0.152vand 0. Suv Pespectively.

Q: Calculate the density of oxygen gas at a temperature of 57 C and a pressure of 5 MPa.

A: Density of oxygen at 570C and 5 MPa is asked

Q: Describe the difference between average pressure and false pressure

A: The force applied perpendicular to the surface of an object per unit area over which that force is…

Q: 16. What is the unit of resistance in SI? O w O W/K O m-K/W O W/m^2-K O K/W

A: Asked;  SI unit of resistance

Q: Apply diffusive Fick's first law on one dimension

A: Mass transfer is the net movement of mass from one location to another. Mass transfer occurs in many…

Q: 100 lb•ft/s2 to N

A: The unit of force is to be converted from lb. ft/s2 to N.

Q: It is said that inlet gas takes 5-6 turns in Cyclone Separator.Justify the statement.

A:

Q: Fraction of water

A: To Answer whether the fraction of water in the underflow stream of thickener is zero

Q: A valve chokes refrigerant 134a from 0.7 mPa to 160 kpa. Determine the temperature released by the…

A:

Q: How Reynold’s No. is related to Drag Coefficient when liquid flows through a packed bed?

A: The packed bed Reynolds number is dimensionless number and is the ratio of inertial to viscous…

Q: 7. Calculate the viscosity (micropoises) of molecular oxygen at 273.2 K and 1 bar. The molecular…

A: Temperature, T = 273.2 K Pressure, P = 1 bar Molecular diameter, d = 0.360 nm

Q: Write if the statement is correct. Else, write the correct answer based on the underlined word(s).…

A:

Q: Boiling temperature (°C) of water at 7200 m altitude?

A: The boiling temperature at 7200 m.

Q: Discuss about Momentum and heat transfer operation with examples

A: Momentum transfer - In general, transfer of momentum from one molecules to other molecules due to…

Q: Explain in detail on the E unsteady state material balance for a suitable system with example.

A:

Q: 5. Absolute pressure is measured relative to atmosphere. Tor F

A: Absolute pressure is measured relative to a full vacuum Whereas the pressure that is measured…

Q: -dj- dz E50 mm PA X) mm da Pn

A:

Q: Baffles increases the fluid velocity on the tube side. True False

A: Baffles are used to direct fluid across the tube bundle and run perpendicularly to the shell.…

Q: What is the maximum radial distance traveled by any particle in cyclone seperator?

A: Chemical processes consist of the separation stages in which the process streams are separated and…

Q: Cl the dimensions were all the same, which chocolate can withstand the greatest load? D. Which has…

A: C. The chocolate that can withstand the greatest load is to be mentioned.

Q: Sketch the (220) plane for CaF2

A: x y z INDICES 2 2 0 RECIPROCAL  1/2 1/2 1/0 INTERCEPT 1/2 1/2 ∞

Q: 1. Calculate the surface per unit volume in square centi- meters per cubic centimeter of galena…

A: Mesh%…

Q: What type of line corresponds to an f value of 0?   a horizontal   b leaning towards the left…

A: Generally the f line or q line represents the quality of feed.

Q: an AE unit for energy

A: The specific heat capacity of a substance is the amount of energy required to raise the temperature…

Q: Q/ explain about effect wettability on 1- Saturation 2- Porosity 3- Relative permeability 4-…

A: To Explain The effect of wettability on saturation, porosity, relative permeability and capillary…

Q: what is the area/diameter of a p6227 venturimeter

A:

Q: Explain analogy between heat and momentum transfer

A: The most widely accepted analogy between Heat, mass and momentum transfer is Chilton-Colburn…

Q: Sketch the cross flow induced-draft cooling tower and illustrate all its parts.

A: Induced draft cooling towers Induced draft cooling towers are of two types based on the nature of…

Q: sphericity

A:

Q: P= 670 kg/m3 V = Jo L %3D kg in %3D

A:

Q: A thin wira with L- 22.13 cm has a uniform linear charge density of X = 5.635 · 1c/m. This wire is…

A:

Q: B. Drive the Kremser Equation which used for Algebraic Determination of the Number of Ideal Stages.

A: Kremser equation is basically used in absorption process to dertermine the no of ideal stages.It is…

Q: 10. Explain the principle of hydraulic diameter and its use for ducts with non-circular…

A: Introduction: Pipe flow: In fluid mechanics, pipe flow is a sort of liquid flow inside a closed…

Q: Determine the capacitance in l of a parallel plate capacitor having a plate area of 0.03 m and a…

A: a) the capacitance for the parallel plate capacitor is  C=Kε0Ad Given : K=7 A=0.03m3…

Q: Q2: What is meant by piston speed? How is it varied for squired, under squired and over squired…

A: Piston Speed is the Average speed that a piston moves from the Bottom Dead Center (BDC) and Top Dead…

Q: The viscosity of honey is about 1 Pa-s. The viscosity of water at 20C is about 1 cp. How many times…

A: Given  Viscosity of honey  µhoney  = 1 Pa-s Viscosity of water  µwater= 1 cp

Q: Write the name of the fundamental dimensions

A: Write the name of fundamental dimensions.

Q: = 7800 N, ributed around a cap plate at the top of the lower rts a load P. pe. A second load P is…

A: I already solve this this question and i know that this question is incomplete . The complete…

Q: y 200 12 Case 1 90 1:4 90 12 f₁²t T Units in mm Units in mm Case 2 Figure 3 200 X X

A:

Q: Viscosity O IV and III IV Which of the above indicates psuedoplastic flow? O II only O IV only I…

A: A pseudoplastic is the Non-Newtonian fluid whose apparent viscosity decreases instantaneously with…

Q: Question 11 When the dislocation density increases, how would the Yield Stress, Tensile Strength,…

A: Dislocation density is explained as the measure of the number of dislocation that can be present in…