(1- a,) Atmospheric layer (5 km altitude) Fc oT Earth's surface 1. Write an expression for the energy balance of the surface in terms of T, TA, Fc and the other given parameters. Keep your expression algebraic, using the notation given above. 2. Write an expression for the energy balance of the atmospheric layer in terms of T, T, Fc and the other given parameters. Keep your expression algebraic.

Q: LESSON: AUTODESK AUTOCAD Choose from the choices:

A: The broken line is used to draw the large drawings which are not possible to draw on the sheet,…

Q: What type of scale is 1:20? O Full Scale O Enlargement Scale O Reduction Scale O O O

A:

Q: what is the MMC of shaft dimension 1.375 /- .030?

A: Given: The dimension of shaft  is 1375/-0.30 MMC :MMC stand for  Maximum Material Condition.

Q: Please create a simple ping pong ball launcher where there is a mechanism for the trigger. And…

A: We have to given a initial launch angle and a launch initial velocity. And according to the initial…

Q: What type of scale is 10:1? O Full Scale O Enlargement Scale O Reduction Scale

A:

Q: For the bearing shown below in the figure which of the following represents the bearing bore? For…

A: This question is based on the concept of deep groove ball bearing.

Q: Name the feature shown below. 10 00

A: the feature displayed in the picture is extrude

Q: Two cylinders act right after one another. Each cylinder is metered, and some actions are slow, and…

A: Volume for each action:Cyl. A extends DE = 65 cubic inCyl. A retracts DR = 62 cubic inCyl. B extends…

Q: Draw a FBD the tip to tail method please show steps

A:

Q: What is Line G?

A: Solution:

Q: FGI and FKJ correct but incorrect afterwards.

A:

Q: Name the feature shown below.

A: The given figure is of

Q: Question: Q1: Write At Least One Case Study Of The Following Seals 1. Labyrinth Seal 2. Lip Seal 3.…

A:

Q: Calculate flow required to retract a differential cylinder in 30 seconds which is moving a load of…

A:

Slope and Deflection

The slope in a deflected beam is described as an angle in radians made by the tangent of the section with the original axis of the beam. The deflection at any point on the axis of the beam is defined as the lateral displacement of the point before and after loading.