0.252 2v 0.12 0252 L 0.452 3v A.) Vab B) Rab 5v A 0.32 0.22 -Bv 2v Determine the following: 0.52 www c) Load current, d.) Load Power in 10v {0.152 B 5v IL RL = 82 IL RL = 852

Q: D1 Vo Ext Trig Vac 8Vrms 50HZ 0° R1 1k0 Şekil (A) Şekil (B) 12 12 8. 6. 4 -4 -12 Om 20m 40m Om 20m…

A: The given circuit it is like a half wave rectifier    During the positive half cycle of the input…

Q: 1f 13.84A E 1₁ = 13 = Determine the following E or V ت 0 HI R₁ = 12-240mA Ri R2 = 500 units units…

A: Given: A network,  where,  Is=3.84 A, I2=240 mA,  R2 = 50Ω, R3 = 5Ω,  To find: E, I1, I3, R1.

Q: Question 3: A very simple model for the distribution of clectricity to a typical home is shown in…

A:

Q: EX Ageueration Stien of lo Mw suPPly regien of two Consumes A and B when the Varatienof the lead is…

A:

Q: What is the totel current? R1 R3 RS 3 kOhm V1 111 V 2 kOhm 1 kOhm R28 kOhm R47 kOhm R66 kOhm

A:

Q: 3) Is there maximum power transfer from: a) source to amplifier? b) amplifier to load?

A:

Q: Find Vy using TEC

A:

Q: 5002 ww ! A k=1 B jXX-1000 500 w A j25 B JXLI X22 -16 (100) -j25 www 2009 Select XL1 and XL2, so…

A:

Q: Calculate the value of RB in ohms. at VCC=18 V, IB=27 uA, and VC=6V and B=63

A: In this question, the given data.  VCC=18 V, IB=27 uA, and VC=6V and B=63 Here The emitter is short…

Q: Find the compless power absorbed by the load.

A: This question is based on the concept of complex power drawn by a load. The load is connected across…

Q: What are the branch currents, 12 and 13? R₁ 4 kOhm V₁ 35 V R2 7.5 kOhm R3 12.5 kOhm

A: In this question,  We need to Determine the branch current I2  and I3   We are solving this problem…

Q: A Full B Adder Y D Q carry-out Clock Q Reset-

A:

Q: + 17V 14A+ R, 25V 0.41

A: Applying the nodal analysis at the node:

Q: 3 2 + V2 is v5 70 24 V + Vi

A: We need to find out current and voltage and power for given circuit

Q: In forward regeneration mode of operation in chopper, one of the following condition happens Load…

A: Forward regeneration mode of the operation in chopper  What will be happened

Q: What are the branch currents, 12 and 13? R₁ 4 kOhm V₁ 35 V R2 7.5 kOhm R 12.5 kOhm

A: Introduction Current divider rule: The current divider rule is an electrical principle that explains…

Q: In a parallel circuit, ET = 120 V, R = 1500 $2, and XL 1000 2. What is the apparent power? O a.…

A: Given: In a parallel circuit, ET=120 VR=1500 ΩXL=1000 Ω

Q: find the value of each current using Kirchhoff's laws

A: The above circuit can be solved using either of the circuit theory rules mentioned below:…

Q: 41. In the figure, the value of Ris 8 A R ww 100 V- 10 2 102 (a) 2.5 2 (c) 7,5 0 (b) 5.0 2 (d) 10 O

A: According to the question we have to find the value of R.

Q: Vdc across the load is 110 V rms/ 1.0k 12.36V 24.73V 110V 55V

A: In this question,  We need to choose the correct options What is average DC voltage?

Q: VEE =-12V, VCC = 12V, R1=9800 ohm, R2 = 3300 ohm, RC = 1800 ohm, RE = 970 ohm, B = 100 Calculate IB…

A:

Q: 9V ImA 1002 ↑ +1 85022 loks 8505 IMS 25002 VI

A: We are given a circuit problem of op-amp :We have to find V1 in the circuit.

Q: ÉA fab j-Xab Eg Ec -j- Xca Ea=220+j0 V, Eb=-110-j190.5 V, Ec=-110+j190.5 V. Rab=200 Ohms, Rbc=150…

A:

Q: 40 ww 200 40 4V SV 202 0.04 A -0.04 A 0,1 A -4V wW-

A:

Q: 820 2 Rg 470 kQ Pac = 200 VcC 10 V V BB 10 V

A: Given data: VBB=10 V RB=470×103 Ω with ±5% tolerance Solution: Let, VBE=0.7 V The 5% of base…

Q: In the figure shown below find the current in the resistor R1 50AN R20 Rla 16.6A O 8.3A 15V O 16.6V…

A: The current division rule is very important to find current in each branch of parallel resistance.…

Q: Forward Blas Condition: (injected minority current - due to holes crossing the junction and entering…

A: Diode is an uncontrolled Device in which their ON and OFF state can't be controlled by us. When the…

Q: ¿Cuánto puede variar Ri, en el circuito adjunto, si la potencia del Zener es de 0.5W y la corriente…

A:

Q: 3) A signal x,(t) that is band-limited to 10KHZ is processed by the following system 占回- f = 20 kHz…

A: Given fm=10 kHzfs=20 kHz

Q: 0.9v- 0.8v 0.6v- o.sv- 0.3v- 0.2v 0.1V- 0.ov- Oms 1ms Ams Sma 6ms Bms 9ms C1 Vo 1p V1 .tran 10ms…

A:

Q: Which one of the following voltage levels is not a standard level for residential loads Select one:…

A:

Q: IfI, = 5/0 A, when a voltmeter is connected across the 22 resistor, reading will be -le 20 2 122 V.…

A: In this question we have to find out voltage across 2 ohm using KCL... Kirchhoff’s Current Law,…

Q: 352 -4V Determine The current I a Bare circuit in The

A: In this question we need to find a current I .

Q: 12 2 mA A Vo R4 R5 6 kQ 2 ko R1 R2 R3 8 mA 3 kQ 6 kQ 1 ka

A:

Q: Determine Rin (in MQ) for the figure. Ipss= 10 mA Vp=-4 V 4.7 kN 10 V o Mw Mw0-2.5 V 2 MN

A: The given circuit is shown below: VGG=-2.5 V VDD=10 V RD=4.7kohm RG=2Mohm

Q: T 12V VT determine IT. 38.2kQ TR1 6.8kQ R2 34.7kQ R3

A: Given circuit:

Q: SOLVE ALL CURRENT USING NODAL ANALYSIS.

A: The required parameters can be calculated by applying kirchhoff's current law to the nodes.

Q: In forward regeneration mode of operation in chopper, one of the following condition happens Load…

A: In the forward regeneration mode of the operation in chopper,  Which conditions are happened

Q: E15V 300 $450 $500

A:

Q: VDD R1 = 7.5 kQ R2 = 6.8 kQ R3 = 4.7 kQ Rc = 2.2 kQ RE = 1.2 kQ Vcc = 20 V B1 = B2 = 180 32 R2 Vi B1…

A:

Q: Vs Ⓒ Q5: In the circuit shown below determine the input source voltage and its power factor. ZI o.o…

A: In this question we need to find the input voltage and its power factor.

Q: Ptja ISI P Power too angele

A: The solution is given below

Q: 40 4 12 V 10 2.5A V T15 V

A: Referring to the above circuit, the terminal seems to be open then the current will flow is 0A as…

KVL and KCL

KVL stands for Kirchhoff voltage law. KVL states that the total voltage drops around the loop in any closed electric circuit is equal to the sum of total voltage drop in the same closed loop.

Sign Convention

Science and technology incorporate some ideas and techniques of their own to understand a system skilfully and easily. These techniques are called conventions. For example: Sign conventions of mirrors are used to understand the phenomenon of reflection and refraction in an easier way.