1-15, Wind blows on the side of the fully enclosed agriculture building located on open flat terrain in Nevada. Determine the external pressure acting on the roof. Also, what is the internal pressure in the building which acts on the roof? Use linear interpolation to determine an and C, in Fig.1-15. 1-13 10 30 m 15 m wind

1-15, Wind blows on the side of the fully enclosed agriculture building located on open flat terrain in Nevada. Determine the external pressure acting on the roof. Also, what is the internal pressure in the building which acts on the roof? Use linear interpolation to determine an and C, in Fig.1-15. 1-13 10 30 m 15 m wind

Structural Analysis

6th Edition

ISBN:9781337630931

Author:KASSIMALI, Aslam.

Publisher:KASSIMALI, Aslam.

Chapter2: Loads On Structures

Section: Chapter Questions

Problem 1P

See similar textbooks

Related questions

Q: Determine the resultant force F due to water acting on the 3 m by 6 m rectangular area AB shown in…

A: given data area of gate =3m×6m take γ=9.81 KN/m3 for water we know that pressure = ρgh force =…

Q: For item #3. What is the moment due to the reaction force at A? 192.5 KN-m 157.5 KN-m 175.0 KN-m…

A: Since we only answer up to 3 sub-parts, we’ll answer the first 3. Please resubmit the question and…

Q: A rectangular altitude of 2.4 m. The short side of the gate is flushed with the water surface.…

Q: The wind blows on the side of a storage building, it is located on open flat terrain where the wind…

Q: A steel building has plan dimensions of 50m x 50m and it is 120 m tall. It is provided with brick…

A: According to given data Plan dimension= 50 x 50 in meters and Height is 120m

Q: For the building in the plan shown below, what would be the value of the external pressure…

Q: Example 4.1 A two-story essential facility shown in Figure 4.6 is an enclosed wood-frame building…

A: Wind is a mass of air that moves in a mostly horizontal direction from an area of high pressure to…

Q: Wind blows on the side of the fully enclosed agriculture building located on open flat terrain where…

A: q2=0.00256×Kz×Kzt×Kd×Vγ×I=0.00256×Kz×1×1×1051×0.87q15=0.00256×.85×1×1×1051×0.87=20.872…

Q: PROBLEM An SDOF portal frame fixed at its base has a mass of 1,000 kg at roof level. The system is…

A: Given:Massm=1000 KgStiffnessk=12000 N/mViscous damping coefficientc=500 Ns/m

Q: A 50 m steel tape is used to measure a rectangle at 20°C with a pull of 55 N. The sides are recorded…

Q: mpute the maximum deflection if E = 8.47 x 10 3MPa (for guijo, stress grade 80 NSCP, 2015). Neglect…

Q: Find the snow load on a house in Portland, Maine, with a conventional roof with an 8:12 slope, that…

Q: Wind blows on the side of fully enclosed residential house on open flat terrain. Determine the…

A: Given;DimensionB= 16 mL= 8 mHeight from ground to ceiling= 2.5 mCeiling to Ridge= 1.0 m Roof Slope=…

Q: A computer room located on the second floor of a five-storey office building is 10m X 7m. The…

A: Answer We are given exterior wall dimension 3.5m x 10 m steel back with 10 mm insulating board 75…

Q: Question:- Abuilding is 100m tall and is square in plan with all sides 25m in length. The wind…

Q: 3. The school building has interior columns that are spaced 6 m apart in two perpendicular…

A: Given:- The school building has interior columns The spacing between the columns = 6 m To…

Q: 4.8 Refer to the following table from ACI Code to determine the maximum spans or minimum thickness…

Q: A 50 m steel tape is used to measure a rectangle at 20°C with a pull of 55 N. The sides are recorded…

A: Since the temperature at the time of measurement is higher than that of standard temperature. The…

Q: 4) Select the size of a timber joist with notched end as shown below. The notch is set at 1/3 of the…

A: E(moduluoof elasticity of timber) = 9.5GPa

Q: a honzontal floor at A and on the wall at B making an angle of 60' from the horizontal. and the…

Q: The standard acceptable total absorption of 150mm concrete masonry hollow units in kg/m3 is? а. 250…

A: given-150 mm concrete masonryIt is needed to find out the acceptable total absorption in kg/m3

Q: A two-story hospital is shown in the figure and must withstand an estimated wind speed of 145km/h…

A: Calculate the design wind pressure using the formula, …… (1)Here, the simplified design wind…

Q: What are the Conditions for passive pressure case? Describe.

A: Lateral earth pressure is defined as the earth presure exerted by the soil on the wall in the…

Q: Q.29 In SDOF system, the frequency ratio is 0.50 and damping ratio is 10%. The dynamic magnificator…

A: In SDOF SYSTEM, frequency ratio =0.5 Damping ratio = 10%

Q: Consider a heated warm roof structure in an urban area surrounded by obstructions from all sides.…

A: Exposure type - Protected (As surrounded by obstruction)Temperature conditions - Heated warm roof…

Q: Two forces are applied to the construction bracket as shown. Determine the angle e which makes the…

A: The free-body diagram is shown below,

Q: Situation No. 1: A 5 storey building is constructed with 15 ft. storey heights. The base shear has…

Q: The frame (Figure 1) has dimensions H, =4 m, H =3 m and L =6 m, and supports two lateral loats P-10…

Q: y cos 60 c.p. IANIAY Fig.

Q: A SDOF system has undamped natural frequency 30000 N/m and the damping ratio equal to 0.5. The…

A: The natural frequency is a kind of frequency at which a system is trying to oscillate in the absence…

Q: e has a horizontal base 4 ft. long, 3

A: Pressure at bottom is :P=γw5+3=62.48=499.2lbft2Centroid =5ft+233=7ftso,Total pressure force…

Q: A building wall comists of exterior stud walls with brick veneer and 13 mm fiterboard on one side.…

A: Use the given values, height of wall(H) = 4m and values from given table.

Q: The wind blows uniformly on the front surface of the metal building with a pressure of 1.8 kN/m?.…

A: Given data : Pressure, P=1.8 kN/m2 To find : (a) Resultant Force, F (b) Location of resultant…

Q: Q- An orifice is located at side of tank with water level is 1.5 m above the centre of orifice.…

A: Given- Water level y=1.5 m, Distance x=0.8 m, Vertical fall h=0.2 m, Coefficient of resistance=?

Q: 1. A three-storey office buiding with roof deck has an interior floor plan shown below. Each columns…

A: Space between columns = 6.7 mThe roof loading for the business processing office from ASCE7-02 is…

Q: Determine the clearance between 10 m steel railroad rails. The lowest temperature considered is 16 C…

Q: The beam is loaded as shown. Given: w = 10 kN/m L = 5.1 m A L W 300 mm 150 mm B Determine the…

A: Given data w = 10 KN/m L = 5.1 m b = 150 mm h = 300 mm

Q: A 100‐ft steel tape standardized at 68° F and supported under a tension of 20 lb, was found to be…

Question

1-15, Wind blows on the side of the fully enclosed
agriculture building located on open flat terrain in
Nevada. Determine the external pressure acting on the
roof. Also, what is the internal pressure in the building
which acts on the roof? Use linear interpolation to
determine an and C, in Fig.1-15.
1-13
10
30 m
15 m
wind

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

This is a popular solution!

SEE SOLUTION Check out a sample Q&A here

Step 1 Interpretation of data

VIEW

Step 2 Fetching of data

VIEW

Step 3 Calculation for wind pressure

VIEW

Step 4 Calculation for design wind pressure

VIEW

Step 5 Calculations for pressure on roofs

VIEW

Step 6 Calculations for internal pressure on roofs

VIEW

Step 7 Final answers

VIEW

Trending now

This is a popular solution!

Step by step

Solved in 7 steps with 4 images

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, civil-engineering and related others by exploring similar questions and additional content below.

Similar questions

Q3
Instruction: Use 2 decimal places in your final answers. (Theory of Structure)
1. Determine the M if fj=60,000 psi and f"c=4,000 psi. 6" 나나나의 6" 6" 4 #9 (A, = 4.00 in.2) -18" 6" 15" 3" 24" 4 #8 18"- 20" 3" 3" 26" 3" 3 #10 5" 6" 16". 5" 8" + 8" 8" 24"
Derive the relationship among Unit weight, Porosity and moisture content. - Consider a soil that has a total volume equal to 1. Expressed the weight of soil solids, dry unit weight, moist unit weight - Clue use the formula of porosity to start V₂ V n=
CHOICES ARE ALREADY GIVEN, PLEASE DON’T POST A WRONG ANSWER JUST TO ANSWER NG POST.
I need the answer as soon as possible
Theory of Structures
14-17. A vertical rectangular gate 2m wide and 3 m high is submerged in water with its top edge flushed With the water surface. Find the following: • The value of the maximum force, Facting on center of pressure • The value of the eccentricity • The location of Force , F below the water surface • The magnitude of the maximum pressure
Just answer 4 and 5 question. Thank you!
Situation:A 50m steel tape was standardized and supported throughout its whole length and found to be 0.00329m longer at an observed temperature of 41.6 degrees C and a pull of 12 kilos. This tape was used to measure a line that was found to be 683.21m at average temperature of 49 .8 degrees C at the same pull. Coefficient of the thermal expansion in 0.000016m/m degrees C. -DETERMINE THE STANDARD TEMPERATUREa. 35.93 c. 50.76b. 44.63 d. 68.25-WHAT IS THE CORRECT LENGTH OF THE LINE?a. 633.88 c. 638.23b. 663.28 d. 683.32
Question 5 The plan dimensions of a public hall in a village measures 8.5 m * 20 m. The roof of the building is mono pitched where the low eave height is 3 m and the high eave height is 4.5m. If wind direction is considered at 180', determine the net effect of external and internal pressure coefficients for the zones of mono pitched roof. Openings in windward side: three windows of dimension: 2 m * 2 m. Openings in leeward side: two doors of dimension: 2.5 m * 2 m. Openings in wind parallel sides: one window, in each side, of dimension: 2 m * 1.5 m.
A vertical circular gate 3ft in diameter is subjected to pressure of molasses (sp gr 1.30) on one side. The free surface of the molasses is 10 ft above the top of the gate. Determine the total pressure and the locations of the center of pressure.