8. The following figure shows a tank of water with a circular pipe connected to its bottom. Acircular gate seals the pipe opening to prohibit flow. To drain the tank, a winch is used to pullthe gate open. Compute the amount of force that the winch cable must exert to open the gate.- WinchCable-WaterStop30⁰38 in-HingeCircular gate10.0 in diameterOpen pipe

Calculation of amount of force applied by cable or tension in cable to open gate#####

Answered: . Compute the amount of force that the…

Engineering

Civil Engineering

. Compute the amount of force that the winch cable must exert to open the gate.

Structural Analysis

6th Edition

ISBN:9781337630931

Author:KASSIMALI, Aslam.

Publisher:KASSIMALI, Aslam.

Chapter2: Loads On Structures

Section: Chapter Questions

Problem 1P

See similar textbooks

Related questions

Q: Consider the cable shown in (Figure 1). Suppose that P-3.8 kN. P₂-5.8 kN Figure Ya (101 3m heeded to…

A: The mechanics deals with the application of the forces and reaction forces that are developed in the…

Q: Water acts against the gate which is hinged at point A. Friction in the hinge is negligible.…

A: let,T=tension in the cableW=weight of the gatepressure force p=wAxwhere,x=distance of centre of…

Q: tuation - The walkway ABC of the footbridge is stiffened by adding the cable ADC and the short post…

A: L=5m h=0.9m Diameter of cable=8mm To find weight of person

Q: Determine the tension developed in each cable for equilibrium of the 300-lb crate.

A: The given figure is shown below:

Q: The block with a mass of 500 kg is kept in equilibrium. Calculate the magnitude of the force T…

Q: kN crate is supported by three cables as shown. 2 m 8 m В 4 m C 6 m 10 m A 4 m D 500 kN ine the…

A: To find cable in AD

Q: A 550 mm B 300 mm 300 mm 300 mm 5 kN. 50 kN

Q: the cable reel is in contact with the ground at A and wall B with a weight of 100 kg. If the static…

A: f= friction force on ground A=μW=0.3×1009.81=3.06 ND' alemberd principal for…

Q: Determine the internal force system acting on section 1 of the circular arch

Q: The homogeneous 600-lb plate is suspended from three cables. Determine the tension in each cable.

A: Given:- 600 lb = m Three cables To find:- Ta,Tb,Tc

Q: f the weight of the crate is 2021 Newtons, calculate the tension in Cable A in Newtons Cable B in…

A: To find tension in cable A and B

Q: E-L The crate has a force in each supporting cable. Ib. Determine the B. 340

A: Given that: Weight of crate, W=550 lb

Q: M B. 60 6 Kn

Q: The 500 kN crate is supported by three cables as shown. Determine the tension in cable

A: To find tension in cable BD

Q: ET Find the tensile stress Jab in cable AB

A: Given data :

Q: Compute the maximum loading (kN) in the cable. E 1.5 m C 1 m 4 kN -5 m -4 m -4 m

A: To find maximum loading in cable

Q: Determine the magnitude (N) of the force in cable AB. Determine the magnitude (N) of the force in…

Q: The cable will fail when subjected to a tension of T = 6 kN. Figure 1) gure 0.1'm -0.75 m- ... * 0.5…

A: Reference : Mechanics, Tension in pulley and cable. Given : A Tension T = 6 KN P force acting…

Q: The top of a folding workbench has a mass of 50kg with mass center at G. A) Determine the resultant…

Q: calculate the maximum tension of the cable and state the corresponding cable section. kindly show…

Q: Please answer this NEATLY, COMPLETELY, and CORRECTLY. Determine the length of the cable used when…

Q: Determine the axial force, shear force, and moment at sections passing through a) C and b)…

Q: A roof purlin, supported by a rafter, must support a 500# vertical snow load. PURLIN- RAFTER 14…

A: Consider the figure,

Q: A certain cable is suspended between two supports at the same elevation and 500 ft apart. The load…

Q: Problem 6: Determine the maximum mass of the crate so that the tension developed in any cable does…

Q: Quo: Find the moment at Co) to hold the gate, shown in figure beloues closed. Negleet gate weight.…

A: pressure on the gateP=wAxlet L=length of gatetherefore,Lsinθ=1.2Lsin30=1.2L=2.4marea of the…

Q: Replace the two wrenches and the force, acting on the pipe assembly, by an equivalent resultant…

A: Consider the figure,

Q: Determine the tension in each cable for equilibrium.

A: Cordinates of the points as follows:

Q: 4.5 m 1.8 m 1.8 m 1.35 m Yc 5.4 m E F 37 kg Mass (M) 1. At point C, what is the largest mass(M) that…

Q: It is desired to remove the spike from the timber by applying fo direct access, so that two forces,…

Q: Determine the reaction at A,B,E 50b D E cable 1' 1' 2' 1'

A: first draw the free body diagram for two beams 1 and 2 as shown above now write the equilibrium…

Q: All problem solutions must include an FBD. F3-1. The crate has a weight of 550 lb. Determine the…

A: Given Weight of crate=550lb To find force in each cable

Q: 2. It is desired to remove the spike from the timber by applying force along its horizontal axis. An…

A: Represent the external forces acting on the spike. Here, T is the resultant force due to the…

Q: Question 2 Sketch the cable profiles required to balance the loads shown below (a) (b) (d) ↑ ↓ ↑ ↑ ↑

A: Four different cases and loading pattern has been given in the above figures. We have to draw the…

Q: Calculate the smallest area of each cable if the stress is not to exceed 90 MPa in bronze and 120…

Q: Q2:Find the horizontal and vertical forces on the curved gate, ABC. R-6 m Water 6 m B 6 m A

A: Given: height = 6 m radius = 6 m

Q: E 30° C 42° 4 3

Q: Determine the maximum mass of the crate so that the tension developed in any cable does not exceeded…

A: The free body diagram of the ring at A is as follows:

Q: Determine the tension in the cable for the tied three-hinged arch subjected to the loading as shown…

Q: Hi there. I have attached a photo of the problem I want to solve. I am familiar with solving similar…

A: The given figure is shown below:

Q: Determine the magnitude and direction of the force exerted on the plate by the ridge illustrate and…

A: The values and diagram given in the question are as follows

Q: 450 mm 360 nim B 320 mm 500 mm 600 mm A 1165 N

A: Given:-

Q: tank of water sits on a cart and discharges from a 10 mm diameter nozzle. Find the tension in the…

Q: Compute the maximum loading (kN) in the cable.

Q: problem solutions must include an FBD. -1. The crate has a weight of 550 lb. Determine the ce in…

A: Weight of crate=550lb

Question

8. The following figure shows a tank of water with a circular pipe connected to its bottom. A
circular gate seals the pipe opening to prohibit flow. To drain the tank, a winch is used to pull
the gate open. Compute the amount of force that the winch cable must exert to open the gate.
- Winch
Cable-
Water
Stop
30⁰
38 in
-Hinge
Circular gate
10.0 in diameter
Open pipe

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Step 3

VIEW

Step by step

Solved in 3 steps with 2 images

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, civil-engineering and related others by exploring similar questions and additional content below.

Similar questions

The 200-lb uniform container is suspended bymeans of a 6-ft-long cable, which is attached to the sides ofthe tank and passes over the small pulley located at O. If thecable can be attached at either points A and B, or C and D,determine which attachment produces the least amount oftension in the cable. What is this tension?
Ql:- What is the minimum force on the circular gate that put the fate in same position? If the maximum force on hinge was 100KN. What the allowable height of water? 2m 2m
A cable weighing 0.4 pound per foot and 800 feet long is to be suspended with sag of 80 feet. Determine the maximum tension of the cable. A) 403 kg B) 416 kg C) 456 kg D) 425 kg
If the resultant of the loads shown passes through point B, determine the equivalent force-couple system at O. 9.1 kips 12.5 kips 2.8' 2.8' 4.1 kips x Part 1 If the resultant passes through B, the original system must be equivalent to the new system shown (a single force passing through point B with no accompanying couple). R₂ 6.9' A 2.8' R₂ B Solve for the forces Rx and Ry so that the forces in the original system are equal to the forces in this new system. Answers: Rx kips Ry= kips i 4.1
Determine the axial force, shear force, and moment at sections passing through a) C and b) immediately to the left of roller E, and c) immediately to the right of roller E. 4 kN -Hinge (pin connection) 5 kN-m A E - 4 m to 5 m 5 m 2 m '1 m'
Catenary Cable (different level of support)
An 85-mm thick precast concrete slab is lifted by 4-16 mmo cables as shown. Unit weight of concrete is 23.5 kN/m. Determine the tensile force in each cable. -16mm 2m
It is desired to remove the spike from the timber by applying force along its horizontal axis. An obstruction A prevents direct access, so that two forces, one 480 lb and the other P, are applied by cables as shown. Compute the magnitude of P necessary to ensure a resultant T directed along the spike. Also find T.
The concrete wall panel is hoisted into position usingthe two cables AB and AC of equal length. Establishappropriate dimensions and use an equilibrium analysis toshow that the longer the cables the less the force in each cable.
The cable exerts a force of P-6 kN at the end of the 8-m-long crane boom (Figure 1) Figure 1of1 Part A If-30, determine the placement ar of the boom at B so that this force creates a maximum moment about point O Express your answer to three significant figures and include the appropriate units Submit Part B Value (Mo) Request Answer What is this moment? Express your answer to three significant figures and include the appropriate units. Enter positive value of the moment is counterclockwise and negative value if the moment is clockwise. Value Submit Request Answ Units Pearson ? → Ć Units
It is decided to remove the spike from the timber by applying force along its horizontal axis.An obstruction A prevents direct access ,so that two force one 1.6kN and other p are applied by cables as shown.compute the magnitude of p necessary to ensure a resultant T directed along the spike?
A uniform steel ring 76 in. in diameter and weighing 680 lb is lifted by the three cables, each 58 in. long, attached at points A, B, and C as shown. Compute the tension in each cable.