1) a) On a sketch illustrate natural gas fired power plant generating and delivering electricity to an end user. At a minimum illustrate the following components: i) Boiler ii) Transformer iii) Generator iv) Turbine v) Condenser

Q: The repair time data for a boiler in a thermal power plant are given by 4.2, 4.5, 4.9, 5.0, 5.2,…

A: (a) Write the given data. T1=4.2 hT2=4.5 hT3=4.9 hT4=5.0 hT5=5.2 hT6=5.6 hT7=5.8 hT8=6.1 hT9=6.3…

Q: If you don't know the solution please leave it but don't copy other experts solution. SO2 is…

A: r=6m/sstack=90mQ=400g/sec∆h=60m:        ⇒ H=90+60=150(A) 3000 m downwind X=3000 m…

Q: 3. Steam at 5.3 MPa, 400 °C expands in a Rankine turbine to 0.036 MPa. For 136 kg/s of steam,…

A: Since you have posted a question with multiple sub-parts, we will solve first three sub- parts for…

Q: el rate c) indicated thermal efficiency d

A: Given-Information:- Generator Efficiency, ηG = 94%Mechanical Efficiency, ηM = 83%Indicated Power, Ip…

Q: A mining pit about 5000ft below sea level was flooding as a result of heavy down pour. The situation…

A:

Q: The diagrams show the cylinder of a petrol engine in 4 stages. Petrol vapour and air are drawn into…

A: Energy cannot be generated or destroyed, according to the first law of…

Q: 12. The speed of the flame in the combustion chamber of SI engine depends on: a) The chamber…

A:

Q: A refrigerator operates on reversed Camot cycle between the temperature limits -10 C and 45 C. The…

A: Given data for refrigerator(R):Lower temperature,TL=-10οC=(-10+273)K=263KHigher…

Q: Question 2: In the Ericsson cycle, the pressure of the air entering the compressor is 100 kPa, the…

A:

Q: 1. Burning gasoline releases heat at 18,600 BTU/lb. a) If this heat is transferred to cool water at…

A: Given:Heat released by burning gasoline, Q=18600 BTU/lbHeat transferred to cold water at, P1=1…

Q: A 60,000 ft2 building used 850,000 kWh of electricity and 900 Mcf of natural gas over the past 12…

A: Given:The area of the building is the energy consumed by the building due to electricity for one…

Q: 7. A fire tube boiler develops 75,000 kilograms of steam at a pressure of 12,500 kpa and a…

A: Given:Mass of steam, m=75000 kgPressure of steam, P=12500 kPaTemperature of steam after heating,…

Q: Superheated steam at 350 0C and 20 bar enters the turbine of steam power plant and expands to a…

A:

Q: .1 A heat engine receives heat transfer rate at 1 MW at a high temperature of 550 °C and rejects…

A: According to company's guidelines,  only First question has to be answered.

Q: Which one of these can be approximated as unsteady flow device?   a) Pump, thermal expansion valve…

A: Which one of these can be approximated as unsteady flow device? Answer: Charging/discharging…

Q: During the operation of a thermal machine, a reduction in the entropy of the working substance is…

A:

Q: Question B2 A fountain fires a jet of water from a 5 mm diameter pipe at ground level vertically…

A:

Q: Which one of these can be approximated as steady flow device?

A: Generally the some of approximate steady flow devices are nozzles, diffusers, mixing chambers,…

Q: Most of us have an electric heater at home. Electric heaters operate at 1500 W (1.5 kW) which means…

A:

Q: Discuss the Carburetors (Single Barrel) Parts of carburetors 2. Carburetors operators 3. Internal…

A: Carburetors are mechanical devices that mix air and fuel for combustion in an internal combustion…

Q: Given the Ultimate analysis of Alabama coal: Hydrogen Nitrogen Moisture Sulfur = 1.26% = 5.29% Ash =…

A: 1 2 3 2

Q: Which one of these can be approximated as unsteady flow device?       A)Diffuser, thermal expansion…

A: Unsteady flow device is the one in which the rate of mass flow is changing with respect to time.

Q: Water vapor at a flow rate of 20000 kg / h enters a steam boiler with a specific volume of 150 kPa…

A:

Q: In a Brayton cycle using air as the working fluid, the temperature at the compressor outlet is 540 K…

A:

Q: 3)A)What is radiation in Heat Transfer ? B)Does the radiation affect the lifetime of the turbine?…

A: Radiation is a heat transfer between two bodies in which there is no direct contact between two…

Q: 10 .In a certain refrigeration system for low temperature application , a two- stage operation is…

A:

Q: Select one correct answer from the statements below. Assume T₁ and T₁ as the absolute temperatures…

A: given  = multiple choice question

Q: A fixed volume insulated tank, initially empty, was connected to a distribution line carrying helium…

A: GIVEN:Ti=135°CCp=5.1926 KJ/KgK

Q: Match the following. 1) Solar water heater which use a heat transfer fluid 2) Solar water heater…

A: (1) Solar water heater which use a heat transfer fluid is: (B) Indirect  In this system, water is…

Q: 9.1 We want to get an idea of the actual mass of 235U involved in powering a nuclear power plant.…

A: Reactor Power Calculation Multiplying the reaction rate per unit volume by the total volume of the…

Q: Arc discharge method for making nanoparticles uses plasma (ionized gas). This ionized gas is from:…

A: Interpretation In Arc discharge method for making nanoparticles uses plasma (ionized gas). This…

Q: cy of a diesel fuel power plant is 13% 0Oste mwhich is eg

A:

Hydronics