1: When a force of 2 lb is applied to the handles of the brad squeezer, it pulls in the smooth rod AB. Determine the force P exerted on each of the smooth brads at C and D. (Note that P is not an external force applied to this system, it is shown in the figure to show you where force Pis acting within the system (between the thin rods and the wood block.)

Q: 2. For the frame shown, calculate the reactions at A and B. 240 lb 90 Ib/ft 30 Ib/ft A 20 ft 20 ft…

A:

Q: Determine the horizontal and vertical component of the force of the pin joint at F (kN)? Determine…

A:

Q: m The hoist supports an engine Determine magnitude of the force created by the engine mass

A: tanθ1=a+ba-btanθ1=2.2+1.12.2-1.1θ1=71.56o∑Fv=0RA+RB-mg=0RA+RB=mgRA+RB=175×9.81RA+RB=1716.75 N ,…

Q: 2. The 30 cm handle is connected rigidly to the 5cm bar at a right angle. Determine the force…

A: The force applied to the handle is, P=100 N Length of the handle is, L=30 cm

Q: P2: The 50-lb rectangular access door is held in the 90° open position by the single prop CD.…

A: Given:Mass = 50 lbAngle = 90 0

Q: A beam with a length of 2 m and a mass of 10 kg supports a 50 kg box. The beam is connected to a…

A: Given: The length of the beam is, l=2 m The mass os the beam is, W=10 kg×9.81 ms2=98.1 N The mass…

Q: Required information NOTE: This is a multi-part question. Once an answer is submitted, you will be…

A:

Q: Boom OAB is supported by a ball and socket at point O and two cables AC and AD. Determine the forces…

A:

Q: Problem 3. Determine the vertical clamping force at E in terms of the force F applied at the handle.…

A:

Q: The following system is in static equilibrium with the strings AB, BC, and CD connected to suppor…

A: Given data:

Q: 4.10 Calculate the horizontal force F that should be applied to the 100 lb weight shown so that the…

A: Given: W= 100 lb To find: The horizontal force F that should be applied to the 100 lb weight shown…

Axial Load

When a bar of the uniform cross-section is acted by a load, such that the load acts along the longitudinal axis of the bar, such kinds of loadings are known as axial loadings. In general terms, a load is an external force acting on a component. An axial load acts perpendicular to the geometric cross-section of the component. Based on the direction of the application of the load, an axial load can be tensile or compressive. The analysis of bodies under the action of axial loads is generally studied under the branch of mechanics, known as statics.