03: SPI system shown in the following figure 1, if SS, = 1, 55, = 0,SS, = MISO = 1, state the data flow in such a case. 1. M-0 and %3D %3D SCLK SCLK MOS MISO SP Slave MOSI Slave 1 SP MISO 551 552 583 Master SCLK MOS MISO SPI Slave Slave 2 SCIK Serial Clock MOSI Master Out Slave in MISO Master in Slave Out SCLK MOS SPI Slave 3 MISO Slave Slave Select

Q: If INTO and INT1 are enabled and EICRA-Oxell then Select one: O a. the falling edge of INTO and the…

A: 1) INT0 and INT1 are enabled: This means that the microcontroller is configured to respond to…

Q: What is mean by PLI express.

A: PLI:  PLI stands for programming language interface,  it is the programming interface to run a…

Q: 03: SPI system shown in the following figure 1, if SS, = 1, SS2 = 0, SS, = 1. MOSI = 0 and MISO = 1,…

A: ANSWER:

Q: A1. A circuit containing

A: In the given question there is miss print the circuit will containing 64k words as it is clear…

Q: Refor to figure 20 (Page 19) of the Single Cycle Datapath module. For the following functional units…

A: As per the given single cycle Datapath and hardware delaysLongest critical path for single cycle…

Q: Write an 8051 assembly program to generate 500 Hz square wave from port P1.0 using Timer 0. The…

A: Here is an 8051 assembly program that generates a 500 Hz square wave from port P1.0 using Timer 0:

Q: If BL=BA and AL=34 hex are multiplied using MUL BL, where do the results appear (a) AX contains the…

A: MUL BL is an instruction in the microprocessor in which multiplication of AL and BL is done and the…

Q: For  tthfeoloowing 8085 instruction determine: t-state, size, and machine cycle for each CMP B INX…

A: The 8085 is an 8-bit microprocessor that was introduced by Intel in 1976. It was a popular…

Q: ASSEMBLY What is the result of executing: mov bx, 0ABCDh shr bx, 1     55E6     6E55…

A: SHR means shift right and the MSB bit is replaced by 0. Mov bx, 0ABCD will store value ABCD into it.…

Q: Give the starting code memory location and the machine code in hexadecimal: The instructions are for…

A: Give the starting code memory location and the machine code in hexadecimal :  The instruction are…

Q: TITI Register Content Data Memory Content WO Ox1006 Ox1000 OXFEB1 W1 OXAB9A Ox1002 Ox0193 W2 Ox0015…

A: To find the content in place of #0xYYYY

Q: What register (letter label) from the register file in MIPS does rd represent? op 000000 10001 rs rd…

A: MIPS:- MIPS (Microprocessor without Interlocked Pipelined Stages) is a series of RISC (reduced…

Q: t a LFSR with 4 shift registers with initial condition S3 = 1, S2 = 0, S1 = 0, S0 = 1 and feedbacks…

A: It is defined as a Linear-Feedback Shift Register (LFSR) is a register of bits that performs…

Q: 1. Construct an NFA for the state table given below.

A: The answer is

Q: Show current state, remaining tapé content and stack content for each step of execution of the PDA…

A:

Q: Blank # 1 Blank # 2 Blank # 3 Blank # 4

A: I have answered below:

Q: The idle state is one clock period long, is inserted in the -- the bus cycle, while the wait state…

A: Here is the explanation about bus cycle:

Q: Formula for Savings is A. Yd - C = S B. Yd + S = C C. Yd - S = C D. Yd + C = S

A: The correct answer is : A. Yd-C=S

Q: Timer Calculate. In this case, we assume the standard 12 MHz / 12 oscillations-per-instruction…

A: Answer: I have written in own handwriting format

Q: Assembler Language: Show all work and explain in detail for the following and assume: 0008AB40 is in…

A: NOTE: “Since you have posted a question with multiple sub-parts, we will solve first three sub-…

Q: Explain these two digrams

A: The block diagrams are made as same as flowcharts are. We will want to create the blocks like we…

Q: Define scan counter?

A: Scan is a term that describes digitizing an image allowing it to be stored modified or understood by…

Q: ount Register in a DMA contr dressable. The DMA controll r for 5 times (5 requests and gI e data…

A:

Q: Q12. Refer to the shift register circuit shown below where stage Z is the LSB. The circuit has 4…

A: D flip flop If the clock pulse is 0 the earlier output does not change   If the clock pulse is 1…

Q: DATA D Q IN CLK CLK D Q CLK D Q CLK DATA IN Qo D Q-DATA CLK OUT Figure 9-1 After the data have been…

A: Shift Register: It is digital circuit which is found in calculator, computer, etc. It contains a…

Q: c. Determine the time delay generated by the following assembly language delay routing. Assuming the…

A: assembly language, now and again shortened asm, is any low-level programming language wherein there…

Q: Define scan counter?

A:

Q: Define scan counter?

A: Counter- scanning (CS) is a scanning method that permits correcting raster mutilations caused by…

Q: For a particular up, the manufacture specifies that the width of a certain control signal determined…

A: Actually, given information: A microprocessor has a memory write timing as shown in Figure 3.18. Its…

Q: Compute the time delay generated by an Atmega32 (XTAL = 8MH2) that is programmed by the following…

A: Solution!!

Q: VI. A given hardware contains 5 logic blocks that require 20ns, 35ns, 15ns, 50ns and 25ns…

A:

Q: hitecture and write the requi stem enables the user to monitor the current tempera nitor. The…

A: The LM35 temperature sensor is connected to analog input A0 on the Arduino UNO. The blue LED is…

Q: Show the content of each register at the specified base a. Mov ax, -10 ; b. Mov bx, OxFEE; C. ax, 5…

A: In this problem, we will analyze and calculate the content of various x86 assembly registers after…

Q: The number of local sequential devices (flops, latches) would need to increase from a nonpipelined…

A: In a non pipelined machine activities done like fetch the data, decode the data, and execute…

Q: ssume the data in $s0 = O×1234ABCD, the data in Şa0 = 0×1234ABCD. After executing the follo sembly…

A: It is defined as memory storing units. It is an element of the computer processor. It can carry any…

Q: Why is cycle stealing necessary for DMA?

A: Introduction: Here we are required to explain why is cycle stealing necessary for DMA.

Q: For the state diagram given below, find the SM chart.

A: Here we have six states so we need 3 bits to store them S1-000 S2-001 S3-010 S4-011 S5-100 S6-101

Q: For the 8051 microcontroller Explain the operation of the following lines of code…

A: We will be looking it line by line in following solution and end result also for Microcontroller…