. Design a roller chain drive. Specify the chain size, the sizes and number of teeth in the nrockets the number of chain pitches, and the center distance.

Q: Make a two DOF linkage with the amount of seven links. Use links that are quaternary and make sure…

A: Make a two DOF linkage with the amount of seven links.Use links that are quaternary and make sure…

Q: A pinion of 19 teeth meshes with a gear of 37 teeth. Module is 4 mm and pressure angle is 20o.…

A:

Q: The following figure depicts a 1600 rpm motor, gear box, and 4000 rpm blower. The gear box weighs 40…

A: “Since you have posted a question with multiple sub-parts, we will provide the solution only to the…

Q: The gear reduction unit and propeller of an outboard boat motor are shown in the following figure.…

A: “Since you have posted a question with multiple sub parts, we will provide the solution only to the…

Q: Find the maximum and minimum transmission angles over its range of motion.

A:

Q: What is the extreme transmission angle values by using maxima and minima condition, of the…

A: The extreme transmission angle in the four-bar mechanism is given as : μmin=sin-1cos2θ2 here ,…

Q: 3 L X x 5 ام 1-Motor; 2,6-Coupling; 3-Reducer; 4-High speed gear pair; 5-Low speed gear pair;…

A:

Q: A hammer mill is driven by a High Torque (HT) AC motor. The system is used for 8 hours /day. Input…

A: Diameter of the motor shaft pulley = D1 = 1.33 cube root of Power / Speed max D1 = 1.33 cube root 25…

Q: For the four-bar linkages below, indicate whether they are Grashof type 1 or 2 and whether they are…

A:

Q: The number of links is L = The number of full joints is j1 = The number of Half joints is J2 = 1 The…

A:

Power Transmission Elements

It is defined as the energy transfer from one location to another location. The energy will start moving from the energy generation source to the energy applied position to obtain the work output. From this method, a large amount of electric energy moves from the power station to various electrical substations.