Assignment1-Determine the width of a carbon resistor having a sheet resistance of 15 0 fN if the length is 1/2 in. and theresistance is 500 2.2-Find the conductance of each of the following resistances:120 Aa.b. 4kn2.2 MAc.d. Compare the three results.3- If an electric heater draws 9.5 A when connected to a 120 V supply, what is the internal resistance of the heater?4- In a TV camera, a current of 2.4 mA passes through a resistor of 3.3 MA. What does the voltage drop across theresistor?5. For the network in Fig.a. Determine I, and V.b. Determine I, if R̟ is shorted out.c. Determine V, if R is replaced by an open circuit.100 NE 12 VRL10 kn VLFIG.6. For the network in Fig.a. Determine the open-circuit voltage Vb. If the 2.2 kN resistor is short circuited, what is the newvalue of V,?c. Determine Vị if the 4.7 kl resistor is replaced by anopen circuit.2.2 kn3.3 kn34.7 kn9 VVLFIG.7. For the network in figurea. the short-circuit currents I, and I.b. the voltages V, and V2.c. the source current I,.determine

As per the guidelines, we supposed to answer one question at a time so please ask other questions…

Answered: 1- Determine the width of a carbon…

1- Determine the width of a carbon resistor having a sheet resistance of 15 0 1 if the length is 1/2 in. and the resistance is 500 N.

Introductory Circuit Analysis (13th Edition)

13th Edition

ISBN:9780133923605

Author:Robert L. Boylestad

Publisher:Robert L. Boylestad

Chapter1: Introduction

Section: Chapter Questions

Problem 1P: Visit your local library (at school or home) and describe the extent to which it provides literature...

See similar textbooks

Related questions

Q: Problem 5. Calculate the cross-sectional area, in mm², of a piece of copper wire, 40 m in length and…

Q: Determine the Norton equivalent current IN and resistance RN across terminals a – b. - 0.01v, R V…

Q: The figure4 shows the relation between resistance and temperature for the thermistor.…

Q: A silver wire has a resistance of 2.1 22 at 27.5 °C, and a resistance of 2.7 22 at 100 °C. Determine…

Q: What is the resistance of this 5-Band resistor ( in Ohms)?

Q: If V1 = 18 V, V2 = -9 V, R1 = 1.2 kOhm, R2 = 4.7 kOhm, R3 = 2.4 kOhm, and all V. diodes are silicon…

A: The solution is given below

Q: 7. A certain cooper wire has a resistance of 25 ohms at 10°C. Take the temperature coefficient at…

A: This question belongs to electrical circuit theory. It is based on the concept of relation between…

Q: What will be the change in resistance produced if the gauge is subjected to a strain of 0.002 ,the…

A: We know that Gf or guage factor=stress/strain stress=∆R/R Strain=0.002 Rg=250 ohms Gf=2.4 To find:…

Q: The resistance of a copper wire is (0.92 0) at a temperature of (4 oC). At what temperature will be…

Q: Resistivity of a wire depends on length material O all of the above. O O O

A: Resistivity of the wire calculated as : R=ρlAwhere,ρ = resistivityL = LengthA= area

Q: The resistance of a 125 2 strain gauge changes by 1 ohm for 4000 micro strain. The gauge factor is…

A: Given: The resistance, R=125 Ω. Change in resistance, ∆R=1 Ω. Strain, ε=4000×10-6.

Q: Determine the resistance of a copper wire that has a cross-sectional area as 8.4 mm2. The length and…

A: Resistance of the wire R? Cross sectional area A= 8.4 mm2 Wire length l= 78.6m Resistivity =…

Q: Current in a semiconductor is generated as follows: Please choose one: a. only holes b. electrons…

A: Semiconductor offers conductivity in between insulators and metals.

Q: A string insulator has 6 units. The voltage across the bottom most until is 20% of the total…

Q: 1. What is the resistance of a copper conductor at 68 °C if its resistance at 20 °C is 6.160?

A: as per our company guidelines we are supposed to answer only first one question. Kindly repost other…

Q: The resistance of a copper wire is (0.92 N) at a temperature of (4 oC). At what temperature will be…

A: The resistance.and temperature dependence of the metals is explored and hence the temperature at…

Q: c) Two of you have been given two instruments with the units in ohms, your colleague measures the…

Q: The resistance of a 5 m length of wire is 600 ohm. Determine the resistance of an 8 m length of the…

Q: Problem 1 10 K D3 The diodes in the circuit are Silicon with forward voltage of 0.7 V. Fill up the…

A: Brief description: In the above question they want to know the value of current and voltages across…

Q: What is the current through the Zener diode when a) R2= 1kQ and b) R2= 0.5 kQ ? Zener diode voltage…

A: a) R2 =1 Ohm The diagram can be modified as from the diagram the voltage Vz can be found by…

Q: In the figure the ideal batteries have emfs &₁ - 18.4 V, E2 = 9.96 V, and 3 = 4.70 V, and the…

Q: The length and diameter of copper wire are found to be 100 and 0.002 m respectively consider that…

Q: The diodes in the circuit given below are identical and each one is ideal. Accordingly, determine…

A: For first circuit shown below:

Q: ,12 B.

Q: Problem 5. Calculate the cross-sectional area, in mm², of a piece of copper wire, 40 m in length and…

A: it is asked to find the cross sectional area of given copper wire in mm2

Q: A copper wire has a temperature coef of resistivity of 0.0054 degree c-1.Whe placed in a water bath…

A: In this question we will find resistance of copper wire at given temperature.....

Q: When a pure semiconductor is heated, it's resistance: a) goes down. B)changing every time. C) goes…

A: In this answer let us try to understand what happens to the resistance of a semi conductor when it…

Q: 1. Assuming that the diodes in Figure 1 are constant voltage-drop diodes with a voltage drop of…

A: A diode is a two-terminal semiconductor device that allows current to flow in only one direction…

Q: Assuming constant temperature, what happens to the resistance of a material when the cross-sectional…

A: Cross sectional area- The cross sectional area is the area of a circle. Thus the cross section of…

Q: compute for the conductance of the following parallel resistances,…

A: In this question, compute for the conductance of the following parallel resistances, R1=10kohm,…

Q: A bank of nickel-cadmium cells is used as the emergency lighting supply for a hospital. There are…

A: When batteries or cells are connected in series, their voltages add and their current capacities…

Q: temperature

A: In this question , effect of temperature on resistance is given...We have to find out resistance of…

Q: explain ohms law in terms of resistance

A: Describe the ohms law in terms of resistance?

Q: The diodes in the circuit are all Silicon with forward voltage of 0.7 V. If R1 = 14N and R2 = 140,…

A: Given circuit

Q: A PMMC ammeter has intern resistance 120 2 and required current for full scale is 1.2 mA. E-5v. the…

A: The circuit daigram is shown below, Where,Rm=120 ΩIfull=1.2 mAE=5 VRx=800 Ω

Q: germanium A compensated semiconductor at T = 300 K is doped with N₂ = 2 X 1012 cm-³ and N = 8 X 1013…

A: According to the question, we need to calculate the thermal equilibrium electron and hole…

Concept explainers

Electrical Heating Unit

The conversion of electrical energy to heat energy is known as electric heating. The heating system that converts the electrical energy to heat energy for various application is called electrical heating unit. Electricity is employed as the firing mechanism in electric heating systems, which transforms electric current to heat. Electric heaters have heating elements in the form of electric resistors.

Question

Assignment
1-
Determine the width of a carbon resistor having a sheet resistance of 15 0 fN if the length is 1/2 in. and the
resistance is 500 2.
2-
Find the conductance of each of the following resistances:
120 A
a.
b. 4kn
2.2 MA
c.
d. Compare the three results.
3- If an electric heater draws 9.5 A when connected to a 120 V supply, what is the internal resistance of the heater?
4- In a TV camera, a current of 2.4 mA passes through a resistor of 3.3 MA. What does the voltage drop across the
resistor?
5. For the network in Fig.
a. Determine I, and V.
b. Determine I, if R̟ is shorted out.
c. Determine V, if R is replaced by an open circuit.
100 N
E 12 V
RL
10 kn VL
FIG.
6. For the network in Fig.
a. Determine the open-circuit voltage V
b. If the 2.2 kN resistor is short circuited, what is the new
value of V,?
c. Determine Vị if the 4.7 kl resistor is replaced by an
open circuit.
2.2 kn
3.3 kn
34.7 kn
9 V
VL
FIG.
7. For the network in figure
a. the short-circuit currents I, and I.
b. the voltages V, and V2.
c. the source current I,.
determine

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

This is a popular solution!

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Trending now

This is a popular solution!

Step by step

Solved in 2 steps with 1 images

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, electrical-engineering and related others by exploring similar questions and additional content below.

Similar questions

If the strain-gauge material is thick film resistor with a gauge-factor of 100 and an initial resistance of 500 Ohm. What is the new resistance of each strain-gauge if the strain is 0.2%. Assume a passion ratio of 0.3.
Total charge is 750 microcoulomb . Determine values of V1 , V , and C2 .
PROBLEMS 1. A four-band resistor has a tolerance +5% and has a maximum resistance of 4.2 MO. Determine the minimum resistance, the resistor rating, and the resistor color code.
A wire has a resistance of 12 N. It is bent in the form of a circle. The effective resistance between the two points on any diameter of the circle is
5) a) An AA sized alkaline-manganese battery has a Thévenin voltage of 1.5V and an internal resistance of 0.40. What is the largest current that can be drawn from it if the terminal voltage is not to drop below 1V? b)How much power can the battery in part a deliver to a load of resistance R? What value of resistance R gives the largest power delivered to the load? What is that power?
With 100-V applied across each ten 50-ohm resistances in parallel, the current though each resistance equals
C) The figure4 shows the relation between resistance and temperature for the thermistor. What is the value of resistance approximately at 70°C? What happens to the resistance value as the temperature increases? 3. Is it PTC or NTC thermistor? Justify your answer.
For the diodes on the below, calculate the currents I1, I2 and I3 using the modified diode model (non-ideal, VD = 0.7V).
There is a steel guide bar (According to figure), knowing that its conductivity is 7x106 (ohm - m)-1 . Determine the resistance at 45 ° C and the gauge of a copper wire for its connection.
Calculate the equivalent resistances Rin of the following circuits. (The resistance value of the diodes in the conduction will be 0, the resistance value of the diodes in the insulation will be taken as infinity. R1=10ohm