1- STOP sign in the intersection is placed on STOP sign in the intersection is placed on A. Left approach B. Right approach C. All Approaches O D. No,1 and 2 2- Grade separated intersections * A. All roadways join or cross at the same vertical level. B. Allows the traffic to cross at different horizontal levels. C. These type of intersection decrease the road capacity. D. Non of those

1- STOP sign in the intersection is placed on STOP sign in the intersection is placed on A. Left approach B. Right approach C. All Approaches O D. No,1 and 2 2- Grade separated intersections * A. All roadways join or cross at the same vertical level. B. Allows the traffic to cross at different horizontal levels. C. These type of intersection decrease the road capacity. D. Non of those

Structural Analysis

6th Edition

ISBN:9781337630931

Author:KASSIMALI, Aslam.

Publisher:KASSIMALI, Aslam.

Chapter2: Loads On Structures

Section: Chapter Questions

Problem 1P

See similar textbooks

Similar questions

Before entering a modern roundabout, the approaching vehicles should always ..... а. yield to the vehicles from the right O b. yield to the circulation flow O C. proceed without stopping d. stop
Hi! help me with this please. Correct answer and solution. Thank you! The two intersecting streets are to be connected by a 6o.simple curve. The centerline of the curve is to be located such that the midpoint is 10.2m from the point of intersection. Compute the central angle of the curve.
Q3. A new section of a freeway is to be designed with a free-flow-speed of 65 mph along of 0.75 mile on 5% upgrade. The expected traffic volume is 4200 v/hr. The traffic composition is 15% trucks, 5% recreational vehicles, and 10% buses. The peak hourly factor is 0.9, the unfamiliar driver factor is 0.95. If the design requirement is to target a level of service (B). how many lanes must be provided to satisfy the design requirement?
A six-lane freeway (three lanes in each direction) in rolling terrain has 10-ft lanes and obstructions (fLw = 6.0 mph) 4 ft from the right edge of the traveled pavement (fic = 0.8 mph). There are five ramps within three miles upstream of the segment midpoint and four ramps within three miles downstream of the segment midpoint. A directional peak-hour volume of 2000 vehicles (primarily commuters) is observed, with 600 vehicles arriving in the highest 15-min flow rate period. The traffic stream contains 12% large trucks (ET = 2.5) and buses and 6% recreational vehicles (ER = 2.0). 1.) What is the estimated free-flow speed of the traffic stream in mph (whole number, nearest 5)? 2.) What is the peak-hour factor 3.) What is the heavy-vehicle adjustment factor? 4.) What is the service flow rate? 5.) What is the service measure value if the average speed of the traffic stream is 65 mph
A multi-lane Minor Arterial is being designed through a level urban area. The current daily volume = 8000 vpd in both directions with 10% Trucks, peak hourly factor 90%and a 60% directional distribution factor. How many lanes are required?
An eight-lane freeway (four lanes in each direction) is on rolling terrain and has 11-ft lanes with a 4- ft right-side shoulder. The total ramp density is 1.5 ramps per mile. The directional peak-hour traffic volume is 5400 vehicles with 11% heavy vehicles. The peak 15-minute volume is 1421 vehicles. What are the freeway’s density and level of service
How many diverging conflicts are present at a 4-leg intersection where each leg is a single lane approach, as shown above? Response Feedback: NBTH with NBLT, NBTH with NBRT EBTH with EBLT, EBTH with EBRT SBTH with SBLT, SBTH with SBRT WBTH with WBLT, WBTH with WBRT
A six-lane urban freeway (three lanes in each direction) is on rolling terrain with 11-ft lanes, obstructions 2 ft from the right edge of the traveled pavement, and nine ramps within three miles upstream and three miles downstream of the midpoint of the analysis segment. The traffic stream consists primarily of commuters. A directional weekday peak-hour volume of 2300 vehicles is observed, with 700 vehicles arriving in the most congested 15-min period. If the traffic stream has 15% large trucks and buses and no recreational vehicles and at some point, further along the roadway there is a 6% upgrade that is 1.5 mi long. (assuming that the proportion of vehicle types and the peak-hour factor remain constant) Determine the FFS value in mi/hDetermine the PHF or Peak Hour FactorDetermine the fHVDetermine the value of vp
A four-lane freeway (two lanes in each direction) is located on rolling terrain and has 12-ft lanes, no lateral obstructions within 6 ft of the pavement edges, and there are two ramps within three miles upstream of the segment midpoint and three ramps within three miles downstream of the segment midpoint. The traffic stream consists of cars, buses, and large trucks (no recreational vehicles). A weekday directional peak-hour volume of 1800 vehicles (familiar users) is observed, with 700 arriving in the most congested 15-min period. If a level of service no worse than C is desired, a.) Determine the Freeflow Speed
A major roadway with a speed limit of 35 mi/h has an intersection that has no intersection control with a minor roadway at a right angle. A building is located next to the intersection at a distance of 50 ft from the center of the near lane on the major roadway and 40 ft from the center of the near lane on the minor roadway. At what speed for the minor roadway is the intersection safe? Grades are approximately level.
A six-lane freeway (three lanes in each direction) has regular weekday users and currently operates at maximum LOS C conditions. The lanes are 3.3 m wide, the right-side shoulder is 1.2 m wide, and there are five ramps within five kilometers upstream of the segment midpoint and3 ramps within five kilometers downstream of the segment midpoint. The highway is on rolling terrain with 10% large trucks and buses (no recreational vehicles), and the peak-hour factor is 0.90. Determine 15-min volume within hour of analysis for these conditions. Hint: Use LOS Criteria for Basic Freeway Segments
A new section of Richmond Highway is being designed as a six-lane facility (three in each direction) with a two-way left-turn lane. Traffic data include directional design hourly volume = 3600 veh/h, PHF = 0.94, assumed base free-flow speed = 55 mi/h (88 km/h). Geometric data include: urban setting, rolling terrain, lane width = 11 ft (3.3 m), shoulder widths = 4 ft (1.2 m) (right side) and 1 ft (0.3 m) (left side), and average access point spacing = 12 points per mile on each side.