1) For a steady flow process, the total mass flow rate entering a control volume equals to total mass flow rate leaving. True or False 2) Mass is a conserved property. It cannot be created or destroyed during a process. It cannot cross the boundaries. True or False 3) A device has one inlet and one outlet. If the volume flow rate at inlet and outlet are the same, the flow through this device should be steady. True or False

Q: An isobaric process is a polytropic process. True or false

A:

Q: Patm=101kPa; g=9.81m/s² A substance is contained in a piston cylinder assembly with properties as…

A:

Q: Select the expression representing the flow work (flow energy), where P is pressure, Vol is volume,…

A: Given p is pressure, vol Is  volume, and  V is the velocity,  Option A is the correct answer

Q: I need handwritten solution. Please don't use chatgpt. Thermodynamics.

A: Step 1:Step 2:

Q: After the completion of the activity one you have been asked to run the test to measure the…

A: Given At Inlet At outlet P1=1bar P2=7bar C1=6.3m/s C2=5m/s V1=0.98m3 V2=0.18m3 m=0.4kg/s…

Q: 6) a) What is the definition of heat capacity (variable C) ? b) Without reforencing any equations…

A: Let C=Heat Capacity Heat Capacity is the heat required to raise the temperature of a body by one…

Q: I need proper explanation previous one was not good. 1) Evaluate whether the following statement is…

A:

Q: (Thermodynamics)(True or False) The equation PVγ=constant, where γ=cₚ/cᵥ, is valid for any adiabatic…

A:

Q: A closed system undergoes a thermodynamic cycle with 2 steps: process 1-2 (from state 1 to state 2),…

A:

Q: Select the flow work (energy) of a flowing fluid below, where Vis velocity and Vol is total volume..…

A:

Q: ows through an air duct which expands in the flow direction then which of the following statements…

A: Option (b) is correct.

Q: In the compressed liquid region, the specific enthalpy is estimated by h = U₁ + Pv₁, where u, and v₁…

A: To check: Whether the statement is true or false. Concept used: Compressed liquid region. A fluid is…

Q: Flow measurement is the measurement of the volume or mass of material that passes a given point…

A: Flow measurement can done using the instruments like Venturimeter, Orficemeter, Flow nozzle, Elbow…

Q: 1. The heat supplied to the system equals increase in the internal energy.  Select one: True False…

A:

Q: 9. Describe the relevance of degree of saturation. Please select all answers that apply: a) The…

A: ANSWER (9) = OPTION D,E Degree of saturation The degree of saturation denotes the actual…

Q: Water vapor enters a throttling valve at 1 atm. An engineer reports that thermometers located at the…

A: If the inlet temperature of gas before throttling  is less than the inversion temperature, then the…