0.30 m 1.70 m 1.10 m 30 Warm Wioad
Q: The ends of a trough are vertical semicircular regions, each with a radius 3 ft. Find the force…
A: Given:- the radius of the half-circle is r= 3 ft Find:- The ends of a trough are vertical…
Q: Swearing high heels shoes require to distribute the weight equally over the heels. Consider for…
A:
Q: A centrifugal pump having a performance curve given by the equation h, = 170 – 122.884Q², with h, in…
A:
Q: What is the lift (in newtons) due to Bernouli's prin- ciple pn a wing of area 78 m? if the air…
A: Given data The area is given as A = 78 m2. The velocity at the top surface is given as vt = 260…
Q: (b). An aluminum cylinder weighs 1.03 N. When this same cylinder is completely submerged in in…
A:
Q: he mass of aluminum is 25g. (a) What is its volume? (b) What will be the tension in a string that…
A: Given: The mass of the aluminum is 25 g = 0.025 kg. The density of aluminum is 2700 kg/m3.
Q: A certain hydraulic system is designed to exert a force 100 times as large as the one put into it.…
A:
Q: The radius of a capillary tube is 0.05cm. It stands vertically in a liquid of surface tension 25…
A:
Q: A crown has a mass of O,59Z kg and when it is Sübmerged tn wwater (lo0 kg Per cubic meter)it…
A: The buoyant force, B=0.671 N The mass of the crown, m=0.592 kg
Q: need asap ty A syringe has a cross-sectional area of 0.35m² and the needle attached to the syringe…
A: Given : A1 = 0.35 m2 A2 = 0.125 m2 v1 = 0.28 m/s
Q: There is a fluid witha constant density of Uston t2o kg per cubic meter. flows without turbulence or…
A:
Q: (a) A 75 kg block has a volume of 0.064 m3. Will it sink or ?oat in water? (b) What is the…
A: a) The density of the block is,
Q: What is the greatest average speed of blood flow at 37OC in an artery of radius 2.00mm if the flow…
A: Blood is what flows throughout the body of an organism to supply oxygen to the organs and carry…
Q: A certain man has a mass of 80 kg and a density of955 kg/m3 (excluding the air in his lungs). (a)…
A: a) the volume of the body is given by,
Q: Water is moving at a velocity of 2.00 m/s through a hose with an internal diameter of 1.60 cm. (a)…
A: The velocity of the water is given as, v=2 m/s, The internal diameter of the hose is given as,…
Q: 1. A full-term fetus typically has a mass of 3.50 kg. (a) What pressure does the weight of such a…
A: given,m=3.5kga)P=FA=mgA=3.5×9.80.009m2=3811.1N/m2
Q: s Water is flowitag theouge a a pipe ot radius 2s on at speed of so %s. the pipe then constriats to…
A: Please note : As per answering guidelines I can answer the first question only. Since, this is not a…
Q: A square plate of side 3 m is submerged in water at an incline of 30°with the horizontal. Calculate…
A: The bottom edge of the plate is located at a depth of 6+3sin30°=7.5 The width of each horizontal…
Q: When the initial height of the pipe is 10 m and final height to 3 m, what is the final pressure of…
A: Using Bernoulli’s principle, P1+ρgh1=P2+ρgh2 Here, P1 is the initial pressure. P2 is the final…
Q: (B) A large storage tank (open at the top), filled with water and, develops a small hole in its side…
A:
Q: Find the total pressure on a diver whe he is 25.0 m below the surface of the sea. make an…
A: Given : h=25m The atmospheric pressure is known to be P0=1×105Pa. The pressure at the given depth is…
Q: A full-term fetus typically has a mass of 3.50 kg. (a) What pressure does the weight of such a fetus…
A: Given Mass (m) = 3.50 kg Area (A) = 90.0 cm2
Q: (a) A 75 kg block has a volume of 0.10 m3. Will it sink or ?oat in water? (b) What is the buoyancy…
A: Given: m = 75 kg V = 0.1 m3
Q: a submarin is 100 m long. the shape of its hall is roughly cylindrical with a diameter of 15 m. when…
A:
Q: Why is the retracting force usually less than the extending force for standard differential…
A: Introduction: A hydraulic cylinder is a mechanical actuator (component that is responsible for…
Q: A river has a flow rate of about 100,000L/s. At the end the river, it narrows to 20m wide and…
A: This is simple formula based question. We just need to calculate the Cross sectional Area and then…
Q: Water flows through a horizontal pipe with a cross sectional area of 4m^2 at a speed of 5m/s with a…
A:
Q: Consider the venturi tube ofwithout the manometer. Let Aequal 5a. Suppose the pressure p1 atAis 2.0…
A: The speed V at the point A is given as Here, A=5a. Therefore,
Q: At one point in a pipeline the water's speed is 4 m.s-1 and the pressure is 151 300 Pa. Calculate…
A: The water's speed at the first point is, v1=4 m/s The pressure at the first point is, P1=151300 Pa…
Q: (1) A siphon having a diameter d of 100 mm is positioned as shown in the picture. The flow losses…
A: Flow of fluid are of many types. Flow may be laminar, turbulent, etc. Continuity means the fluid…
Q: A full-term fetus typically has a mass of 3.50 kg. (a) Whatpressure does the weight of such a fetus…
A: The pressure exerted by the fetus is
Q: a) A regular basketball (diameter: 34.2 cm) is entirely submerged in water. Calculate the buoyant…
A:
Q: An unknown liquid fills a 100 cm3 container and weights 500 g what the density of the liquid in…
A: Given data: Volume (V) = 100 cm3 Mass (m) = 500 g = 0.500 kg Required: The density of the liquid…
Q: (a) Identify the any two points where the Reynolds number fluctuates. (b)ldentify the any two points…
A: Part(a): In laminar flow, fluids flow in smooth path and it never interfere with one another. And in…
The hydraulic system of a backhoe is used to lift a load as
shown. (a) Calculate the force F the slave
cylinder must exert to support the 400-kg load and the 150-kg
brace and shovel. (b) What is the pressure in the hydraulic
fluid if the slave cylinder is 2.50 cm in diameter? (c) What
force would you have to exert on a lever with a mechanical
advantage of 5.00 acting on a master cylinder 0.800 cm in
diameter to create this pressure?
Step by step
Solved in 2 steps with 2 images