. 6. A quarter piece of a transmission line is connected to a capacitive load from one port. At the other port of the transmission line, the input impedance becomes None of them capacitive resistive inductive conductive d when the

. 6. A quarter piece of a transmission line is connected to a capacitive load from one port. At the other port of the transmission line, the input impedance becomes None of them capacitive resistive inductive conductive d when the

Power System Analysis and Design (MindTap Course List)

6th Edition

ISBN:9781305632134

Author:J. Duncan Glover, Thomas Overbye, Mulukutla S. Sarma

Publisher:J. Duncan Glover, Thomas Overbye, Mulukutla S. Sarma

Chapter4: Transmission Line Parameters

Section: Chapter Questions

Problem 4.32MCQ

See similar textbooks

Related questions

Q: A. For the following figure, the diameter of each conductor is 2.5 cm. Find the inductance and…

Q: The line with symmetrical spacing then the equilateral spacing (Deq) for the three-phase…

A: The line with symmetrical spacing then the equilateral spacing (Deq) for the three-phase inductance…

Q: c) For a transmission line w/characteristic impedance Z0 = 50 W. At some point of the line, a…

A: To solve the given problems, we'll use transmission line theory and the equations that govern wave…

Q: Q) A source of 10 V and frequency 1000 KHz with internal resistance of 10 2 is connected to the…

Q: i(t) 42 v(1) 0.9H For the accompany circuit, if the source voltage v(t) = V 2 95 cos(12t) volts what…

A: Given, Source voltage, vt=2×95cos12t volts

Q: For the circuit shown in the figure, determine the reflected impedance on the source side.

A: A coupled circuit is given with multiple couplings. We need to determined the reflected impedance on…

Q: Derive the expression for total inductance of a transmission line.

A: Inductance of a transmission line is calculated as Inductance=Flux linkagesCurrent passing through…

Q: A 502 transmission line is terminated with a 502 resistor on series with a 2 * 10 7H inductor. If…

Q: If the normalized admittance visible at a distance d from the load impedance is 1 - j5, how many mho…

Q: negligible only if the length of the Transmission Line does not exceed how many kilometers? A. 240…

A: In this question, we will write shunt capacitance effect...

Q: 8. A transmission line has a characteristic impedance of 500 and a resistanc of 0.1 02/m. If the…

A: In this question we will find attenuation constant for distortionless transmission line....

Q: - The distance from the load to the first minimum voltage in a 50 N line is 0.12A, and the standing…

Q: A single-phase transmission line consisting of two conductors, the radius of each conductor is 0.4…

A: 1..>>Capacitance of line without effect of ground Radius of conductor is 0.4cm Distance…

Q: be -j12.8 Ω HE 13.6 Ω ΣΕΩ 2j12 Ω - Ω ΔΩ {5Ω 3:10 Ω

Q: 4/ Which parameter is neglected or ignored in Short Transmission Lines? A. SHUNT CAPACITANCE ONLY…

Q: Which of the following parameter/s is represented as connected in shunt in the equivalent circuit…

A: Any transmission line is represented by four components namely Resistance, inductance capacitance…

Q: ). A transmission line has a characteristic impedance of 502 and a resistance of 0.1 Q/m. If the…

Q: Q6: Calculate Zin at the load using smith chart for total transmission lines, while the wavelength…

Q: 5A rms /60Hz L1 100mH L2 www. 150mH C1 = 2.2μF 2 + 10V rms 60Hz + R1 V 1kQ 1

Q: What is the capacitance per kilometer per phase of a single circuit, two bundle conductor line with…

A: What is the capacitance per kilometer per phase of a single circuit.

Q: Determine the B, value from this polarization curve. -300 -350 -400 -450 -500 -550 -600 -650 -700…

A: A A polarization curve is given in the question. We need to determine the value of βa.

Q: A single-phase transmission line consisting of two conductors, the radius of each conductor is 0.4…

Q: 500 transmission line is terminated with a 500 resistor on series with a 2 * 10 H inductor. If the…

Q: 0.35λ long with characteristic impedance Z0= 50 ohms transmission line is combined with ZL=10+j25…

A: Smith chart:It is a graphical tool used in RF (Radio Frequency) for analyzing and designing…

Q: Each phase of a transmission line is a bundle of 4 conductors that form a square with all sides…

A: Given a transmission line with bundle of four conductors in the form of square with all sides equal…

Q: b) A 602 characteristic impedance transmission line is fed by a DC source of 100V with an internal…

Q: A 219-2 lossless air transmission line is connected to a complex load composed of a 579-Nresistor in…

Q: Q4) A- For the following SWR Pattern, find the reflection coefficient of the load and Ag. mw 8.6 43…

A: Solution 4- (A) From the given figure,Vmax=8.6Vmin=4.3Now, the voltage standing wave ratio is given…

Q: A transmission line of characteristic impedance of Zo=50 ohm with length of A/4 loaded by a load…

A: Given: A transmission line is having Characteristic equation, Z0=50 Ω Length, L=λ4 Load impedance,…

Q: For a T.L. of Zo=50 Ohm, terminated with ZL= 100 Ohm, the value of the VSWR is: O 5 O 2 O 3

A: The solution can be achieved as follows.

Question

6. A quarter piece of a transmission line is connected to a capacitive load from
one port. At the other port of the transmission line, the input impedance
becomes
None of them
capacitive
resistive
inductive
O conductive
7. The transmission line is matched when the

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Step by step

Solved in 2 steps with 1 images

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, electrical-engineering and related others by exploring similar questions and additional content below.

Similar questions

In the Transmission Line Simulator, the Transmission Line is composed of which parameter/s? O A. The Shunt Conductance Only O B. The Series Impedance and Shunt Capacitance O C. The Shunt Capacitance Only O D. The Series Impedance Only
27/ A filter converts _______________________________. a. pulsating AC to pure DC b. pulsating DC to pure DC c. DC to AC d. AC to DC
b) If quantity A is PATAT with TC of 2mV/C, and quantity B is CTAT with TC of -1mVrC, then determine the following quantities if they are PTAT or CTAT 1. 1/A 2. 1/B 3. A+ 5°B
, For the trapezoidal pattern shown below, determine a. Modulation coefficient. b. Percent modulation. c. Carrier amplitude. d. Upper and lower side frequency amplitudes. 28 V 12 V -12 V -28 V
Needs Complete typed solution with 100 % accuracy.
An inductor is attached to an AC voltage source. Which change will result in a halving of the current?A. Halving the voltage and doubling the frequencyB. Doubling the frequencyC. Halving the frequencyD. Doubling the voltage and halving the frequency
All of the following statements about the TRIAC could be true except: O A. TRIACs are not used in automotive applications O B. None of the other choices are correct OC. TRIACS are not suitable for high frequency (over 100k) switching applications O D. TRIACS are largely used for power application at the line frequency O E. TRIACS cannot be used in household appliances
A single-phase transmission line consisting of two conductors, the radius of each conductor is 0.4 cm, the distance between the conductors is three and half meters and the height above ground is eight 1-The capacitance in uF/km without effect of ground is 2-The capacitance in pF/km with effect of ground is
0.5: a) Correct any five of the following sentences using suitable scientific phrases. 1. In series resonance maximum voltage is obtained in the circuit 2. The sign of the induced voltage can't be determined by the direction of current in the 3. In star connected three phase system then the line current isn't equal the phase current 4. The locus of capacitive load is a vector in the 2nd quadrant. 5. The Y-parameters is called the voltage equation. 6. Impedance matching occurs when Z₁-Z 7. The capacitive reactance (Xc) cannot be affected by the harmonics of non-sinusoidal w
How can such circles be drawn with any program? Explain how to draw them through a specific website or program
Please solve the problem
4/ Which parameter is neglected or ignored in Short Transmission Lines? A. SHUNT CAPACITANCE ONLY B. SERIES CONDUCTANCE AND SHUNT CAPACITANCE C. SHUNT CONDUCTANCE AND SHUNT CAPACITANCE D. SHUNT CONDUCTANCE ONLY