. A resistance of R2 is connected in series with a parallel circuit comprising two resistances of 100 and 12 respectively. The total power dissipated in the circuit is 80 Watts, when applied voltage is 20 V. Calculate the value of R.

. A resistance of R2 is connected in series with a parallel circuit comprising two resistances of 100 and 12 respectively. The total power dissipated in the circuit is 80 Watts, when applied voltage is 20 V. Calculate the value of R.

College Physics

11th Edition

ISBN:9781305952300

Author:Raymond A. Serway, Chris Vuille

Publisher:Raymond A. Serway, Chris Vuille

Chapter1: Units, Trigonometry. And Vectors

Section: Chapter Questions

Problem 1CQ: Estimate the order of magnitude of the length, in meters, of each of the following; (a) a mouse, (b)...

See similar textbooks

Related questions

Q: 1) A circuit containing a linear resistor is powered by a 25 Vbattery and has a current of 5…

A: a) Write the equation of Ohm's law and substitute the corresponding values to calculate the…

Q: 17.6 kΩ resistor and a capacitor are connected in series and then a 12.0 V potential difference is…

Q: During an experiment to verify Ohm's law, the voltage supplied and the current through a circuit are…

Q: In an automobile, the system voltage varies from about12 V when the car is off to about 13.8 V when…

A: The power delivered to load be defined as, P=V2R

Q: Consider the circuit shown in the figure. A short time after closing the switch, the charge on the…

A: Let initial charge be Q and charge on the capacitor after t seconds is q.q = 80% of QTime constant,…

Q: Consider an initially uncharged capacitor in an RC circuit. The resistance is 22,489 Ohms and the…

Q: A 50 μF capacitor that had been charged to 30 V is discharged through a resistor. Figure shows the…

A: The voltage of a discharging of a capacitor at any time t is given by the formula V=V0e-tRCV0 is…

Q: A capacitor with capacitance 10.8 μF in an RC circuit is initially charged up to a voltage of Vo =…

Q: Two electric bulbs rated at 25 W, 220 V and 100 W, 220 V are connected in series across a 220 V…

Q: A certain solar cell type has an output capability of 7.6 A at 0.4 V. A series / parallel solar…

A: Voltage of each cell = 0.4 V Number of cells in series= 242

Q: For a limited time interval, the voltage across a 1.35 microfarads (or, equivalently, 1.35 x 10-6…

A: C = 1.35 x 10-6 F v(t) = 4.05 + 26.3 t + 29.1 t2 v'(t) is the derivative of v(t) w.r.t. t…

Q: How long does it take the charge to reach 63% of its final value if a 10 microfarad capacitor is…

Q: Consider an initially uncharged capacitor in an RC circuit. The resistance is 20,232 Ohms and the…

A: Given: The resistance of the circuit is 20,232 Ω. The capacitance of the circuit is 511×10-6 F. If…

Q: A capacitor with capacitance C = 2.5 µF is charged to a voltage V = 5V. It is then discharged…

A: The capacitance of the capacitor is 2.5 μF. The resistance of the resistor is 100 Ω. The charged…

Q: A 200-volt electromotive force is applied to an RC-series circuit in which the resistance is 1000…

A: Given data: V=200 Volt R=1000 ohm C=5×10-6F To find: (a) charge q(t) on the capacitor if i(0)=0.2…

Q: Consider the RC circuit shown in the figure below. If the resistance of the circuit is R=7kO and the…

A: Answer: 74.4 ms

Q: How many kW of energy does a 650-W toaster use in the morning if it is in operation for a total of…

Q: An external resistor of 12 Q is connected to a real battery, as shown the figure. The thermal energy…

A: The internal resistance is defined as the resistance offered by the battery or cell itself, towards…

Q: The time needed for fully charging of the capacitor is 50ms for an RC charging circuit. If the…

A: Time , T = 50 ms = 50 x 10-3 s Capacitance , C = 17 x 10-6 F To find = resistance

Q: the time constant of the RC circuit. e capacitor is being charged, what is the potential difference…

A: We know that the value of the time constant is given as τ= RC…

Q: All of the electrical outlets in a room are connected in a single parallel circuit. The circuit is…

A: To determine,partathe maximum total power(P) that can be supplied by the outlets without blowing the…

Q: A capacitor is being charged with 9.6 V of the voltage supply in a RC circuit shown below. At t = 0…

A: According to the Bartleby guidelines, only three questions can be solved. Given data The potential…

Q: An RC has a resistor with a resistance of 12 ohms and a capacitor with a capacitance of 1.4 F. The…

A: Resistance, R = 12 Ω Capacitance, C = 1.4 F Max charge, Qmax = 11 C Charge at time t, q(t) = 0.6875…

Q: In the figure a, calculate the potential difference between a and c by considering a path that…

A: As per our policies, I can answer only first question. The detailed solution of first one is given…

Q: A combination of three resistors R₁, R2, and R3 in series is connected across a voltage source V7.…

Q: A thick insulating spherical shell of inner radius a=2.1R and outer radius b=9.9R has a uniform…

A: Given data The inner radius of the spherical shell is given as a = 2.1 R. The outer radius of the…

Q: The current in a single-loop circuit with one resistance R is 6.6 A. When an additional resistance…

A: Recall V=iR Ohm's law for single loop circuit.

Q: A 20 m-ohm ammeter is used to measure the current through a 10 ohm resistor with which it is in…

Q: Consider the RC circuit shown in the figure below. The resistance of the circuit is R 4.3k2 and the…

A: We will first write an expression for current in the circuit while capacitor charges. Then we…

Q: Consider the RC circuit shown in the figure below. If the resistance of the circuit is R=6kQ and the…

A: When pure resistance R in ohm and capacitor C in Farads combine to form a circuit it is called as RC…

Q: What is the value of the unknown R if the voltage across the 500 resistances is 4.00 V?

A: This circuit can be analysed by using ohm's law, kirchoff's voltage and current law. Ohm's law -…

Q: In a RC circuit with power supply with an emf of 10 V, capacitance 5 µF, and resistance 10000, the…

Q: A 0.7-F capacitor is connected in series with a 9-ohm resistor. If the connection is energized from…

A: Given: C=0.7 Farad R=9 Ohm V=11 Volts t=2.75 ms To find: Voltage across the resistor at time t=2.75…

Q: A capacitor of capacitance C = 1 µF is connected in series to a resistor of resistance R = 10 MN and…

A: Given: capacitance of capacitor, C = 1 μF = 10-6 F Resistance of resistor, R = 10 MΩ = 10 × 106 Ω…

Q: An RC (resistor + capacitor) circuit will have an exponential voltage response of the form v(t) = A…

A: Equation of voltage Resistance Capacitance From the data

Q: A circuit with three resistors is connected in series and in parallel, with a supply DC voltage. The…

Q: An RC circuit takes t = 1.58 s to charge to 45% when a voltage of ΔV = 5.5 V is applied. If the…

Q: All of the electrical outlets in a room are connected in a single parallel circuit. The circuit is…

A: (a) According to the question the rating of the fuse is 20 A .That simply means the maximum current…

Q: In the circuit shown in the figure, the input voltage V, is 20 V, VBE = 0 and VCE = 0. The values of…

Q: the voltage across a component is given by v = V0e-t/CR. Determine the time taken for voltage v to…

A: SOLUTION AS

Q: You create a plot of voltage (in V) vs. time (in s) for an RC circuit as the capacitor is charging,…

A: We have the given value of A, B, C A=4.211±0.4211 B=0.1699±0.007211 C=1.901±0.2051 Given Capacitor…

Q: In the circuit diagram R1 = 5R and R2 = 15R, where R = 14 Ω. The power dissipated in resistor 2 is P…

A: Given Resistance of the resistors are given as R1=5R and R2=15 R, where R=14 Ω Power dissipated in…

Question

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Step by step

Solved in 2 steps with 2 images

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, physics and related others by exploring similar questions and additional content below.

Similar questions

In an experiment, an initially uncharged capacitor of capacitance C=62µF (microFarad) is connected to a resistor R and a battery of voltage V as shown in the figure below: V(V) VT After the switch is closed at t=0, the voltage across the capacitor is measured and plotted as shown in the figure below. Using the data provided in the curve, determine the value of resistance R. Express your answer in units of using zero decimal places. 13- 12- 11 10- 9 8- 7- 6 5 4- 3 2 1- 0- 0 P 0.1 66****** 0.2 0.3 R www 0.4 0.5 C 0.6 t (s) 0.7 0.8 0.9 1 1.1 1.2 4
A 0.7-F capacitor is connected in series with a 9-ohm resistor. If the connection is energized from an 11-V DC source, determine the voltage (in volts) across the resistor at t = 2.75 ms. The initial charge is 175 mC. Express your answers accurately to four decimal places.
An RC circuit with components C = 4mF (mili-Farads), R1 = 2kN (kilo-Ohms) and R2 = 3kN is set as shown in the figure. The capacitor is initially charged to 16V. At t =0 the switch is thrown to position 1, at t = 4s the switch is turned to position 2. Which of the following expressions correctly gives the charge on the capacitor at t = 10s? О а. Q%3D (64птC)(1 — е 1/2)е 1/3 ОБ. Q3 (24C) (1 — е 3/2)е 1/3 Ос. Q%3 (32тC)e 1/2 R2 O d. Q= (64mC)e¬1 O e. Q = (32mC)e 6/5 R1 O f. Q3 (16тС)(1 — е 1/3)е 1/2 Оg. Q%3D (24mC)(1 — е 5/6) O h. Q = (16mC)e¬1/3
R +1₁H sa In the circuit shown, the resistor has a value of 821 kohms and the capacitor has a value of 49.9 microfarads and the supply voltage is 24.0 volts. Given these values for this circuit, how long will it take for the capacitor to charge up to a voltage of 10.0 volts?
Consider the circuit shown that has two resistors (each with resistance R = 8.00 Q), a battery with negligible internal resistance (V= 12.0 V), and a lightbulb. If the resistance of the lightbulb is 3.50 Q, calculate the power output of the lightbulb (ie. the rate at which energy is dissipated in the lightbulb). R R 12 W 2.2 W 6.8 W 4.0 W
Consider an initially uncharged capacitor in an RC circuit. The resistance is 25,957 Ohms and the capacitance is 555 x 10^-6 F. If the source potential being used to charge the capacitor is 14.8 V, how long after charging begins will the energy stored by the capacitor be 65.5% of its maximum value.
A discharging RC circuit has its charge reduced from 20C to 10C in 22 seconds. If the resistance of the circuit is 11 Ohms then what is the capacitance?
Consider an initially uncharged capacitor in an RC circuit. The resistance is 20,000 Ohms and the capacitance is 500 x10• F. If the source potential being used to charge the capacitor is 15 V, how long after charging begins will the power delivered to the resistor be 25 % of its maximum value?
You are given the job of evaluating potential power line systems. One system is designed to operate at V = 3000 V, and another would operate at V = 6500 V. Suppose the power line at the higher voltage would dissipate 3 % of the power that it carries. What percentage of the power would be dissipated in the low-voltage power line?
Consider the RC circuit shown in the figure below. If the resistance of the circuit is R=4kN and the capacitance of the initially uncharged capacitor is C=11µF. If emf of the battery the circuit is connected to is E=17V and the switch is closed at t=0, determine how long it would take for the capacitor to reach 86% of its maximum charge. Express your answer in units of ms (milliseconds) using one decimal place. + S