1-33. The specimen failed in a tension test at an angl of 52° when the axial load was 19.80 kip. If the diamete of the specimen is 0.5 in., determine the average norma and average shear stress acting on the area of the incline failure plane. Also, what is the average normal stress actin on the cross section when failure occurs? 52° 0.5 in. Prob. 1-33

Q: The $40 mm round steel shaft shown below is subjected to a bending moment of 1.6 kN-m and a torsion…

A: Steel shafts, which are often composed of carbon steel but can sometimes occasionally be constructed…

Q: The uniform concrete slab has a mass of 2400 kg. Determine the tension in each of the three parallel…

A:

Q: Find the stress resultants N, V and M, draw the diagrams of the stress resultants (N,V,M)

A: Stress ResultantsN= -7 kN (Compression)V= 18 kNMmax= 54 kN-m  As seen on the diagram at explanation…

Q: A steel pipe with an outside diameter of 115 mm and an inside diameter of 105 mm supports the…

A: Principal stresses: Principal stress is defined as the plane's zero shear stress. The principal…

Q: QUESTION 1. Determine the principle stress acting on points A and B on the solid shaft, which is…

A: The radius of the shaft = 20 mm  The distance of points A & B from free end = 250 mm  To…

Pressure and Stress