1) In horizontal pipe, a 90° elbow is used to carry the water flowing in upward direction. The mass flow rate of the water is 30 kg/s. The elbow discharges water to the atmosphere. The pressure at the outlet is equivalent to the atmospheric pressure. The diameter of the entire elbow is 20 cm. The gage pressure at the center of the inlet of the elbow is 3.5 kPa. Determine the anchoring force needed to hold the elbow in place. Use the value of momentum flux correction factor as 1.10. ..

Q: Q2 // The diameter of a pipe at section 1 and 2 are 10 cm and 15 cm respectively. Given velocity of…

A: Given that, The diameter of the pipe at section 1 D1 = 10 cm = 0.1 m The diameter of the pipe at…

Q: Determine diameter of galvanized pipe needed to make the water flow along 180m with flow rate 85L/s…

A: Given data: Length of pipe = 180 m Volumetric flow rate = 85 L/s Head loss = 9 m Kinematic viscosity…

Q: continuous flow sedimentation tank is 3.5 m deep and 65 m long. The flow velocity observed is 1.22…

A: Given data: Depth of sedimentation tank = 3.5 m Length of sedimentation tank = 65 m Velocity of flow…

Q: The velocity distribution for laminar flow between parallel plates is given by 2 Umax h where h is…

A:

Q: 1. An oil having a density of 1200 kg m3 and a viscosity of 0.02 Pa s flows through a 25 mm diameter…

A: It is to be mentioned whether the flow of oil is laminar or turbulent.

Q: The U tube shown is rotated about the left vertical leg at 30 rpm. The pressure at point A is…

A:

Q: For a parallel plate arrangement, it is found that when the distance between the plates is 2 mm, a…

A:

Q: Q3- Calculate the thickness of the boundary layer at a distance of 75 mm from the leading edge of a…

A: velocity of water = 3 m/s.Also flow in the boundary layer is streamline

Q: 3. A fine (thin) ring with a radius 50 mm is being pulled from the surface of water. If the ring has…

A: