1 3/2 n.c push button spring return pneumatic DCV 6. 10 2- Shuttle valve 3 (M 3- Electrical motor 5. 4- Air dryer filter 8 5 – Compressor 6. 6- Single acting cylinder spring return single rod pneumatic cylinder LA 1 7- Lubricator 1 V3 8- Air Filter 1. 2 9- Pressure 2 Gauge 11 10- Receiver 11- Presure relief 3 valve 12 1 12 Regulator Symbols of components used in experiment 1 ........... 13 Flow diverter !.....!

Q: Briefly describe the action taken by the following G&M command blocks assuming absolute coordinates.…

A:

Q: Apply geometric tolerancing to part according to the instructions below. This exercise will provide…

A: The majority of current production techniques and equipment are incapable of producing items that…

Q: create 2 fourbar designs that include the dimensions and angle of motion

A: It is asked to draw four bar mechanism with given motion

Q: Give all the location dimensions between the datum target areas , A1 and A2. X = _________________,…

A: Give all the location dimensions between the datum target areas , A1 and A2.X =0  ,  Y =74   ,   Z =…

Q: 9. Please list the basic procedure of calculating the X- and Y-coordinates of the tool centerline…

A:

Q: A stepper motor is used to drive an x-y milling machine table. If the step angle of the motor is 1°…

A: Given, Step angle of the motor, α=1°Pitch of the lead screw,p=7mmSpped, V=25.0mm/sDistance moved by…

Q: what is the omega value? as per the professor, the IC is at b not a

A: Given: The velocity of the upper wire: →V=5.6 m/s It is right that the instantaneous center of…

Q: Draw the plan, Front view and the Side view of the following figure and do the dimensioning.

A: Please refer the following orthographic views of the given object.

Q: 0 = 0° A

A:

Q: Use the image below to do the following  i.  draw 3 positions on a piece of paper. ii.  Chose a…

A: Find three positions and corresponding distances based on the reference point.Alos find linear…

Q: What is the v-velocity at the centerline after refining the mesh

A: To explain: What is the v-velocity at the centerline after refining the mesh.

Q: Given two Orthographic views of an object, construct an Auxiliary view of the indicated ( —P)…

A:

Q: I need help matching the following terms to the phrase it describes. Answers are used only once.

A: The correct answers are matched for the corresponding terms as shown below:

Q: SPECIFY WHERE DIMENSIONS NEED TO BE PLACED FOR THE FOLLOWING PART NOTE: JUST NOTE WHERE…

A: To mark the letters on the following figure mentioned.

Q: 6 Using the drawing callout shown in Figure 5 below, which part(s) shown in Figure 4 would now…

A: According to the given dimensional tolerance for the part, the maximum and minimum allowable…

Q: State any three rules of orthographic parallel projection.

A: Orthographic parallel projection is a method of representing 3D objects normally by three 2D…

Engineering Drawing

Technical drawing has been around since ancient times. As in the ancient Renaissance, complicated drawings were created, including Leonardo da Vinci's drawing. Modern engineering drawing, including its specific orthographic projection with scale conventions, began in Europe (France) during the early stages of Industrialization. L.T. C. Rolt also made some of Marc's drawings for its block-making machinery (in 1799) that also may have contributed significantly to British engineering technology. Since he learned the art of presenting three-dimensional(3D) items in a two-dimensional(2D) plane, as we now term mechanical drawing.