1) Determine the support reactions and draw the bending moment and shear diagram of the becima shown in the figure. Also deterimin. the poin't De maximum sneck and mini banding momann their values (a)=400 16/47 A 7 18+ 24FF 3

Q: Assignment 3 Question one Consider the following diagram of the elbow joint. The angle of pull of…

A: Given DataFB=100Nθ=30°ϕ=10°

Q: If P = 290 N, determine the required minimum compression in the spring so that the wedge will not…

A: Write the given data with the suitable variables. μ=0.35P=290 Nk=15 kN/m   It is required to…

Q: Ql: For the simply supported beam shown below, calculate the maximum stresses in the steel and wood…

A: To calculate the N.A. of the section:

Q: An extruded polymer beam is subjected to a bending moment M. The length of the beam is L= 800 mm.…

A: Answer: The largest moment M that can be applied to the beam is 494.6 N•m.

Q: (a) Determine the reaction forces at connections A and B. (b) Draw the shear force and bending…

A:

Q: An "I"-shape beam is subjected to bending. The loading condition and the dimension of its…

A:

Q: A rectangular element as shown in the figure is used to represent a pure bending problem. Due to the…

A:

Q: Applying the flexure formula, how can we determine the position of the absolute maximum bending…

A: The flexure formula is used to calculate the normal stress in the beam due to bending moment applied…

Q: A simply supported beam of length L = 1 m (A = hinged support, B = Roller support) is shown above…

A: Given data :- L = 1 m                         a = 0.4 m                         P = 1.7 kN (A) By…

Q: 2. For the 20 meter beam shown, there is a roller at "A" (Ay = 52 kN; it is acting upward), and a…

A: For the 20 meter beam shown, there is a roller at "A" (Ay= 52 KN; it is acting upward), and a pin…

Q: hogging or sagging

A: if beam become as hogging then it's value taken with negative signand if it's form sagging then take…

Q: For a steel circular cantilever beam, 10mm in diameter, 700mm in length with an applied load of…

A: M= (3/4 My + 1/3 Mp)My = 24543.5 N.mmMp = 41666.66667 N.mmYield strength= 250 MPad = 10 mmy = d/2F =…

Q: The beam shown below is subjected to a point load of 10kN and a uniformly distributed load of 3kN/m,…

A:

Q: Find the max shear stress in a 200mm tall, 150mm wide rectangular cross section using the…

A:

Q: An extruded polymer beam is subjected to a bending moment M. The length of the beam is L = 600 mm.…

A:

Q: Find the shear force and bending moment at points C and D. 60 lb/ft 10 ft- -15 ft- 40 lb/ft B D -5…

A:

Slope and Deflection

The slope in a deflected beam is described as an angle in radians made by the tangent of the section with the original axis of the beam. The deflection at any point on the axis of the beam is defined as the lateral displacement of the point before and after loading.