lab 4-3

Peak input voltage =(from graph) ?Peak output voltage =  (from graph)?DC voltage across RL = ?ripple factor=?

hand written asap plzzzzz..i'll upvote

how to measure ripple factor and peak input and peak output voltage for this circuits ?

electrnic circuits find vo1 and Vout

Hello. I would appreciate some help with this problem. Thank you

Answer The following problem. Base on the given Table. Show complete solutions. View Image

Answer The following problem. Base on the given Table. Show complete solutions. View Image

I need the answer as soon as possible

O b. None of them C. Req=36.67 Q,P=-3.92W. O d. Req=61.5 Q,P=-2.34W. e. Req=36 0,P=-4W. estion 4 For this circuit, the values of 11, 12 and V are: yet swered 11 12 arked out of R1 R2 R3 R4 Is 15 A V 50 10 Q 10 Q Flag uestion Select one: O a. 11= 10J12 = 5 A, V=50 V O b. 11 = 5 A, 12 = 2.5 A, V=25 V O c. 11 = 5 A, 12 = 2.5, V=50 V O d. 11 = 2.5 A, 12 = 5 A, V=25 V Question 5 Find Rab- Not yet arswered 20 Q AAAA Marked our of TOSHIBA

Given the range find the per scale value for each range based on the encircled basis (follow the line of the black encircled basis) Range: Per scale val.: 0.1 0.5 2.5 10 50 250 1000

How did they get these equation explain simply?

Thank Y ou

in V1 R2 100k SINE(0 10 100) R1 100k D1 D V2 0 out D D2 V3 0 DC offset[V]: 0 Amplitude[V]: 10 Freq[Hz]: 100 T delay[s]: Theta[1/s]: Phi[deg]: Ncycles: anter 2019-2220 Figure 3-5 Clipper Circuit for LTSPICE Simulation C4. To specify the type of simulation, select "Simulate>>Edit Simulation Cmd" from the menu. Choose "Transient" and enter 30m for Stop time, 0 for Time to start saving data, and 1m for Maximum Timestep. Click OK. C5. Click Run to start the analysis. C6. Place two voltage probes (voltage probes appear when placed on a wire during simulation), one at the input side (at the top of V1) and another at the output side (at the top of D2) of the circuit. What difference do you observe between the input and the output waveforms?