Chapter 8, Problem 8.103EP

A compressor receives R-410A as saturated vapor R-410A at 400 kPa and brings it to 2000 kPa, 60°C. Then a cooler brings it to saturated liquid at 2000 kPa (see Fig. below). Find the specific compressor work and the specific heat transfer in the cooler? A eccoi = Compressor Compressor section Cooler section

One kg of steam expands isentropically from 2.1 MPa and 374°C to 93°C. Find the final quality and the work for non-flow and steady flow processes.

Please be very detailed

The 1 lb of air has decrease of internal energy of 20.58 Btu while its Fahrenheit temperature is reduced to 1/3 of the initial temperature during a reversible nonflow constant pressure process. Find 1).the initial and final temperatures, 2). heat 3).work

In an engine, the air in a piston-cylinder arrangement has a compression ratio of 0.1. It starts from 100kPa and 20degC. Find the temperature at state 2. You can assume an adiabatic process and the ideal gas law applies.

One way to determine the quality of saturated steam is to throttle the steam to a low enough pressure that it exists as a superheated vapor. Saturated steam at 500 kPa is throttled to 0.1 MPa, 100 oC. Determine the quality of the steam at 400 kPa side. (Starts the calculation from mass and energy conservation)

Question 3: Superheated steam enters a turbine at 7 MPa, 550°C, and exits at 150kPa a. Draw the system. b. If the process is reversible adiabatic (isentropic), find the final temperature (T2), the final enthalpy (h2,) of the steam, and do the energy balance to calculate the turbine work (Wts). c. Using entropy balance, show that Sgen for the above process is 0. d. If the isentropic efficiency is 85%, find the actual final temperature (T23) and calculate Sgen? e. Plot process in (b) and (d) on a Ts diagram with proper labelling.

A condenser (heat exchanger) brings 1 kg/s water flow at 10 kPa quality 95% to saturated liquid at 10 kPa. The cooling is done by lake water at 20 degree Celsius that returns to the lake at 30 degree Celsius. For an insulated condenser, find the flow rate of cooling water.

Number 4