1) Determine the height of chimney required in a boiler having natural draught equivalent to 25 mm of water. The flue gases are at temperature of 600K , atmospheric air temperature is 25 C and 15 kg air per kg of fuel is required in boiler.

1) Determine the height of chimney required in a boiler having natural draught equivalent to 25 mm of water. The flue gases are at temperature of 600K , atmospheric air temperature is 25 C and 15 kg air per kg of fuel is required in boiler.

Refrigeration and Air Conditioning Technology (MindTap Course List)

8th Edition

ISBN:9781305578296

Author:John Tomczyk, Eugene Silberstein, Bill Whitman, Bill Johnson

Publisher:John Tomczyk, Eugene Silberstein, Bill Whitman, Bill Johnson

Chapter47: High-pressure, Low-pressure, And Absorption Chilled-water Systems

Section: Chapter Questions

Problem 18RQ: In an absorption chiller, _______is used to create the difference in pressures.

See similar textbooks

Related questions

Q: H,O) H,O(v) BOILER 25°C 250°C, 17 bar AIR PREHEATER Flue gas Flue gas 450 kmol CH,/h 300°C 150°C…

A: In this type of combustion furnace, a new mixture of air is taken for each cycle. The first step…

Q: determine optimum velocity of steam

A: Given; For a single stage impulse turbine with; rotor diameter,d =2 mSpeed,N=3000 rpmNozzle angle…

Q: A water tube boiler has a heating Surface area of 500 m². For a developed boiler hp of 825.…

Q: Using PV & TS Diagrams derive the formulae of a. Temperature, Pressure & Volume c. Change of…

Q: 1. A cylindrical air compressor tank with an inside diameter of 600 mm has a safe working pressure…

A: Given data Diameter= 600mm Pressure= 1 MPa Tensile stress = 75 MPa Find the thickness of the wall…

Q: Initial and operating cost is high for fixed floating gas holder type biogas plant. Select one:…

Q: Evaporative cooling PLEASE DO NOT USE PSYCHROMETRIC CHART. THANK YOU In the diagram below inlet air…

A: Given data:

Q: What is the ideal mass flow rate for a refrigeration and cryogenic plant for oxygen production?

A: Ideal mass flow rate: Ideal mass flow rate is referred as the rate at which a fluid flow through a…

Q: A 3 m3 air tank has an initial pressure of 120 kpa and 35oC. The heat is added until its pressure…

Q: Determine the type of steam, given: Pressure: 60kPa Interal Energy: 360 kl/kg O Saturated Liquid…

A: Given: Pressure P=60kPa Specific internal energy u=360kJ/kg

Q: Example-6 The four cylinder engine of a light truck owned by a utility company has been converted to…

Q: Q.1. A refrigeration process with interstage cooling uses refrigerant HFC-134a, and the outlet of…

Q: Draw the layout of gas turbine plant which has two stage of compression with perfect inter-cooling

Q: 1. A cylindrical tank, 3 m long and 2 m in diameter is used for oil storage. How many days can the…

Q: Without doing any calculations, just show I. On Tv diagram: Saturated liquid is converted to…

A: Explanation: The PV and TV diagram are shown in the following attached image:

Q: What are the requirements on proposing Refrigeration and cryogenic plant for oxygen production? List…

A: Proposing a refrigeration and cryogenic plant for oxygen production requires a comprehensive…

Q: 1.) A hand pump is used to inflate a bicycle tire to a gauge pressure of 70 psi. a) How much work…

Q: Please provide complete solution and diagram for this problem. A 2m3 air tank has an initial…

A: Initial condition of Air, V1=2 m3, P1=200 kPa =200*103 Pa, T1=45oC=45+273=318 KFinal mass of air,…

Q: a.) What are the different types of fans used in air-conditioning systems? Discuss their…

A: Solution; Given Data: The volume flow rate of the air is, Q=20 m3/min The duct area is, Ad=0.12 m2…

Q: d) The condenser of a thermal power plant is to be cooled by a nearby river at 14.5°C, allowing a…

A: Given data: Condensor thermal power plant is cooled by a nearby river at TC1=14.5°C, The allowing…

Q: A 485kw-diesel engine uses fuel oil of 28° API, fuel consumption is 0.395kg/kw-hr. Determine the…

A: Power, P= 485 kW Fuel consumption, sfc= 0.395 kg/kW.hr API= 28∘API Ambient temperature, T= 45∘C

Q: A cooling tower has an efficiency of 65%. Water enters the tower at 55°C. The wet bulb temperature…

Q: What exists in a steam boiler operation? a. there is a local equilibrium b. convection heat exchange…

A: The problem is based on heat transfer and can be solved as :

Q: Identify the number of needed tons of refrigeration effect (TR) should the exhibition center require…

A: Given: Number of BTU generates by body, Q = 400 BTU

Q: Create a PH diagram for Refrigeration and Cryogenic Plant for Oxygen Production, using multiple…

A: A PH diagram, also known as a pressure-enthalpy diagram, is a graphical representation of the…

Q: K 1.calculate virtual temp of air with an actual temperature of 25C and pressure of 950hpa, and the…

Q: An engine from a quany vehicle used in the Buid a Beach program of DEMR has a power requirement of…

A: A Carnot engine is referred as a thermodynamic cycle which can result in at most efficiency of a…

Q: Condenser 30C „Flash Chamber Evaporator OC & 50 kW For a 2-stage ammonia compression system,…

Q: Problem Set. Ideal Gas Processes (PVT) 1. The initial pressure of the system during isometric…

A: Given data, P= 100 kPa Heat Q= 10 kW And the process is isometric

Q: What comes up next to the Heat value of natural gas? Q is what? Also, in Fuel Oil, where does the…

A: Ans Higher heating value(HHV) of the natural gas is 23000.859Btu/lbmNow to produce 1KWH power heat…

Q: 13.4 A trigeneration plant (refer to Figure 13.8b) based on an SOFC fuel cell stack is employed for…

A: Given: Pel = 230 kW tel = 12h/day = 43200 sec/day nel = 0.44 Qh = 88 kW th = 12h/day = = 43200…

Q: 3. A water-tube boiler having a heating surface of 325.23 m2 evaporates 6349.21 kg of water in an…

A: The ratio of useable heat production to total energy intake is known as boiler efficiency. The best…

Q: Explain briefly the importance of draft pressure during boiler operation.

A: Draft pressure in a boiler refers to the difference in pressure between the combustion chamber and…

Q: A cylindrical tank 3 m long and 2 m diameter is used for oil storage. How many days can the tank…

A: Given data, d = 2m h = 3m API = 27 FIND n = no. of days

Question

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Step by step

Solved in 2 steps

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, mechanical-engineering and related others by exploring similar questions and additional content below.

Similar questions

QUESTION 12 Determine the type of steam, given: Pressure: 60kPa Interal Energy: 360 kl/kg Saturated Liquid O Saturated Vapor O Superheated Vapor O Wet Vapor
Please provide complete solution and diagram for this problem. A 2m3 air tank has an initial pressure of 200 kpa and 45oC. After 2 kg of air used, thetemperature drops to 35oC. What is the final pressure? A. 156.23 kpa B. 134.78 kpa C. 167.45 kpa D. 105.31 kpa Answer: D
need the correct ans
Provide complete solution and detailed diagram. A 3 m3 air tank has an initial pressure of 120 kpa and 35oC. The heat is added until itspressure increases to 250 kpa. Find the heat added during the process. A. 874.55 KJ B. 762.33 KJ C. 972.82KJ D. 1083.34 KJ
Create a PH diagram for Refrigeration and Cryogenic Plant for Oxygen Production, using multiple compressors and multiple expansion valve.
E 01 Image Word 1/1 Using PV & TS Diagrams derive the formulae of a. Temperature, Pressure & Volume c. Change of Enthalpy e. Change of Entropy g. Work steady-flow of the following processes; 1. Isopiestic, 2. Isochoric, 3. Isothermal, 4. Adiabatic, 5.General Polytropic b. Heat addedrejected d. Change of Internal Energy f. Work non-flow Tap to view in full-screen OCR Rotate Markup Extract Text Signature Note
Pls. Answer thank you! A cooling tower has an efficiency of 65%. Water enters the tower at 55°C. The wet bulb temperature of surrounding air is 27°C. What is the temperature of water leaving the tower?
1. A cylindrical tank, 3 m long and 2 m in diameter is used for oil storage. How many days can the tank supply the engine having 27°API with fuel consumption of 60 kg/hr if the average tank temperature is 24°C?
Initial and operating cost is high for fixed floating gas holder type biogas plant. Select one: OTrue O False
A cylindrical tank 3 m long and 2 m diameter is used for oil storage. How many days can the tank supply the engine having 27oAPI with fuel consumption of 65 kg/hr?
Required information Problem 04.038 - Energy balance for water in a piston-cylinder device NOTE: This is a multi-part question. Once an answer is submitted, you will be unable to return to this part. An insulated piston-cylinder device contains 3.5 L of saturated liquid water at a constant pressure of 175 kPa. Water is stirred by a paddle wheel while a current of 8 A flows for 45 min through a resistor placed in the water. One-half of the liquid is evaporated during this constant-pressure process and the paddle-wheel work amounts to 400 kJ. 11,0 consta Problem 04.038.a - Find source voltage Determine the voltage of the source. Use data from the steam tables. (Please provide an answer before moving on to the next part) The voltage of the source is V.
Define the Compressed Liquid and Saturated Liquid.