1 and I2. 22 www. 10V 42 I 652 2V I2 41₁ + 6(1₁-1₂) = 10-2 6(121₁) +21₂ + 71₂ = 2 + 20 7Q 20V

Q: . When SW2 is closed, the motor will spin and D1 will light. The current through 1.______ will flow…

A:

Q: In a 10-trunk circuit, there are 180 calls in one hour. The average holding time per call is 2…

A: Given: In a 10-trunk circuit, there are 180 calls in one hour. The average holding time per call is…

Q: for the Chavacterstic fad ealuation shown Value of below for the the RH Which Yemain stable using…

A: for the characteristic equation shown above find the value of k for which the system remain stable…

Q: The train never late. It always . . at .time leave / leaves left is leaving

A: The answer as given below:

Q: The concept of the state of a dynamic system refer to a .maximum set of variables The root locus is…

A:

Q: formula for admittance and draw the current triangle and admittance triangle for parallel RL…

A: formula for admittance and draw the current triangle and admittance triangle for parallel RL circuit

Q: ith schematic diagram, explain the Wind Power Plant

A: Power station: A power station, often known as a power plant and also referred to as a generating…

Q: AMoving to another question will save this response. uestion 8 Which of the following is the phase…

A: In this question we need to choose a correct option.

Q: Remaining Time: 53 minutes, 27 seconds +Ouestion Completion Status: A Moving to another question…

A: Given  In capacitive load ,the load angle

Q: What is the approximate value of surge impedance of a power cable ? 400 100 40 1600 A Moving to…

A: Surge impedance is defined as the square root of ratio of line impedance Z and shunt admittance Y is…

Q: Define the unit step function and the shifted unit step function. Need

A: The unit step function and its shifted counterpart has been defied in the following section.

Q: Define the unit step function and the shifted unit step function. Need correct solution within 20…

A: The unit step function and the shifted unit step function have been defined in the following…

Q: How does voltage divide in a series circuit?

A: As per our guidelines, we are supposed to answer only one question. Kindly repost other questions as…

Q: 10 N 10 A 10 V mA All will show 10A 1A, 500mA and 500ma All will indicate 1A O All will show 1000mA…

A: Current indicated by milliammeters A,B and C will show same current as they are connected in series…

Q: (a) What is the average system utilization? (b) What is the average number of customers in the…

A: In the question following data is given. The average number of customers arriving per hourλ=12…

Q: What is the dimensioning system shown in the figure below? +1.31 67 .31 .51

A:

Q: differentiate between overhead service connection and under ground service connection with sketch

A: Overhead Service Connection:- Electric locomotives, trolleybuses, and trams receive their electrical…

Q: Two identical (in terms of voltage and power ratings) transformers A & B are designed to ru at…

A: In this question,  We need to choose the correct option We know Weight of the transformer is…

Q: Please answer in typing format and don't be AI solution either i will dislike

A: When you're measuring power in a three-phase system, the phase sequence matters because it affects…

Q: b. Ground-fault protection c. Service-entrance conductors d. Branch circuits

A: Given: The answer is shown below:

Q: True or False: We can use BLOG term in 66 blocks to remember the wire order, and remember to start…

A:

Q: 5. Will the lamp become bright or dim or stay the same when we move the brush to the right? Why Will…

A:

Q: For measurement instrument, the crucial -1 static characteristic is resolution аccuracy sensitivity

A: Since there are multiple questions uploaded within the same question, therefore solving the first…

Q: In type of system,the input and output have direct connection in between. O a. Closed loop O b. Open…

A:

Q: Due to the effect of the resistance of the cable connected to RTD, two-wire cables up to ……. meters…

A: c) 50-195

Q: Define the unit step function and the shifted unit step function. Need

A: The solution is provided in the following section.

Q: 1) What happens if we connect current coil of wattmeter in parallel with load? 2) Why we say…

A: Methods of power Measurement Three ammeter method Three voltmeter method Wattmeter method....etc…

Q: Problem 1 is a review of your understanding of KVL (Kirchhoff's voltage law) Using KVL find the…

A: A simple question based on network analysis and the topics described in the solution are kirchoff's…

Q: Draw a schematic diagram for closed circuit

A: In this question , we will draw a schematic diagram for closed circuit....

Q: Deviations in quality of service include power irregularities. Which irregularity occurs when…

A: This problem is from power system.  The solution is given below.

Q: What type of order is given by a governing agency that finds a violation of the Electrical Code…

A: Electric Code rules:- A building's electrical wiring must adhere to a set of rules known as the…

Q: In a 10-trunk circuit, there are 180 calls in one hour. The average holding time per call is 2…

A: Given: In a 10-trunk circuit, there are 180 calls in one hour. The average holding time per call is…

Q: Using Multisim please

A: The objective of this question is to design a traffic control system for a four-way intersection…

Q: In standard architectural site plan symbols, a fire hydrant is indicated by a/an _. A. Dark -field…

A: In this question we need to choose a correct option.

Q: which side is short cct.in short cct. test ? why?

A: Short circuit test: It is one of the method to calculate the series parameters of the transformer's…

Q: Which of the following-combinations cannot be combined into K-map groups?   A. corners in the same…

A:

Q: What is the result of right shifting A1B3  four times?

A: Right shifting is done by using the register of the serial in serial out type register:

Q: draw sequence diagram for circuit-breaker example

A: The circuit breaker is a device that can make or break the circuit during the fault. The above…

KVL and KCL

KVL stands for Kirchhoff voltage law. KVL states that the total voltage drops around the loop in any closed electric circuit is equal to the sum of total voltage drop in the same closed loop.

Sign Convention

Science and technology incorporate some ideas and techniques of their own to understand a system skilfully and easily. These techniques are called conventions. For example: Sign conventions of mirrors are used to understand the phenomenon of reflection and refraction in an easier way.