1 A continuous time filter has frequency response H(f) = Assuming the attenuation of 20DB in the stop band, the stop band edge frequency is if 1+ 10 Hz. Also the half power frequency Fc (i.e. cut off frequency) is Hz. Note: If the obtained frequencies have decimals, please round them to the closest integer.

Q: After reduction, the current - caring capacity of a condenser is referred to as the___. A. ambience…

A: Given: After reduction, the current carrying capacity of a conductor is referred to as the ___.

Q: What spaces are not included in floor area when calculating the load in volt amperes per square…

A: For calculating the load, first evaluated the total floor area. And according to the NEC , the total…

Q: answer correctly or I'll give down vote 206. Describe the function of the electronic parking brake…

A: The Electronic Parking Brake (EPB), also known as the electric parking brake, is a technology that…

Q: Count Mounting method 15. From the information you have studied about the various electrical…

A: We are authorized to answer one question at a time, since you have not mentioned which question you…

Q: Number 23 please.

A:

Q: List and explain types of Fire Extinguishers. What's the difference between Mechanical safety vs.…

A: Both more formal visual inspections and routine, informal "before use" visual checks enhance safety.…

Q: Is there a way to clean up this answer by using proper notation

A:

Q: Problem 1 is a review of your understanding of KVL (Kirchhoff's voltage law) Using KVL find the…

A: A simple question based on network analysis and the topics described in the solution are kirchoff's…

Q: What type of order is given by a governing agency that finds a violation of the Electrical Code…

A: Electric Code rules:- A building's electrical wiring must adhere to a set of rules known as the…

Q: R a 0 Х R ли 2 л чее L= 10m H If V₂ = ±7√ when x goes to terminal a, what would be VL when t = 25ms?

A:

Q: Please provide a comprehensive explanation of what ring counters are as well as how they are used.

A: Introduction Ring Counters: Ring counters are the type of sequential digital circuit that is used…

Q: . Explain about Fuel cells?

A: Fuell cell

Q: Still confused about how you calculated the current. Could you please elaborate a little? thank you

A:

Q: The subject is engineering and it is from the textbook "AutoCad and its applications"  1-Describe…

A: Since this question contains more than one sub-part, as per the guidelines, first 3 sub-parts has…

Q: Q3: What is a synchronous circuit?

A: I hope you asking synchronous circuit in terms of digital circuits, you have not stated it so I am…

Q: Does ‘a three digit color coding of resistor values’ limit producible resistor value ranges? Why? If…

A: Solution Yes color coding of resistor values limit the resistor value range. In colour coding of…

Q: Explain what this matching box is. Describe the parts

A: The given diagrams are shown below. It is asked what is this matching box and also it asked to…

Thermistors

A thermistor is a special type of resistor whose resistance is more temperature-dependent than standard resistors.  The resistance of the thermistor decreases with increasing temperature. This is the basic principle of thermistors. This allows the thermistor circuit to detect very small temperature changes that cannot be observed with the Resistance temperature detectors (RTDs) or the thermocouples. Since the resistance of a thermistor is temperature dependent, it can be connected to an electrical circuit to measure body temperature. This high sensitivity to temperature changes makes thermistors very useful for accurately controlling and calibrating temperature measurements. In general, resistance increases with increasing temperature in most metals, but thermistors react negatively.