0il with p = 876 kg/m³ and u = 0.24 kg/m-s is flow- ing through a 1.5-cm-diameter pipe that discharges into the atmosphere at 88 kPa. The absolute pressure 15 m before the exit is measured to be 135 kPa. Determine the flow rate of oil through the pipe if the pipe is (a) horizontal, (b). inclined 8° upward from the horizontal, and (c) inclined 8° downward from the horizontal.

Q: n a refinery, fuel ethanol is flowing in a pipe at a velocity of 1.2 m/s at 2 atm. The refinery…

A: Given data v1=1.2 m/sP1=2 atmP2=1 atmd1=40 cmd2=10 cm Here, v is the velocity of flow and P is the…

Q: 2- mass flow rate is

A: To find Enters density mass flow rate

Q: Water is to be withdrawn from an 11.2-m-high water reservoir by drilling a 4.1-cm-diameter hole at…

A:

Q: Gasoline (p = 680 kg/m² and v = 4.29 × 10o-7 m²/s) is transported at a rate of 190 L/s for a…

A:

Q: air flows in a duct at the rate of 0.056 m3/s. Determine the pressure drop (kPa) between the 6 and 3…

A:

Q: Consider two liquids of densities p₁ = 1000 kg/m³ and p2 = 800 kg/m³ that are initially flowing in…

A: According to principle of conservation of mass, the mass can neither be created nor be destroyed so…

Q: A 3-m-high large tank is initially filled with water. The tank water surface is open to the…

A: Given:Initial height of the tank, H=3 mOrifice diameter, d=10 cm=0.1 mLength of the horizontal pipe,…

Q: 480 kPa 15 cm Water 445 kPa Reducer 8 cm

A: Flow through pipe given- d1=15cmd2=8cmQ=0.035 m3/sec

Q: Determine the maximum allowable height, in metres, of a pump relative to a reservoir it is…

A:

Q: Determine the maximum allowable suction head for a pump with a cavitation constant equal to 0.3 when…

A:

Q: Question 3 Water enters a U-shape pipe at 50 kg/s mass flow rate at inlet 1 and leaves the U-shape…

A: Given:P1 = 300 kPaP2 = 200 kPaP3 = 100 kPad1 = 5 cmd2 = 10 cmd3 = 3 cmDensity of water = 1000…

Q: uryer eharges ameter, well-rounded vent with negligible loss is n en connected to a 15-ft-long,…

A: select point (1) toward be inside the drier and point (2) toward be the exit of the drier.consider…

Q: the minimum power required

A: Given; Determine the minimum power required to pump the water across the pipe ?Where,  Pressure drop…

Q: Water is flowing through a horizontal pipe of diameter 250 mm. If the pressure drop between two…

A: Givend=250mm∆P=825Pa

Q: Water flows (from bottom to top) in a vertical duct of 5 cm of internal diameter. A differential…

A: Solution is attached below

Q: A 400cm long pipe with a smaller diameter of 3.937 inchesand a larger diameter of 11.81 inches as…

A:

Q: The water level in a tank is 12 m above the ground. A hose is connected to the bottom of the tank,…

A:

Q: Air at 110 kPa and 50 °C flows through the 6 cm diameter duct at a flow rate of 45 L/s in the…

A: Data given-  P1 = 110 kPa  d1 = 6 cm = 0.06 m d2 = 4 cm = 0.04 m Q = 45 L/s = 0.045 m3/s z2 - z1…

Q: Water at 90°C is to be pumped from a low-elevation reservoir to a high-elevation reservoir at a flow…

A: The length of the suction pipe→L=7.2 m Flow rate of the water→Q=0.0046 m3/s Friction factor of the…

Q: While the fluid passes through the nozzle at a volume flow of 12 m3 / hour, the pressure difference…

A:

Q: A large open tank is filled with oil (SG=0.75) to a height of 4.1ft. At t=0, a 1.5-inch ID spout at…

A:

Q: Consider the flow of oil with p = 870.15 kg/m³ and µ = 3.93 kg/m•s in %3D a 37.6 cm-diameter…

A:

Q: 20 cm diameter pipe carries air at 24 m / s at a pressure of 148 kpa absolute pressure and 27 ° C.…

A: Given:d1=20 cmv1=24 m/sP1=148 KPaT1=27°C =300 Kd2=10 cmT2=11°C =284 KP2=130.5 KPa

Q: Water at 20°C is pumped at a constant rate of 9 m3/h from a large reservoir resting on the floor to…

A:

Q: Determine the minimum pipe diameter if the pressure drop is to

A:

Q: Water is flowing through a horizontal pipe. Water enters the left side of the pipe at a pressure P =…

A:

Q: Consider two liquids of densities p₁ = 1000 kg/m³ and p₂ = 800 kg/m³ that are initially flowing in…

A:

Q: ter at 27.5°C flows at a rate of 2.1 kg/s through a vertical pipe with an internal diameter of 17…

A:

Q: A turbine is placed at the bottom of a 20-m-high water body. Water flows through the turbine at a…

A: Given: The height of the body is H=20 m. The rate of flow of the water is V=30 m3/s. The shaft power…

Q: The owners of a smallholding water their vegetable garden using collected rainwater from atank.…

A: Diameter of Tank, b=8 m Diameter of hose, c=7m Height of Tank, a=9 m Height of stand, 6m Length of…

Q: A 6cm diameter horizontal water pipe expands to a 10cm diameter pipe. The average velocity and…

A:

Q: Water is flowing through a venturi meter whose diameter is 7 cm at the entrance part and 4 cm at the…

A:

Q: Water in a duct of area 0.1 m2 has an average velocity of 7 m/s. The duct tapers slowly to 0.4 m2.…

A: Given data: The area of the duct at section 1 is, A1 = 0.1 m2. The average velocity at section 1…

Q: A horizontal pipe bend with a deflection angle of 120o has an entrance diameter of 300 mm and exit…

A:

Q: Explain how flow rate is measured with a turbine flowmeter, and discuss how they compare to other…

A: For measuring flow rate we have many flow meter and one of them is Turbine flow meter. As from the…

Q: Oil flows in a 39-cm-diameter pipeline at an average velocity of 0.5 m/s. A 304-m-long section of…

A:

Q: Water flows through a horizontal verturi meter whos inlet diameter is 31 cm and throat diameter is…

A:

Q: Water at 25°C flows from a large reservoir to a smaller one through two clean cast iron pipes in…

A:

Q: Water is being pumped from a  reservoir with water surface elevation of 12 m to  another reservoir…

A: Given that, Elevation of water, he=12 m,Elevation of reservoire, hr=69 m,Flow rate of water, Q=25…

Q: Water at 20C is pumped at a constant rate of 9 m3/h from a large reservoir resting on the floor to…

A: Given:Water temperature, T=20oCWater flow rate, Q=9 m3/h=93600m3/s=0.0025 m3/sThe point of discharge…

Q: is 11.75 m/s. The hose makes a 180° turn before the water is discharged. Disregard the weight of the…

A:

Q: Air is flowing through a venturi meter whose diameter is 2.6 in at the entrance part (location 1)…

A: