1 Give the azimuths of the lines AB, BC, CD, and DA shown in Figure P7-1. North is zero.

Q: List the four distinct kinds of drawings according to their projection methodologies.

A:

Q: 6. Using the equation of the magnetic field due to a single ring of charge, derive the formula for…

A: Step 1: Step 2: Step 3:don't forget to upvote :) thank you and comment if doubt exists Step 4:

Q: Draw the top, the front, and the right side orthographic views of the objects shown. Indicate when…

A: Top , front and side views of the given object can be drawn as

Q: Given the isometric view of the cut block objects shown, use rectangular grid paper to sketch a…

A:

Q: structural drawing   please indicate a details in this image

A: The structural diagram is shown in the above figure. We have to indicate a details in this image.

Q: There are a couple errors in the multi-view drawings below (the isometric is accurate and assume any…

A:

Q: Draw the multiview projection of the given isometric figure. L HRP FRP L 1. Discuss how did you draw…

A:

Q: SKETCH AUXILIARY VIEW. SHOW ALL VISIBLE AND HIDDEN LINES.

A: An auxiliary view is simply known as the “helper” view because it shows the slanted part of the…

Q: Civil Engineering Using the drawing board, draw the following views in 3rd angle projection: a) An…

A: Hi! Thank you for the question As per the honor code, We’ll answer the first question since the…

Q: SUBJECT: CIVIL DETAILS: ISOMETRIC DRAWING.

A:

Q: (D) -

A: A sectional view in engineering drawing is a representation of an object as if it were cut by an…

Q: show

A: angle = 188°59'30''

Q: Instructions: Redraw the objects in isometric orloblique views. Also, draw the three basic…

A:

Coordinate Geometry of Survey

Coordinate geometry (COGO) is a method of inserting surveying or engineering data into geographic information system (GIS), computer-aided design (CAD), or mapping software. These data can be collected on the proposed construction site using standard surveying techniques and instrumentation or may be taken from existing maps, engineering plans, drawings, or records. Data gathered on the site includes coordinates of points, bearings, and distances between points. The data are noticed and noted through conventional surveying procedures, like a traverse or layout measurement series and it can be either digital or non-digital. The maps and plans are inclusive of boundaries, divisions, and other components, and these features are shown with coordinate values, the lengths, offset distance, and bearings between them.