BPR130_CH11_Test

I need answers to questions 4, 5, and 6 pertaining to the print provided.

I need answers to questions 13, 14, amd 15 pertaining to the print provided.

I need answers for problems 10, 11, and 12 pertaining to the print.

OR Perform FMEA and Root Cause Analysis for any TWO problems faced in your industry. MA

Question 4   What is relation between product tolerance (engineering tolerance) and process variation.? Explain in some details showing some representation. Analyze the following study in terms: Components of variations and their contributions X Chart and R Chart 3. Calculate the process capability (show your method). Is it acceptable? Comment on this result.

I need parts 4, 5, and 6 answered pertaining to the print provided.

I need these 3 parts answered for a review activity.

Drilling and Completion Engineering II An exploration well is to be drilled to a total depth of 19000 ft, relevant data are as follows: Safety factors for collapse and burst are 0.9 and 1.05 respectively. Design suitable casing strings for the given hole sizes, taking into consideration the available casing grades and the maximum expected pressures. The answer by hand written in a clear way

The foreman in the welding department wanted to know what value of allowance to use for a particular section of the shop. A work sampling study was authorized. Only two activity categories were considered: (1) welding and other productive work, (2) personal time, rest breaks and delays. Over a four-week period, where there are 40 hours per week, 161 observations are made at random times. Each observation captured the category of activity of each of 12 welders in the shop section of interest. Results indicated that category 2 constituted 17 % of the total observations. (a) Can you conclude that realized PFD is 17 % in the factory at 100*(1-0.02) % confidence level with 7% precision? (b) If a total of 88 work units were produced during the 4 weeks, and all category 1 activity was devoted to producing these units, what was the average time spent on each unit?

I need answers to questions 10, 11, and 12 pertaining to the print provided. Note: A tutor keeps putting 1 question into 3 parts and wasted so many of my questions. Never had a issue before until now, please allow a different tutor to answer because I was told I am allowed 3 of these questions.

Q-1A) Identify if TRUE or FALSE, give an explanation for the FALSE ones only). a. If a homogenous piece of rock is cut into two pieces, then each one will have the same formation factor. h Micro-resistivity log can be used in oil-based mud and water-based mud systems. L. In a water bearing formation, Ro is equal to the Rt. d. A high GR value always indicates the presence of shale. e One of the most important application of the SP log is to measure the formation permeability. L Caliper log shows a smaller reading that the bit size for evaporite (Salt) layers. g. If the micro-Inverse and micro-Normal logs exhibit positive separation, the permeability of the formation is small. b. A reverse/positive SP deflection occurs when Rmf< Rw. i Water Saturation is defined by the ratio of water volume to the bulk volume of a rock. i The higher formation porosity, the larger invasion diameter. k. Induction log measures the formation resistivity. L Well-logging measurements are recorded while puling…